Page 223 of 283
Vehicle care221
2. Press retaining clip upwards andpull the bulb socket toward the
rear.
3. Detach the bulb from the bulb socket and replace the bulb.
4. Insert the bulb socket into the reflector housing.
5. Fit the protective cover on.
Front turn lights
In case of defective LEDs, have them
replaced by a workshop.
Side light
In case of defective LEDs, have them replaced by a workshop.
Daytime running light
In case of defective LEDs, have them
replaced by a workshop.
LED headlights
Headlights for low and high beam,
sidelights, daytime running lights and turn lights are designed as LEDs and
cannot be changed.
Have lights repaired by a workshop in
case of failure.
Front fog lights
Have bulbs replaced by a workshop.Tail lights
Tail lights, daytime running lights and
3rd-brake light are designed as LEDs.
In case of failure, have LEDs replaced by a workshop.
Light assembly in the body
1. Open the tailgate then unclip the access cover on the relevant side.
Page 229 of 283
Vehicle care227No.Circuit1Climate control2Steering wheel4Electric parking brake6Air vent16Front fog lights18Right high beam (Halogen) /
Right headlight (LED)19Left high beam (Halogen) /
Right headlight (LED)21StarterNo.Circuit22Heated windscreen26Additional Heater / Heated
windscreen
After having changed defective fuses,
close the fuse box cover and lock it.
If the fuse box cover is not closed
correctly, malfunction may occur.
Instrument panel fuse box
In right-hand drive vehicles, the fuse
box is located behind a cover in the
glovebox. Open the glovebox and
remove the cover.
Depending on the version, different
instrument panel fuse boxes are
available:No.Circuit1Electronic key system / Anti-
theft alarm system4Stop-start system5Advanced parking assist /
Camera / Transmission control
module7Amplifier8Rear wiper
Page 246 of 283
244Vehicle care3. Allow both engines to idle forapprox. 3 minutes with the leads
connected.
4. Switch on electrical consumers e.g. headlights, heated rear
window of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle
Remove the cap.
The towing eye is stowed with the
vehicle tools 3 229.
Screw in the towing eye as far as it will
go until it stops in a horizontal
position.
Attach a tow rope – or better still a tow
rod – to the towing eye.
The towing eye must only be used for towing and not for recovering the
vehicle.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.
Page 249 of 283

Vehicle care247Do not clean the engine compartment
with a steam-jet or high-pressure jet
cleaner.
Thoroughly rinse and leather-off the
vehicle. Rinse leather frequently. Use
separate leathers for painted and
glass surfaces: remnants of wax on
the windows will impair vision.
Have the door hinges of all doors
greased by a workshop.
Exterior lights
Headlight and other light covers are
made of plastic. Do not use any
abrasive or caustic agents, do not use
an ice scraper, and do not clean them dry.
Polishing and waxing
Wax the vehicle regularly at the latest
when water no longer beads.
Otherwise, the paintwork will dry out.
Polishing is necessary only if the paint
has become dull or if solid deposits
have become attached to it.
Paintwork polish with silicone forms a
protective film, making waxing
unnecessary.Plastic body parts must not be treated with wax or polishing agents.
Windows and wiper blades Switch off wipers before handling in
their areas.
Use a soft lint-free cloth or chamois leather together with window cleanerand insect remover.
When cleaning the rear window from
inside, always wipe in parallel to the
heating element to prevent damage.
For mechanical removal of ice, use a
sharp-edged ice scraper. Press the
scraper firmly against the glass so
that no dirt can get under it and
scratch the glass.
Clean smearing wiper blades with a
soft cloth and window cleaner. Also
make sure to remove any residues
such as wax, insect residues and
similar from the window.
Ice residues, pollution and continuous
wiping on dry windows will damage or
even destroy the wiper blades.Glass panel
Use a soft lint-free cloth or chamois
leather together with window cleaner
to clean the glass panel.
Wheels and tyres Do not use high-pressure jet
cleaners.
Clean rims with a pH-neutral wheel
cleaner.
Rims are painted and can be treated
with the same agents as the body.
Paintwork damage Rectify minor paintwork damage witha touch-up pen before rust forms.
Have more extensive damage or rust areas repaired by a workshop.
Underbody Some areas of the vehicle underbody
have a PVC undercoating while other
critical areas have a durable
protective wax coating.
After the underbody is washed, check
the underbody and have it waxed if
necessary.
Page 280 of 283

278Fuel gauge ................................... 90Fuses ......................................... 225
G
Gauges ......................................... 89
Gear selection ........................... 147
Gear shifting ................................. 96
General information ...................205
Glass panel .................................. 42
Glovebox ..................................... 68
Glovebox cooler ......................... 132
H Halogen headlights ....................219
Hazard warning flashers ............117
Headlight flash ........................... 113
Headlight range adjustment ......114
Headlights................................... 112
Headlights when driving abroad 114
Head restraint adjustment .............8
Head restraints ............................ 44
Heated mirrors ............................. 37
Heated rear window ..................... 40
Heated steering wheel .................80
Heated windscreen .......................41
Heating .................................. 50, 51
Heating and ventilation system . 122
High beam ........................... 99, 113
High beam assist ..........................99
Hill start assist ........................... 155
Horn ....................................... 13, 80Hybrid system active....................95
Hybrid system fault .......................95
I Identification plate .....................256
Ignition switch positions .............134
Immobiliser .................................. 36
Indicators ...................................... 89
Inductive charging ........................86
Info Display ................................. 102
Instrument cluster ........................87
Instrument panel fuse box .........227
Instrument panel illumination control .................................... 119
Instrument panel overview ........... 10
Interior care ............................... 248
Interior lighting ............................ 119
Interior lights ...................... 120, 225
Interior mirrors .............................. 38
Interruption of power supply ......149
Introduction .................................... 3
J
Jump starting ............................. 242
K Keys ............................................. 20
Keys, locks ................................... 20L
Lane departure warning .......96, 190
Lane keep assist ..................96, 191
Lashing eyes ............................... 73
LED headlights .............99, 114, 221
Lighting features .........................121
Light switch ................................ 112
Load compartment ................29, 69
Load compartment cover .............71
Loading information .....................76
Low beam ..................................... 99
Low fuel ....................................... 98
M
Malfunction indicator light ............94
Manual anti-dazzle ......................38
Manual mode ............................. 148
Manual seat adjustment ...............46
Manual transmission .................. 150
Mirror adjustment ........................... 9
Misted light covers .....................119
N New vehicle running-in ..............134
Number plate light .....................225
O
Object detection systems ...........176
Odometer ..................................... 89
Oil, engine .......................... 254, 258
Page:
< prev 1-8 9-16 17-24