2020 TOYOTA RAV4 HYBRID low beam

2
OVERVIEWInstrument panel
Steering wheel controls
Audio volume
control switch2
Telephone switch2
Voice
command switch2
Audio control switches2
LTA (Lane Tracing Assist)/Lane Departure
Alert with Steering Assist (LDA w/SA) switch
Meter control
switches
Full-Speed Range Dynamic Radar
Cruise Control (DRCC) Vehicle-to-
vehicle distance switch
Full-Speed Range
Dynamic Radar Cruise
Control (DRCC) switch
Tilt and telescopic steering
lock release lever
(below the steering wheel)
Ignition switch
Hood lock release lever
Headlight/turn signal/fog light
1 control
Fuel tank door release lever
Power Liftgate main switch
1
Bird’s Eye View Camera
ON/OFF switch1,2
Windshield de-icer
switch1
Instrument panel
light control dial
Automatic High Beam
(AHB) switch
Heated steering wheel switch
1
Windshield wiper and washer control Meters
Multi-Information Display (MID)

6
OVERVIEWIndicator symbols
For details, refer to “Indicators and warning lights,” Section 2-1\
, 2020 Owner’s
Manual.
Blind Spot Monitor (BSM) indicator4
BSM outside rear view mirror
indicators4
Brake system warning1
Charging system warning1
Brake system warning1
[Yellow]
Fuel tank door position
Airbag ON/OFF indicator
1
Anti-lock Brake System (ABS)
warning1
Automatic High Beam (AHB)
indicator
ECO drive mode indicator
Electric power steering system
warning1 [Red/yellow]
Hybrid system overheat warningFront and Rear Parking Assist
with Automated Braking OFF
indicator
1,2,4
Brake hold operating indicator1,2
Brake hold standby indicator1
Brake Override System/Drive-Start
Control/Front and Rear Parking
Assist with Automated Braking
4,5
warning
Driver’s and front passenger’s seat
belt reminder
(alarm will sound when
the engine switch is ON mode)
Airbag SRS warning1
Fog light indicator4
High coolant temperature warning Headlight low/high beam
indicators
EV drive mode indicator
EV indicator
Constant speed cruise control
indicator/Constant speed
cruise control SET indicator
Full-Speed Range Dynamic
Radar Cruise Control (DRCC)
indicator/DRCC SET indicator

18
FEATURES & OPERATIONS
1 The right hand signals will flash three times.2 The left hand signals will flash three times.
Right turn
Lane change
1
Lane change2
Left turn
Lights & turn signals
Daytime Running Light system (DRL) Automatically turns on under certain
conditions to make vehicle more visible to other drivers. Not for use at\
night.
Automatic light cut off system Automatically turns lights off after 30 second
delay, or lock switch on remote is pushed after locking.
Automatic High Beam (AHB) system Automatically switches between high
and low beams as appropriate to enhance vision at night.
Refer to Toyota Safety Sense™ 2.0 (TSS 2.0) in this guide or the Ow\
ner’s Manual
for more details on the Automatic High Beam feature.
* Operating conditions must be met. Refer to the Owner’s Manual for d\
etails.
Type AType B
HEADLIGHTS
Parking lights
Low beam
High beam
Automatic High beam* or
Auto
Headlights
DRL OFF Parking lights
DRL ON Headlights
OFF
High beam flasher
TURN SIGNALS

19
OVERVIEW
FEATURES & OPERATIONS
TOYOTA SAFETY SENSE
SAFETY & EMERGENCY FEATURES
Windshield wipers & washers
Front fog lights come on only when the headlights are on low beam.
Turn
OFF
ON
FRONT
*Intermittent windshield wiper
frequency adjustment Rotate to
increase/decrease wipe frequency. *
Rain-sensing windshield wiper Rotate
to increase/decrease sensor sensitivity.
Intermittent (if equipped)
Adjust frequency*
Adjust frequency*Single wipeSingle wipe
Interval wipeInterval wipe
Slow Slow
FastFastPull to wash
and wipePull to wash
and wipe
Off
Off
Rain-sensing (if equipped)
REAR
Single wipe
Interval wipe
Off
Push to Wash and wipe
'0(-*()54 *'&26*11&%

Cup holders
FRONT REAR

48
TOYOTA SAFETY SENSE™
Automatic High Beams (AHB)
ACTIVATING THE AHB SYSTEM
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
When all of these conditions are met, high beams will be automatically t\
urned on
BGUFSBQQSPYJNBUFMZTFDPOE
t7FIJDMFTQFFEJTBCPWFBQQSPYJNBUFMZNQI LNI

• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail\
lights turned on.
• There are few streetlights on the road ahead.
If any of these conditions occur, high beams will be automatically turne\
d off: t7FIJDMFTQFFEESPQTCFMPXBQQSPYJNBUFMZNQI LNI

• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or tail lights turne\
d on.
• There are many streetlights on the road ahead.
AHB is a safety system designed to help drivers see more of what’s ah\
ead at
nighttime while reducing glare for oncoming drivers, AHB uses an in-vehi\
cle
camera to help detect the headlights of oncoming vehicles and tail light\
s of
preceding vehicles, then automatically switches between high and low bea\
ms
as appropriate to provide the most light possible and enhance forward vi\
sibility.
By using high beams more frequently, the system may allow earlier detect\
ion of
pedestrians and obstacles.
Refer to the Toyota Owner’s Manual for additional information on AHB \
operation,
settings adjustments, limitations, and precautions before attempting to \
use it.
(2) (1)

1SFTTUIFi
” switch.

1VTIMFWFSBXBZGSPNZPVXJUIUIFIFBEMJHIUTXJUDIJTJOUIFi
” or “AUTO”
position.
The AHB indicator will come on when the headlights are turned on automat\
ically
to indicate that the system is active.
Note: Pull the lever back toward you or press the AHB switch to turn the\
AHB
system off.
The AHB indicator will turn off. To turn switch to “
” position and the manual
high beam indicator “
” turns on.