2020 SUZUKI JIMNY AIR CO

Child restraint systems suitability for each seat position (for the vehicle with­out airbag deactivation switch)
The above illustration shows Left hand drive vehicle.
NOTE: Seat position number of G), @ and @ is same as Left hand drive vehicle for Right hand drive vehicle.
G) Front passenger's seat @ Rear seat right side @ Rear seat left side
G)
(#1, #2, #3)
~
(#2, #3)
@
(#2, #3)
(gJ
(g)@
[g)~l~
[g)~l~
It is suitable for univer­sal category of child restraint system fixed with the vehicle seat belt.
It is suitable for i-Size and ISOFIX child restraint system.
This seat is equipped with Top tether anchor­age point.
Never use a rear-fac­ing child restraint sys­tem on the passenger seat.
FOR SAFE DRIVING
#1: Move the front seat fully rearward. #2: When you install a forward-facing child restraint, if there is a gap or space between the child restraint and the seatback, adjust the seat­back angle in order to install the child restraint system properly. #3: If the head restraint interferes with the child restratint system, adjust the height of the head restraint or remove it, as necessary.
1-24

FOR SAFE DRIVING
Detailed information for child restraint system (for the vehicle without airbag deactivation switch)
Seat position number
Seating position suitable for universal belted (YES/NO)
· i-Size seating position (YES/NO)
Seating position suitable for lateral fixture (L 1 /L2)
Suitable rear-facing fixture (R1/R2/R3)
Suitable front-facing fixture (F2X/F2/F3)
Key of letters to be inserted in the above table YES =Suitable for this seating position NO = Not suitable for this seating position X =ISOFIX position is not suitable for ISOFIX child restraint systems in this fixture.
CD
YES (#1)
NO
NO
NO
NO
ISOFIX child restraint systems are divided into different mass group, size class and fixture. The child restraint system can be used in the seating positions for fixture shown in the above table. For mass group, size class and fixture, confirm the table of next page.
#1: When installing the child restraint systems, only a front-facing fixture is suitable.
1-25
Seating position
@
YES
YES
X
R1, R2
F2X, F2, F3
@
YES
YES
X
R1, R2
F2X, F2, F3

FOR SAFE DRIVING
Installation suitability of SUZUKI recommendation child restraint systems (for the vehicle without airbag deactivation switch)
Recommendation of Mass group Child restraint system (#A)
0,0+ Britax Romer Baby-Safe i-Size (up to 13kg)
I Britax Romer Duo Plus (9kg to 18kg)
II, II I Britax Romer KidFix XP (15kg to 36kg)
Key of letters to be inserted in the above table YES =II is suitable for this seating position NO = It is not suitable for this seating position
#1: Only belted.
G)
NO
YES (#1)
YES (#1)
#A: These child restraint systems are SUZUKI Genuine Accessory, refer to the accessories catalog. However, there are countries which do not sell this child restraint system.
1-27
Seating position
(2) @
YES (#1) YES (#1)
YES YES
YES YES

FOR SAFE DRIVING
ELR type belt
80JC021
1-29
(For models with front passenger airbag deactivation system) Whenever possible, SUZUKI recom­mends that child restraint systems be installed on . th_e rear seat. According to· accident stat1st1cs, children are safer when ~roperly restrained in rear seating posi­tions than in front seating positions. • If you must install the child restraint sys­tem on the front passenger's seat follow instructions below. ' -D_eactivate the front passenger's front airbag by the front passenger airbag d~activation system (if equipped). -Slide the seat to the most rear position by the seat position adjustment lever. -If there is a gap or space between the child restraint and the seatback, adjust the seatback angle in order to install the child restraint system properly.
Install your child restraint system accord­ing to the instructions provided by the child restraint system manufacturer.
Check that the seat belt is securely latched. Move the child restraint system in all direc­tions to check that it is securely installed. When you put your child in the child restraint system, appropriately slide the front seat forward not to touch a part of your child's body.
Installation with ISOFIX type
anchorages
78RB02020
Your vehicle is equipped with the lower anchorages in the rear seat outboard seat­ing positions for securing a ISOFIX type of child restraints with the connecting bars. The lower anchorages are located where the rear of the seat cushion meets the bot­tom of the seatback.
A WARNING
Install the ISOFIX type of child restraint(s) in the only outboard seat­ing positions, not in the central posi­tion for the rear seat.

FOR SAFE DRIVING
NOTICE
When installing a child restraint sys­tem to the rear seat, adjust the front seat position so that the front seat does not interfere with the child restraint system.
NOTE: For Australian models, refer to "For Austra­lia" in the "SUPPLEMENT" section.
1-33
Seat belt pretensioner system
A WARNING
This section describes your SUZUKI vehicle's seat belt pretensioner sys­tem. Read and follow all these instructions carefully to minimize your risk of severe injury or death.
To determine if your vehicle is equipped with a seat belt pretensioner system at the front or rear seating positions, check the label on the seat belt at the bottom part. If the letters "p" and/or "PRE" appear as illus­trated, your vehicle is equipped with the seat belt pretensioner system. You can use the pretensioner seat belts in the same manner as ordinary seat belts. Read this section and "Supplemental restraint system (airbags)" section to learn more about the pretensioner system.
The seat belt pretensioner system works with the supplemental restraint system (air­bags). The crash sensors and the elec­tronic controller of the airbag system also control the seat belt pretensioners. The pretensioners are triggered only when there is a frontal or side collision severe enough to trigger the airbags and the seat belts are fastened. For precautions and general information including servicing the pretensioner system, refer to "Supplemen­tal restraint system (airbags)" section in addition to this "Seat belt pretensioner sys­tem" section, and follow all those precau­tions.

The pretensioner is located in each front seat belt retractor and each rear seat belt retractor in outboard seating position. The pretensioner tightens the seat belt so the belt fits the occupant's body more snugly in the event of a frontal or side collision. The retractors will remain locked after the pre­tensioners are activated. Upon activation, some noise will occur and some smoke may be released. These conditions are not harmful and do not indicate a fire in the vehicle.
The driver and all passengers must be properly restrained by fastening seat belts at all times, whether or not a pretensioner is equipped at their seating position, to minimize the risk of severe injury or death in the event of a collision.
Sit fully back in the seat; sit up straight; do not lean forward or sideways. Adjust the belt so the lap portion of the belt is worn low across the pelvis, not across the waist. Please refer to "Seat adjustment" section and the instructions and precautions about the seat belts in this "Seat belts and child restraint systems" section for details on proper seat and seat belt adjustments.
Please note that the pretensioners along with the airbags will activate in severe fron­tal or side collisions. They are not designed to activate in rear impacts, roll­overs, or minor frontal side collisions. The pretensioners can be activated only once. If the pretensioners are activated (that is, if the airbags are activated), have the pre­tensioner system serviced by a SUZUKI dealer as soon as possible.
FOR SAFE DRIVING
If AIRBAG light on the instrument cluster does not blink or come on briefiy when the ignition switch is turned to "ON" position, stays on for more than 1 O seconds, or comes on while driving, the pretensioner system or the airbag system may not work properly. Have both systems inspected by a SUZUKI dealer as soon as possible.
Service on or around the pretensioner sys­tem components or wiring must be per­formed only by a SUZUKI dealer who is specially trained. Improper service could result in unintended activation of preten­sioners or could render the pretensioner inoperative. Either of these two conditions may result in personal injury.
To prevent damage or unintended activa­tion of the pretensioners, check that the lead-acid battery is disconnected and the ignition switch has been in "LOCK" position for at least 90 seconds before performing any electrical service work on your SUZUKI vehicle.
Do not touch pretensioner system compo­nents or wiring. The wires are wrapped with yellow tape or yellow tubing, and the couplers are yellow. When scrapping your SUZUKI vehicle, ask a SUZUKI dealer, body repair shop, or scrap yard for assis­tance.
1-34

FOR SAFE DRIVING
Supplemental restraint
system (airbags)
,A. WARNING
This section describes the protection provided by your SUZUKI vehicle's supplemental restraint system (air­bags). Read and follow all instruc­tions carefully to minimize your risk of severe injury or death in the event of a collision.
Your vehicle is equipped with a supple­mental restraint system consisting of the following components in addition to a lap­shoulder belt at each seating position.
(1) Forward crash sensor (2) Side crash sensor (if equipped) (3) Driver's front airbag module (4) Side curtain airbag module (if equipped) (5) Front passenger's front airbag module (6) Side airbag module (if equipped) (7) Front seat belt pretensioners (if equipped) (8) Rear seat belt pretensioners (if equipped) (9) Airbag controller
1-35
2 3
9 6 7
4 5 2 4 6 8
' ., : I!,..---._ -----': ~ /~~wcil',,.--··---.~:r
1_;· v-;
2 8 7 2
78RB02022

A. WARNING
An airbag supplements or adds to the collision protection offered by seat belts. The driver and all passengers must be properly restrained by fas­tening seat belts at all times, whether or not an airbag is mounted at their seating position, to minimize the risk of severe injury or death in the event of a collision.
AIRBAG light
63J030
If AIRBAG light on the instrument cluster does not blink or come on when the igni­tion switch is first turned to "ON" position. or AIRBAG light stays on, or comes on while driving, the airbag system (or the seat belt pretensioner system) may not work properly. Have the airbag system inspected by a SUZUKI dealer as soon as possible.
Airbag symbol meaning
A Dll
AIRBAG ~
®
@t
72M00150
You may find this label on the sun visor.
A. WARNING
NEVER use a rearward facing child restraint on a seat protected by an ACTIVE AIRBAG in front of it, DEATH or SERIOUS INJURY to the CHILD can occur.
FOR SAFE DRIVING
NOTE: For the label of Australia models, refer to "For Australia" in the "SUPPLEMENT" section. For the label of GCC Countries' models, refer to "For GCC Countries" in the "SUPPLEMENT" section. For the label of Taiwan models, refer to "For Taiwan" in the "SUPPLEMENT" section. For the label of Thailand models, refer to "For Thailand" in the "SUPPLEMENT" section.
1-36