2020 YAMAHA YXZ1000R SS tires

8-15
8
Braking
When slowing down or stopping, take your
foot off the accelerator pedal and press the
brake pedal smoothly. Abrupt or improper
use of the brakes can cause the tires to lose
traction, reducing control of the vehicle and
increasing the possibility of an accident.
Braking ability is affected by type of terrain. In
most cases, gradual application of the brakes
is more effective than abrupt braking, partic-
ularly on loose surfaces, such as gravel. Al-
ways allow for greater braking distance on
rough, loose, or slippery surfaces.
Engine compression braking will also help
slow the vehicle down. With the transmission
still in gear, take your foot off the accelerator
and allow the drivetrain and engine to absorb
vehicle speed. Downshift as necessary. Ap-
plication of the brakes provides additional
stopping power. Leaving the vehicle
Do not get out of the vehicle while the engine
is running. Take the key with when you leave
the vehicle. There is a serious risk of injury or
death because:

Children or other unauthorized persons
may attempt to operate the vehicle.
 Objects tossed into the vehicle may strike
the shift lever and accidently engage the
transmission.
 The parking brake may not keep the vehicle
from moving.
Parking on a flat area
Even when parking on a seemingly flat area, it
is good practice to leave the transmission in
gear to prevent the vehicle from rolling.
Therefore, shift into first or reverse gear, stop
the engine and always apply the parking
brake.UBAS7AE0.book Page 15 Wednesday, June 19, 2019 11:51 AM

9-58
9
EBU35833Checking and tightening the bead lock
(equipped models)Check the bead lock at the intervals specified
in the periodic maintenance chart and when-
ever the tires have been replaced.Tighten the bead lock bolts to the specified
torque in a crisscross pattern.
EBU32620Tire replacementAlways use the same size and type of tires
recommended in this owner’s manual. The
tires that came with your Yamaha YXZ1000R
1. Wheel nut
11
1. Bead lock
2. BoltTightening torque:
Bead lock bolts:37 N·m (3.7 kgf·m, 27 lb·ft)1
2
22 2
UBAS7AE0.book Page 58 Wednesday, June 19, 2019 11:51 AM

9-59
9
were designed to match the performance ca-
pabilities and to provide the best combination
of handling, braking, and comfort. It is best to
replace all four tires at the same time. If that is
not possible, you must replace the tires in
pairs (front or rear) with tires of the same size
and type as the originals. Never replace just
one tire.
WARNING
EWB03390Installing improper tires on your Yamaha
YXZ1000R can affect handling and stabili-
ty. This can cause a loss of control. The tires listed below have been approved by
Yamaha Motor Manufacturing Corporation of America for this model.
EBU33090Wheel installation1. Install the wheel and the nuts.
2. Lower the vehicle so that the wheel is on the ground.
3. Tighten the wheel nuts in a crisscross pattern to the specified torque.
WARNING
EWB03400Do not reverse the rims on your Yamaha
YXZ1000R to widen the track width. In-
stalling wheels improperly increases the
risk of wheel failure and accidents. Front tire:Size:29 x 9.00R-14NHS
Manufacturer/model: MAXXIS/M917 / BIGHORN
Rear tire: Size:29 x 11.00R-14NHS
Manufacturer/model: MAXXIS/M918 / BIGHORN
UBAS7AE0.book Page 59 Wednesday, June 19, 2019 11:51 AM

11-3
11
Fuel reserve amount:8.5 L (2.24 US gal, 1.87 Imp.gal)Throttle body:ID mark:
B5H1 00Spark plug (s):Manufacturer/model:NGK/CR9EB
Spark plug gap:
0.7–0.8 mm (0.028–0.031 in)Drivetrain:Primary reduction ratio:1.660 (88/53)
Secondary reduction ratio:
7.333 (46/23 x 33/9)
Final drive: Shaft
Clutch type: Wet, multiple-disc
Transmission type:
5-speed with reverse
Gear ratio: 1st:
2.400 (36/15)
2nd: 1.545 (34/22)
3rd: 1.192 (31/26)
4th:
0.962 (25/26)
5th: 0.806 (25/31) Reverse gear:
2.467 (28/15 x 37/28)
Front tire:Size:
29 x 9.00R-14NHS
Manufacturer/model: MAXXIS/M917 / BIGHORNRear tire:Size:
29 x 11.00R-14NHS
Manufacturer/model: MAXXIS/M918 / BIGHORNTire air pressure (measured on cold tires):Vehicle load:
0.0–195.0 kg (0–430 lb)
Recommended: Front:
114.0 kPa (1.140 kgf/cm², 16.5 psi)
Rear: 128.0 kPa (1.280 kgf/cm², 18.5 psi)
Minimum: Front: 110.0 kPa (1.100 kgf/cm², 16.0 psi)
Rear: 124.0 kPa (1.240 kgf/cm², 18.0 psi)
Vehicle load:
195.0–328.0 kg (430–723 lb)
Recommended: Front:
114.0 kPa (1.140 kgf/cm², 16.5 psi)
Rear: 169.0 kPa (1.690 kgf/cm², 24.5 psi)
UBAS7AE0.book Page 3 Wednesday, June 19, 2019 11:51 AM

13-3
13
Steering, Pre-operation check ....................................... 6-7
Steering shaft, lubrication ............................................ 9-57
Steering wheel position ............................................... 5-27
Storage ........................................................................ 10-2
Storage compartments ................................................ 5-29TTire, replacing .............................................................. 9-58
Tires, Pre-operation check ............................................ 6-8
Transmission oil ........................................................... 9-29
Transmission, Pre-operation check ............................... 6-6
Troubleshooting ........................................................... 9-69
Troubleshooting charts ................................................ 9-70UUpper and lower arm pivot, lubrication ....................... 9-55VValve clearance ............................................................ 9-47
Vehicle identification number ........................................ 1-1WWheel installation ......................................................... 9-59
Wheel removal ............................................................. 9-57YYamalube ..................................................................... 9-28
YCC-S clutch ............................................................... 9-51
YCC-S clutch, Pre-operation check .............................. 6-8
YCC-S system ............................................................. 5-23
YCC-S system warning light .......................................... 5-7
UBAS7AE0.book Page 3 Wednesday, June 19, 2019 11:51 AM