2020 Seat Ateca warning

Operation

It lights up
Left or right turn signal.
The control lamp flashes twice as f ast when a t
urn
signal is faulty.
Hazard warning lights on

Operation
6. Use the warning triangle to draw the at- tention of other r
oad users to your v
ehicl
e.
7. Always take the vehicle key with you when you leave the vehicle
.
All turn signals flash simultaneously when the
hazard warning lights are switched on. The
two turn signal turn signal lamps   and the
turn signal lamp in the switch  will flash at
the same time. The simultaneous hazard
warning lights also work when the ignition is
switched off.
Emergency braking warning
If the vehicle brakes suddenly and continu-
ously at a speed of more than 80 km/h (50
mph), the brake light flashes several times per
second to warn the vehicles driving behind. If
you continue braking, the hazard warning
lights will come on automatically when the
vehicle comes to a standstill. They switch off
automatically when the vehicle starts to
move again. WARNING

Lights
Setting 2
All seats occupied, luggage compart-
ment full. With trailer and minimum
dr
awbar l
oad.
Setting 3 Driver only, luggage compartment full
Driving with trailer and maximum
drawbar l
oad. Dynamic headlight range control
The control is not mounted in vehicl
es with
dynamic headlight r

ange control. The head-
light range is automatically adjusted accord-
ing to the vehicle load status when they are
switched on. WARNING
Heavy objects in the vehicle may mean
that the headlights dazzle and distract oth- er drivers. This coul d r

esult in a serious ac-
cident.

Visibility
More the lever to the required position:
4 v
Short wipe. Brief press, short clean.
Hold the lev
er do
wn for more time to in-
crease the wipe frequency.
5 W
Windscreen washer. The windscreen
washer function is activated by push-
ing the le

ver towards the steering
wheel, and the wipers operate simulta-
neously.
6 
Interval wipe for rear window. The wip-
er will wipe the window approximat
ely
e

very six seconds.
7 \
The rear window wash function is acti-
vated by pressing the l
e

ver, and the
rear wiper starts simultaneously. WARNING
In cold conditions you should not use the
wash/wipe system unless you hav e
w

armed the windscreen with the heating
and ventilation system. The windscreen
washer fluid could otherwise freeze on the
windscreen and obscure your view of the
road. CAUTION
If the ignition is switched off with the wind-
screen wipers active, they compl et

e their
wipe before returning to the rest position.
When switching the ignition back on, the
windscreen wiper will continue to operate
at the same wiping level. Ice, snow and oth- er obstacles on the windscreen may dam-
age the wiper and the windscreen wiper
motor.

Operation
Seats and headrests
Adjusting seats R el
at ed video Fig. 123
Vehicle interior Manual adjustment of the front
seats
Fig. 124
Front seats: manual seat settings. Forwards/backwards: pull the lever and
mo
v
e the seat. The seat must engage
when the l e
v
er is released!
Raise/lower: pull the lever up or push
down (several times if necessary) from its
home position.
Tilting the backrest: turn the hand wheel.
Lumbar support: move the lever until the
required position is achieved. WARNING
Incorrect seat adjustment may lead to ac-
cidents and severe injuries.

Seats and headrests
Seat up/down: Press the rear part of the
butt on up/do
wn. To adjust the angl
e of
the seat cushion, pr
ess the front of the
button up/down.
Backrest further upright/further reclined:
press the button forwards/backwards. WARNING

Operation
and the brackets of the roof railings B must
be 15 cm. WARNING
Incorrect attachment and use of the cross-
bars and the roof carrier system may cause the whole syst em t
o detach from the roof
and cause an accident and injuries.

Transport and practical equipment
LED on the power socket
Flashing green
light: The ignition is switched off, but
there is enough power av
ail
able
to continue supplying the socket
with current for a maximum of 10
minutes. If the connector is un-
plugged before this time elap-
ses, the socket is disconnected
and cannot be used again until
the ignition is switched on again.
Flashing red
light: There is an anomaly, e.g. dis-
connection due to a current
surge or o
v

erheating. Disconnection due to overheating
When the t
emper
atur
e e

xceeds a certain val-
ue, the 230 volt socket inverter is automati-
cally disconnected. The disconnection pre-
vents overheating when the power consump-
tion of the connected devices is excessive or
the ambient temperature is very high. The
230-volt power supply can be used once
again after a cooling time. First unplug the
connector of the connected device and then
plug it back in again. This prevents the elec-
trical device from being switched on again if
this is not wanted. WARNING
The electrical system is under high voltage!