Page 256 of 268
Declaration of
Conformity
Radio equipment TFT instrument cluster
For all Countries without EU
Model name: ICC10in
Technical information
The ICC10in can operate in one of two operating modes: 1. Normal mode, with Bluetooth and WLAN on, and 2. Radio off mode (only available during vehicle manufacturing). BT operating frq. Range: 2402 – 2480 MHz BT version: 4.2 (no BTLE) BT output power:
< +4 dBm (internal antenna) WLAN operating frq. Range: 2402 – 2472 MHz WLAN standards: IEEE 802.11 b/g/n WLAN output power: < +14 dBm (internal antenna)
Manufacturer and Address Manufacturer: Robert Bosch GmbH Address: Robert-Bosch-Platz 1,
70839 Gerlingen, Germany
Turkey
Robert Bosch GmbH, ICC10in tipi telsiz sisteminin 2014/53/EU nolu yönetmeliğe uygun olduğunu beyan eder. AB Uygunluk Beyanı'nın tam metni, aşağıdaki internet adresinden görülebilir: http://cert.bosch- carmultimedia.net
Brazil
Este equipamento não tem direito proteção contra interferência prejudicial e não pode causar interferência em sistemas devidamente autorizados. Para maiores informações, consulte o site da ANATEL www.anatel.gov.br Thailand เครื่องโทรคมนาคมและอุปกรณ ีน
มีความสอดคลองตามขอกําหนดขอ ง
กทช. (This telecommunication equipments is in compliance with NTC requirements)
Argentina
C-25636
Page 257 of 268
Canada
This device contains licence- exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Radiofrequency radiation exposure Information: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Informations sur l'exposition aux radiofréquences: Cet équipement est conforme aux limites d'exposition aux radiations fixées par le Canada pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 centimètres entre le radiateur et votre corps. Cet émetteur ne doit pas être co- localisée ou opérant en conjonction avec autre antenne ou émetteur.
Page 258 of 268
United States (USA)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved by Robert Bosch GmbH may void the FCC authorization to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver.
- Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Radiofrequency radiation exposure Information: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co- located or operating in conjunction with any other antenna or transmitter.