2021 Alfa Romeo MiTo technical data

WARNINGS AND PRECAUTIONS
While reading this Owner Handbook you will find a series ofWARNINGSto prevent procedures that could damage your vehicle.
There are alsoPRECAUTIONSthat must be carefully followed to prevent incorrect use of the components of the vehicle, which could
cause accidents or injuries.
Therefore allWARNINGSandPRECAUTIONSmust always be carefully followed.
WARNINGSandPRECAUTIONSare recalled in the text with the following symbols:
personal safety;
vehicle safety;
environmental protection.
NOTE These symbols, when necessary, are indicated besides the title or at the end of the line and are followed by a number. That
number recalls the corresponding warning at the end of the relevant section.
IMPORTANT
This Owner Handbook describes all Alfa Mito versions. Options, equipment dedicated to specific markets or versions are not
explicitly indicated in the text: as a consequence, you should only consider the information which is related to the trim level,
engine and version that you have purchased. Any content introduced throughout the production of the model, outside the
specific request of options at the time of purchase, will be identified with the wording(where provided).
All data contained in this publication are intended to help you use your vehicle in the best possible way. FCA Italy S.p.A. aims at
a constant improvement of the vehicles produced. For this reason it reserves the right to make changes to the model described
for technical and/or commercial reasons.
For further information, contact an Alfa Romeo Dealership.
VEHICLE CHANGES / ALTERATIONS
IMPORTANT Any change or alteration of the vehicle might seriously affect its safety and road holding, thus causing accidents, in
which the occupants could even be fatally injured.

the kit from the specific compartment;
remove the adhesive label of speed 3
(see previous paragraph) and apply it in a
visible position. Wear the protective
gloves provided;
remove the cap from the valve of the
punctured tyre and connect and firmly
tighten the transparent tube of the
sealing fluid 1 fig. 109 and tighten nut
2 on the tyre valve;
make sure that the switch for the
compressor is in position0(off), start the
engine, open the rear hatch and insert the
plug in the into the luggage compartment
power socket or on central tunnel and
start the engine. Switch on the
compressor by turning the switch to
positionI(on);
inflate the tyre to the pressure
indicated in the “Wheels” paragraph in the
“Technical data” chapter;
if after five minutes pressure is not at
least 1.8 bar/26 psi, turn off the
compressor and disconnect it from the
valve and power socket, replace the cap,
then move the vehicle forwards by
approx. ten metres in order to distribute
the sealing fluid inside the tyre evenly.
Stop the vehicle safely and repeat the
operation above until the required
pressure is reached;
if after this operation you still cannot
reach at least 1.8 bar/26 psi after
5 minutes from switching on the
compressor, THE TYRE IS TOO
DAMAGED TO BE REPAIRED. Remove
and place the kit in the specific
compartment and contact an Alfa Romeo
Dealership;
if the required pressure is reached,
restart driving. Do not exceed 80 km/h.
Avoid sudden acceleration or braking.
After driving for about 8 km / 5 miles,
place the vehicle in a safe and suitable
area, engaging the parking brake. Pick up
the kit, ensure the on-off button is in0
position, insert the electrical connector in
the vehicle 12V socket. Remove the cap
from the valve of repaired tyre,
disconnect and pull out the black inflation
tube, connect it to the valve and lock it
with the lever. Check the tyre pressure on
the pressure gauge.
if the pressure is lower than 1.8 bar /
26 psi, the TYRE IS TOO DAMAGED AND
CANNOT BE REPAIRED. Remove and
place the kit in the specific compartment
and contact an Alfa Romeo Dealership;
if the pressure indicated is equal to or
higher than 1.8 bar/26 psi, switch on the
compressor and inflate to the required
pressure. Disconnect and replace the kit
in the specific compartment. Drive
carefully to the nearest Alfa Romeo
Dealership as soon as possible.
CHECKING AND RESTORING TYRE
PRESSURE
The compressor can also be used to
check and, if necessary, restore the tyre
pressure.
Disconnect and pull out the black
inflation tube 1 fig. 110, connect and to
the tyre valve and lock in position with
the lever.
With the same procedure it is possible to
inflate bicycle tyres and balloons. The kit
should be used by adults and cannot be
used by children.
109A0K0518C
121

Everything you may find useful for understanding how your car is
made and works is contained in this chapter and illustrated with
data, tables and graphics. For the enthusiasts and the technician,
but also just for those who want to know every detail of their car.
TECHNICAL SPECIFICATIONS
IDENTIFICATION DATA..........................152
VEHICLE IDENTIFICATION NUMBER (VIN) PLATE . . . . ......152
CHASSIS NUMBER . . . . . .......................153
ENGINE MARKING . . . . . ........................153
ENGINE...................................154
WHEELS...................................159
DIMENSIONS . . ..............................165
WEIGHTS..................................166
REFUELLING................................169
FLUIDS AND LUBRICANTS. . . .....................172
PERFORMANCE . . . . . . . . . . . . . .................175
FUEL CONSUMPTION. . . . . ......................176
CO2 EMISSIONS . . . . ..........................178
PRESCRIPTIONS FOR HANDLING THE VEHICLE AT THE END OF ITS
LIFE......................................179

IDENTIFICATION DATA
The identification data of the vehicle are:
VIN plate;
Chassis marking;
Bodywork paint identification plate;
Engine marking.
VEHICLE IDENTIFICATION
NUMBER (VIN) PLATE
This plate is fitted to the engine
compartment front crossmember and
contains the following identification data
fig. 129:
TO: Name of Manufacturer
B: Type-approval number
C: Vehicle type identification code
D: Chassis number
E: Maximum permitted weight of vehicle
fully laden
F: Maximum permitted weight of vehicle
fully laden plus trailer
G: Maximum permitted weight on front
axle
H: Maximum permitted weight on second
(rear) axle
I: Engine type
L: Bodywork version codeM: Spares number
N: Smoke opacity index (for diesel
engines)
129A0J0161C
152
TECHNICAL SPECIFICATIONS

Light beam direction..........34
Hill Holder system.............67
Identification data
chassis marking............153
engine marking............153
identification data plate.......152
Ignition device...............11
Installing a Universal Isofix child
restraint system............79
Instrument panel...............8
Interior lights................21
Interiors (cleaning)............149
Isofix child restraint system setup . . .79
Jack.....................116
Jump starting...............122
Keys.....................10
Key with remote control........10
Lifting the vehicle............147
Light bulbs
types of bulbs.............105
Luggage compartment
Extending the luggage
compartment..............34
Luggage compartment
initialisation...............34
Main beam headlights..........19
Main beam headlights (bulb
replacement)..............108
Mechanical key...............10
Menu items.................43MSR system................66
Multimedia
Power on/off.............187
Number plate lights (bulb
replacement)..............110
Parking lights................19
Parking sensors..............98
Parking the vehicle.............91
Passenger side front airbag.......82
Performance...............175
Pre-tensioners...............73
Load limiters..............73
Rain sensor.................22
Rear direction indicators (bulb
replacement)..............110
Rear fog light................20
Rear fog light/reversing light (bulb
replacement)..............110
Rear light clusters (bulb
replacement)..............109
Rear seat..................15
Rear view mirrors.............18
Rear window wiper/washer.......23
Reconfigurable multifunction
display................40,42
Refuelling.................169
Refuelling the vehicle..........100
Replacing a bulb.............104
exterior lights.............108
General instructions.........104Rims and tyres provided . . ......159
Safe Lock (device).............11
SBR system (Seat Belt Reminder). . . .72
Scheduled servicing . . . . . ......128
Scheduled Servicing Plan . . ......129
Screen wiper/washer . . . . . ......22
Seat belts . . . . ..............70
Seat belts (using) ..............70
Seats . . . . . . . ..............14
Servicing and maintenance
Demanding use of the car ......136
periodic checks . . . .........136
Setup menu .................43
Side airbags (Side bag - Window
bag) ....................86
Side bags (front side airbags) . . . . . .86
Side lights/brake lights (bulb
replacement). . . ...........110
Side lights/daytime running lights
(DRL) (bulb replacement) ......108
Side lights/dipped beam
headlights . . ..............19
Snow chains................164
Sport front seats ..............15
Start&Stop (system) . . . . . ......95
Starting the engine . . . . . . . . .90 ,122
Bump starting . ............123
Steering lock . . ..............11
Steering wheel . . . . ...........17
Technical data..............152
INDEX