2021 CHEVROLET COLORADO display

3
OFF-ROAD MODE
Off-Road Mode changes the antilock brake, traction control, and stabilit\
y control
calibrations for different conditions. It also alters throttle progressi\
on and transmis-sion shifts.
In Off-Road Mode:
• The locking rear axle does not have a speed limitation. The rear axle wi\
ll remain locked up to the maximum vehicle speed.
• The StabiliTrak electronic stability control system is adjusted for off-\
road performance.
• Powertrain calibrations are optimized for off-road use.
OFF-ROAD MODE CONTROL
Press the Off-Road Mode control
button on the center of the transfer case knob to turn Off-Road Mode on or off.
The Off-Road Mode symbol on the instru-ment cluster will illuminate when Off-Road Mode is active.
Note: Off-Road Mode is calibrated for off-road driving conditions. It should not be used when driving on pavement.
SHIFTING INTO OR OUT OF 4-WHEEL DRIVE
To shift into or out of 4-wheel drive, rotate the knob to the desired po\
sition (2 HI, AUTO, 4 HI, 4 LO, or Neutral). Line up the indicator mark on the knob w\
ith the indicator light to command the shift.
The indicator light flashes while the shift is in progress and remains\
illuminated when the shift is complete. If the shift cannot be completed, the transfer ca\
se returns to the last chosen setting. The current 4-wheel drive status is displayed o\
n the Driver Information Center.
See Driving and Operating in your Owner’s Manual.
Mode SummaryStandardOff-Road
2 HI/4 HI4 LO2 HI/4 HI4 LO
Throttle ProgressionNormalLow RangePerformanceLow Range
Transmission Shift ModeNormalLow RangePerformanceLow Range
Locking Rear AxleUp to 25 mphUp to 25 mphUnlimitedUnlimited
Locking Front AxleNot AvailableUp to 25 mphNot AvailableUp to 25 mph
Antilock BrakesNormalNormalOff-RoadOff-Road
Traction ControlNormalDriveline OnlyOffDriveline Only
StabiliTrakNormalOffSportOff

5
HILL DESCENT CONTROL
TRACTION CONTROL AND STABILITRAK SYSTEMS
Hill Descent Control sets and maintains vehicle speed when descending a very steep hill. It can maintain vehicle speeds from 3–19 mph on an incline greater than or equal to a 10% grade (or an incline of 6 degrees).
Press the Hill Descent Control switch on the center of the instru-ment panel. Vehicle speed must be below 37 mph to enable the system. The symbol will illuminate on the instrument cluster.
Increase or decrease speed by applying the accelerator or pressing the C\
ruise Control +/– buttons. The adjusted speed becomes the new set speed.
The symbol flashes when the system is actively applying the brakes to main\
tain vehicle speed.
Hill Descent Control will remain enabled between 19 and 37 mph, but vehi\
cle speed
cannot be set or maintained in this range. It will automatically disable\
if the vehicle speed is above 50 mph or above 37 mph for 30 seconds.
See Driving and Operating in your Owner’s Manual.
The traction control system limits
wheelspin and the StabiliTrak elec-tronic stability control system assists with directional control of the vehicle in difficult driving conditions. Both
systems turn on automatically when the vehicle is started.
To turn off traction control, press the Traction Control/StabiliTrak Off switch. The Traction Control Off symbol and StabiliTrak Off symbol on the instrument cluster will illuminate. Press the switch again\
to turn on traction control.
To turn off traction control and StabiliTrak, press and hold the switch until the StabiliTrak Off message is displayed on the Driver Information Center. T\
he Traction Control Off symbol and StabiliTrak Off symbol on the instrument cluster will illumi-nate. Press the switch to turn on both systems.
Note: StabiliTrak will turn on automatically if the vehicle exceeds 35 mph unless Off-Road Mode is enabled and active.
See Driving and Operating in your Owner’s Manual.

6
OFF-ROAD INFORMATION
The Driver Information Center on the
instrument cluster displays a variety of vehicle operating information.
Use the controls on the right side of the steering wheel to move between the display zones and menus.
OFF-ROAD PAGE
The Off-Road Page under the Info menu shows the traction, 4WD, and steering angle states. It also displays a lock icon when the front or rear axle is locked.
INFO PAGES
The Off-Road Page and other pages can be selected/deselected in the Options menu.
1. Select the Options menu. Press to enter the menu.
2. Scroll to view Info Pages. Press the button.
3. Scroll through the list of Info Page Options and highlight the desired item. Press to select the item to be displayed.
4. Go to the Info menu to view the selected items.
See Instruments and Controls in your Owner’s Manual.