45
112,500 miles or 90 months
Check installation of driver’s floor mat
Inspect and adjust all fluid levels1
Inspect drive belts
Inspect wiper blades
Replace engine air filter
Replace engine oil and oil filter2
Rotate tires
 
Visually inspect brake linings/drums  
and brake pads/discs
Dealer Service verification:
D
ate:
Mileage:
120,000 miles or 96 months
Check installation of driver’s floor mat
Inspect and adjust all fluid levels1
 
Inspect emergency flat tire repair kit  
(if equipped)3
Inspect wiper blades
Replace cabin air filter
Replace engine coolant4
Replace engine oil and oil filter2
Rotate tires
 
Tighten nuts and bolts on body  
and chassis
Inspect the following:
Ball joints and dust covers
Brake lines and hoses
 
Brake linings/drums and brake pads/discs5
Drive shaft boots
Emission hoses and tubes Fuel lines and connections, fuel tank band 
and fuel tank vapor vent system hoses
Fuel tank cap gasket
Radiator and condenser
Steering gear
Steering linkage and boots
Transmission fluid or oil
Dealer Service verification:
D
ate:
Mileage:
1   inspect sealed transmissions, transfer cases and differentials for signs of leakage. if any leakage from a sealed   
component is suspected, it is recommended that you have the sealed component inspected by a toyota dealer. inspect   
power steering fluid (if equipped) and brake fluid level/condition. inspect engine and inverter (if equipped) coolant 
level/condition/freezing point. Your dealer may recommend services (Dealer-recommended Maintenance) based on 
inspection results.
2   reset the scheduled maintenance indicator light. Use 0W-20 genuine toyota Motor oil or equivalent. 3  check the tire repair fluid expiration date every year during inspection. replace the tire repair fluid bottle with a new one 
before the expiration date.
4   NOTE:  Initial replacement at 120,000 miles/120 months. Replace every 60,000 miles/60 months thereafter. Refer   
to “Engine Coolant” in the “Explanation of Maintenance Items” section in the back of this guide for more information.
5  Inspect thickness measurement and disc runout.
Maintenance Log 
MAINTENANCE LOG
MAINTENANCE  
         
        
        47
EXPLANATION OF MAINTENANCE ITEMS
Driver’s Floor Mat
•  
Only use the driver’s floor mat   
designed specifically for the model   
and model year of your vehicle.
•   
Always properly secure the driver’s   
floor mat using the retaining hooks.
•   
Never install another floor mat on top   
of the existing driver’s floor mat.
•   
Never install the driver’s floor mat   
upside down.
Emergency Flat Tire Repair Kit
Inspect at specified intervals.
Emission Hoses and Tubes 
Visually inspect for corrosion, damage, cracks, 
and loose or leaking connections. Tighten 
connections or replace parts as necessary.
Engine Air Filter
Inspect or replace at specified intervals.   
When performing inspections, check for 
damage, excessive wear and oiliness, and 
replace if necessary.
Engine Coolant
NOTE:  Initial replacement is at   
120,000 miles /120 months. Replace 
every 60,000 miles/60 months thereafter.
Drain the cooling system and refill with the 
coolant specified by Toyota for your vehicle. 
Inspect hoses and connections for corrosion 
and leaks. Tighten connections and replace 
parts when necessary. A qualified technician 
should perform these operations.
Engine Oil and Oil Filter
Replace the oil filter and drain and refill 
the engine oil at specified intervals. For 
recommended oil grade and viscosity,   
refer to the Owner’s Manual.
Your vehicle is equipped with 0W-20   
synthetic oil, which allows for extended oil 
change intervals and optimum fuel economy. 
It is recommended that Toyota Genuine 
0W-20 Motor Oil be used during scheduled 
oil changes. For normal operating conditions, 
Toyota recommends changing your oil 
and filter every 7,500 miles or six months, 
whichever occurs first. For special operating 
condition maintenance recommendations, 
refer to page 37 of this publication.
Exhaust Pipes and Mountings 
Visually inspect the exhaust pipes, muffler   
and hangers for cracks, deterioration and 
damage. Start the engine and listen   
carefully for any exhaust gas leakage.   
Tighten connections or replace parts   
as necessary.
Maintenance Log 
MAINTENANCE