2020 TOYOTA RAV4 ignition
[x] Cancel search: ignitionPage 4 of 64
2
OVERVIEW
Instrument panel
Steering wheel controls
Audio volume
control switch2
Telephone switch2
Voice
command switch2
Tilt and telescopic steering
lock release lever (below
the steering wheel)
Ignition switch
Audio control switches2
LTA (Lane Tracing Assist)/Lane Departure
Alert with Steering Assist (LDA w/SA) switch
Meter control
switches
Hood lock release lever Headlight/turn signal/fog light
1 control
Fuel tank door release lever Power Liftgate main switch
1
Bird’s Eye View Camera
ON/OFF switch1,2
Windshield de-icer
switch1
Instrument panel
light control dial
Automatic High Beam
(AHB) switch
Heated steering wheel switch
1
Windshield wiper and washer control
Meters Multi-Information Display (MID)
Full-Speed Range Dynamic Radar
Cruise Control (DRCC) Vehicle-to-
vehicle distance switch
Full-Speed Range
Dynamic Radar Cruise
Control (DRCC) switch
Page 41 of 64
39
CHANGING PRE-COLLISION ALERT TIMING
% * 4 " # - * / ( 1 3 & $ 0 - - * 4 * 0 / 4 : 4 5 & . 1 $ 4
Each time the PCS switch is pressed, the response to the PCS alert timing changes.
FarMiddle
(default)Near
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ PCS” and then press “.” The setting
screen is displayed.
1 S F T T “
” switches and select “Sensitivity” and then press “” to select
the desired setting. Each time it is pressed, the response to the PCS alert timing
changes as shown above.
1ress “
” to go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ PCS” and then press “.”
1 S F T T “
” and select “PCS” and then press “” to select the desired setting.
1 S F T T “
” to go back to the menu.
Note: The system is enabled each time the power switch is turned to ON mode.
Refer to the Toyota Owner’s Manual for additional information on PCS operation,
settings adjustments, limitations, and precautions before attempting to use it.
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
Page 42 of 64
40
TOYOTA SAFETY SENSE™
LDA in TSS 2.0 uses an in-vehicle camera designed to detect visible white and
yellow lane markers or road edge in front of the vehicle and the vehicle’s position
on the road. If the system determines that the vehicle is starting to unintentionally
deviate from its lane, the system alerts the driver with an audio and visual alert.
When the alerts occur, the driver must check the surrounding road situation and
carefully operate the steering wheel to move the vehicle back to the center part of
their lane.
- % " J T E F T J H O F E U P G V O D U J P O B U T Q F F E T P G B Q Q S P Y J N B U F M Z N Q I L N I
P S I J H I F S
on relatively straight roadways.
In addition to the alert function, LDA w/SA also features a steering assist
function. When enabled, if the system determines that the vehicle is on a path to
unintentionally depart from its lane, the system may provide small corrective steering
inputs to the steering wheel for a short period of time to help keep the vehicle in its
lane.
If the vehicle repeatedly deviates from the lane, the vehicle drifts within the lane due
to inattention, or the driver abruptly operates the steering wheel after an inattentive
period, when enabled, the vehicle sway warning function alerts the driver with an
audio and visual alert, urging them to take a break.
Lane Departure Alert with Steering Assist
(LDA w/SA)
TURNING THE LDA SYSTEM ON/OFF
Press the LDA switch to turn the LDA system on. Depress again to turn it off.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LDA operation,
settings adjustments, limitations, and precautions before attempting to use it.
Page 44 of 64
42
ADJUSTING LDA ALERT SENSITIVITY
DISABLING STEERING ASSIST
TOYOTA SAFETY SENSE™
SWAY WARNING SYSTEM
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ LDA” and then press “.”
1 S F T T “
” switches and select the “Steering Assist” setting function and then
press “
.”
1 S F T T “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
5 I F E S J W F S D B O B E K V T U U I F T F O T J U J W J U Z P G U I F - % " X B S O J O H
G V O D U J P O G S P N U I F
. V M U J * O G P S N B U J P O % J T Q M B Z . * %
D V T U P N J [ B U J P O T D S F F O
High - Is designed to warn approximately before the front
tire crosses the lane marker.
Normal - Is designed to warn approximately when the front
tire crosses the lane marker.
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ LDA” and then press “.”
1 S F T T “
” switches and select the “Sensitivity” setting function and then
press “
.”
1 S F T T “
” to go back to the menu.
SWS is a function of LDA and is designed to detect swaying based on the vehicle
location in the lane and the driver’s steering wheel operation. To help prevent
swaying, the system alerts the driver using a buzzer sound and a warning displays
in the MID.
Continuous lane deviations from
swaying.
Gentle swaying from driver’s
inattentiveness.
Acute steering wheel operation after the
number of operations decrease due to driver’s
inattentiveness.
Page 45 of 64
43
ADJUSTING SWAY ALERT SENSITIVITY
DISABLING LDA SWAY WARNING ALERT
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ LDA” and then press “.”
1 S F T T “
” switches and select the “Sway Sensitivity” setting function and then
press “
.”
1 S F T T “
” to go back to the menu.
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ LDA” and then press “.”
1 S F T T “
” switches and select the “Sway Warning” setting function and then
press “
.”
1 S F T T “
” to go back to the menu.
Note: Operation of the LDA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Page 46 of 64
44 When the LTA system is enabled, the lane centering function will automatically
provide assistance to help keep the vehicle in the center of the lane when Full-
Speed DRCC is set.
TOYOTA SAFETY SENSE™
TURNING THE LTA SYSTEM ON/OFF
Press the LTA switch to turn the LTA system on. Depress again to turn it off.
Note: Operation of the LTA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Refer to the Toyota Owner’s Manual for additional information on LTA operation,
settings adjustments, limitations, and precautions before attempting to use it.
Lane Tracing Assist (LTA)
Page 48 of 64
46
TOYOTA SAFETY SENSE™
ADJUSTING LTA ALERT SENSITIVITY
DISABLING STEERING ASSIST
5 I F E S J W F S D B O B E K V T U U I F T F O T J U J W J U Z P G U I F - 5 " X B S O J O H
G V O D U J P O G S P N U I F
. V M U J * O G P S N B U J P O % J T Q M B Z . * %
D V T U P N J [ B U J P O T D S F F O
High - Is designed to warn approximately before the front
tire crosses the lane marker.
Normal - Is designed to warn approximately when the front
tire crosses the lane marker.
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ LTA” and then press “.”
1 S F T T “
” switches and select the “Sensitivity” setting function and then
press “
.”
1 S F T T “
” to go back to the menu.
1 S F T T “
” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ LTA” and then press “.”
1 S F T T “
” switches and select the “Steering Assist” setting function and then
press “
.”
1 S F T T “
” to go back to the menu.
Note: Operation of the LTA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
Page 49 of 64
47
LANE CENTERING
The lane centering function is linked with Full-Speed Range Dynamic Radar Cruise
$ P O U S P M % 3 $ $
B O E Q S P W J E F T U I F S F R V J S F E B T T J T U B O D F C Z P Q F S B U J O H U I F T U F F S J O H
wheel to keep the vehicle in its current lane.
When dynamic radar cruise control with full-speed range is not operating, the lane
centering function does not operate.
OVERVIEW FEATURES & OPERATIONS TOYOTA SAFETY SENSE SAFETY & EMERGENCY FEATURES
1 S F T T “ ” switches and select “” G S P N U I F . V M U J * O G P S N B U J P O % J T Q M B Z . * %
1 S F T T “
” switches and select “ LTA” and then press “.”
1 S F T T “
” switches and select the “Lane center” setting function and then
press “
.”
1 S F T T “
” to go back to the menu.
Note: Operation of the LTA system and setting adjustments continues in the
same condition regardless of Ignition cycle until changed by the driver or the
system is reset.
DISABLING LANE CENTERING FUNCTION