INSPECTION AND MAINTENANCE
Interval: This interval should be judged byl km (x1000) 70 I 80 I 90 I 100 I 110 I 120 odometer reading or months, whichever comesi miles (x1000) 43.75 I 50 I 56.25 I 62.5 I 68.75 I 75 first. I months 42 I 48 I 54 I 60 I 66 I 72
ENGINE *1-1. Engine accessory drive bell Tension check, *Adjustment, *Replacement -
I
I
I
-
I
I
I
-
I
R
*1-2. Valve clearance -I ---I
1-3. Engine oil and engine oil filter ACEA Standards or SUZUKI GENUINE OIL (#1) R R R R R R Refer to "Oil change reminder light" in the "BEFORE DRIVING" sec-tion. Other than ACEA Standards or SUZUKI GENUINE OIL (#1) Replace every 7500 km (4687 miles) or 6 months. Refer to "Oil change reminder light" in the "BEFORE DRIVING" sec-lion.
1-4. Engine coolant SUZUKI LLC: Super (Blue) (#2) First time only: Replace at 160000 km (100000 miles) or96 months. Second time and after: Replace every 80000 km (50000 miles) or 48 months.
SUZUKI LLC: Standard (Green) Replace erery 4000~ km (250010 miles) 0136 months.
*1-5. Exhaust system (except catalyst) -I ---I I
IGNITION 2-1. Spark plugs Iridium plug !Replace every 30000 km (18750 miles) or 24 months.
FUEL 3-1. Air cleaner filter element*1 Inspect every 2500 km (1562 miles). Replace every 30000 km (18750 miles) or 24 months.
*3-2. Fuel lines = I : I = I = I = I
I
*3-3. Fuel tank I
EMISSION CONTROL SYSTEM *4-1. PCV valve *4-2. Fuel evaporative emission control system
!Inspect every 80000 km (50000 miles) or 48 months. I -I I I -I I
#1: For further details, see "Engine oil and filter" in this section. #2: Perform the engine coolant level check under the daily inspection in the "OPERATING YOUR VEHICLE" section. If you use the engine coolant other than "SUZUKI LLC: Super (Blue)" for replacement, follow the schedule of "SUZUKI LLC: Standard
(Green)". (Replace every 40000 km (25000 miles) or 36 months.)
6-20
Air cleaner
If the air cleaner is clogged with dust, there will be greater intake resistance, resulting in decreased power output and increased fuel consumption.
(1)
78RB07044
1) Unclampthe clamps (1). 2) Hold up the air cleaner upper case. 3) Remove the element from the air cleaner case. If it appears to be dirty, clean or replace it with a new one. 4) If the element is installed on the air cleaner case, confirm the mark of "FRONT" on the element and fit the boss of the element in the groove of the front on the air cleaner case. 5) Clamp the clamps securely.
Spark plugs
Spark plug replacement and
inspection
(3)~
(1) 0
(2)
78RB07006
To access the spark plug: 1) Disconnect the coupler (1) while pushing the release lever. 2) Remove the bolt (2). 3) Pull out the ignition coil (3) straight.
INSPECTION AND MAINTENANCE
NOTE: During installation, check that the wires, couplers, sealing rubber of air cleaner chassis and washers, are correctly returned in place.
Correct Wrong
§7® ~
~~
78K179
NOTICE
When pulling out the ignition coils, do not pull on the cable. Pulling on the cable can damage it. • When servicing the iridium/platinum spark plugs (slender center electrode type plugs), do not touch the center electrode, as it is easy to be damaged.
6-30
