2020 VAUXHALL COMBO E ECU

214Vehicle care
Push the safety catch upwards and
open the bonnet.
Secure the bonnet support.
Closing
Before closing the bonnet, press the
support into the holder.
Lower the bonnet and let it fall into the
latch from a low height (20-25 cm).
Check that the bonnet is engaged.Caution
Do not press the bonnet into the
latch to avoid dents.
Engine oil
Check the engine oil level manually
on a regular basis to prevent damage
to the engine. Ensure that the correct
specification of engine oil is used.
Recommended fluids and lubricants
3 254.
The maximum engine oil
consumption is 0.6 l per 600 miles.
Check with the vehicle on a level
surface. The engine must be at
operating temperature and switched
off for at least 5 min.
Caution
It is the owner's responsibility to
maintain the proper level of an
appropriate quality engine oil in
the engine.
Pull out the dipstick, wipe it clean, reinsert it fully, pull out and read the
engine oil level.

242Vehicle care● Note that the spare wheel issecured by the conical contact ofeach bolt if the wheel bolts for the alloy wheels are used. In this
case, the washers do not come
into contact with the spare wheel.
1. Disengage wheel bolt caps with the wheel bolt cover remover.
3 230
Steel wheels with cover: Pull off
the wheel cover.
Alloy wheels: Disengage wheel
bolt caps with the wheel bolt cover
remover.2. Attach the wheel wrench and loosen each wheel bolt by half a
turn.
The wheels might be protected by
locking wheel nuts. To loosen
these specific nuts first attach the
adapter onto the head of the nut
before installing the wheel
wrench. The adapter is located in
the tool box. 3 230
3. Ensure the jack is correctly
positioned under the relevant
vehicle jacking point.
4. Set the jack to the necessary height. Position it directly below
the jacking point in a manner that
prevents it from slipping.

Vehicle care243Ensure that the edge of the body
fits into the notch of the jack.
With the jack correctly aligned
rotate wheel wrench until wheel is
clear of the ground.
5. Unscrew the wheel nuts.
6. Change the wheel. Spare wheel 3 240.
7. Screw on the wheel nuts.
8. Lower the vehicle and remove jack.
9. Install the wheel wrench ensuring that it is located securely and
tighten each bolt in a crosswise
sequence. Tightening torque is
115 Nm.
If the vehicle is equipped with
alloy wheels, note that the wheel
bolts can also be used for the steel spare wheel. In this case, the
spare wheel is secured by the
conical contact of each bolt.
10. Align the valve hole in the wheel cover with the tyre valve before
installing.
Install wheel nut caps.
11. Stow the replaced wheel 3 240,
the vehicle tools 3 230 and the
adapter for the locking wheel nuts.
12. Check the tyre pressure of the installed tyre and the wheel nuttorque as soon as possible.Jump starting
Do not start with quick charger.
A vehicle with a discharged vehicle
battery can be started using jump
leads and the vehicle battery of
another vehicle.9 Warning
Be extremely careful when starting
with jump leads. Any deviation
from the following instructions can
lead to injuries or damage caused
by battery explosion or damage to the electrical systems of both
vehicles.
9 Warning
Avoid contact of the battery with
eyes, skin, fabrics and painted
surfaces. The fluid contains
sulphuric acid which can cause
injuries and damage in the event
of direct contact.
● Never expose the vehicle battery
to naked flames or sparks.

276Three-point seat belt .................... 55
Tools .......................................... 230
Tow bar....................................... 206
Towing ................................ 206, 245
Towing another vehicle .............246
Towing equipment .....................207
Towing the vehicle .....................245
Trailer coupling ........................... 206
Trailer stability assist .................210
Trailer towing ............................. 206
Transmission ............................... 17
Transmission display .................155
Tread depth ............................... 234
Trip odometer .............................. 97
Turn lights .......................... 100, 125
Tyre chains ................................ 235
Tyre deflation detection system . 233
Tyre designations ......................231
Tyre pressure ............................ 232
Tyre pressures ........................... 264
Tyre repair kit ............................. 235
U
Ultrasonic parking assist............. 183
Underseat storage .......................72
Upholstery .................................. 249
USB port ....................................... 93
Using this manual ..........................3V
Valet mode ................................. 110
Vauxhall Connect .......................119
Vehicle battery ........................... 217
Vehicle checks............................ 213
Vehicle data ................................ 258
Vehicle data recording and privacy ..................................... 268
Vehicle dimensions .................... 262
Vehicle identification number ....256
Vehicle jack ................................ 230
Vehicle locator lighting ...............129
Vehicle messages .....................114
Vehicle personalisation .............115
Vehicle security ............................ 34
Vehicle specific data ......................3
Vehicle storage ........................... 212
Vehicle tools ............................... 230
Vehicle unlocking ........................... 6 Ventilation ................................... 138
W Warning chimes .........................114
Warning lights ............................... 97
Warning triangle .......................... 84
Washer and wiper systems .........13
Washer fluid ............................... 216
Wheel changing .........................238
Wheel covers ............................. 235
Wheels and tyres .......................231Windows....................................... 40
Windscreen................................... 40
Windscreen wiper and washer ....90
Winter tyres ............................... 231
Wiper blade replacement ..........219