2020 Seat Arona battery

Emergencies
Connect the other end of the black
jump
l ead X to a solid metal component bol-
t ed t
o the engine bl ock or t
o the engine
bl
ock itself of the vehicle with the flat
battery. Do not connect it to a point near
the battery A .
P osition the l
eads in such a w ay that
they cannot come int o cont

act with any
moving parts in the engine compart-
ment.
Starting Start the engine of the vehicle with the
boosting battery and let it run at idling
speed.
Start the engine of the vehicle with the
flat battery and wait for 2 or 3 minutes
until the engine is running.
Removing the jump leads Before you remove the jump leads,
switch off the dipped beam headlights if
they are switched on.
Turn on the heater blower and heated
rear window in the vehicle with the flat
battery. This helps minimise voltage
peaks which are generated when the
leads are disconnected.
When the engine is running, disconnect
the leads in reverse order to the details
given above.
5.
6.
7.
8.
9.
10.
11.
Make sure the battery clamps have sufficient
metal-to-metal cont

act with the battery ter-
minals.
If the engine fails to start after about 10 sec-
onds, switch off the starter and try again after
about 1 minute. WARNING

Emergencies
No. Consumer/Amps
10 Vref Battery: Gateway, BDM and
BCM 7.5
12 Detachable compressor 10
14 Injection Module, Engine Hauptre-
lay, ESC / ABS, Relay Coil 87 7.5
15 Aut
omatic gearbo
x DQ200 and
AQ160 30
17 50 Diag 7.5
18 BDM starter motor 30
20 ESC (Pump)
60
ABS (Pump) 40
21 ESC/ABS (Valves) 25
24 TH4 Electric fan without A/C for
moder
ate climate countries 30
25 TH4 f
an with A/C or T5I f

or moder-
ate climate countries 20
PTC1 40
26 T

J1/TJ4/TJ7/T6P or TH4/T5I Electric
fan for warm climate countries 50
27 TH4 f

an with A/C or T5I for moder-
ate climate countries 30
PT C2 40
28

PTC3 40 Note

Operation

Fault in the battery

Opening and closing
Changing the battery

Opening and closing
For the automatic lowering function: pull
the butt on f
or the corr esponding windo
w up-
w
ards until it reaches the second position.
Stop automatic movement: push or pull on
the button of the corresponding window.
Resetting one-touch opening and closing
The one-touch opening and closing function
is not active after the vehicle battery has
been disconnected or is flat and will have to
be reset.

Operation
the air, the cooling system will automatically
s wit
ch on.
Heat ed r
ear windo
w 
This only works when the engine is running
and switches off automatically after a maxi-
mum of 10 minutes.
It should be switched off as soon as the glass
is demisted. By saving electrical power you
can also save fuel.
To avoid possible damage to the battery, an
automatic temporary disconnection of this
function is possible, coming back on when
normal operating conditions are re-establish-
ed.
Air recirculation 

Driving
approximately two minutes in neutral be-
fore swit
ching it off
.Note
After the engine is switched off the radiator
f an may run on for up to 10 minut es, e

ven if
the ignition is switched off. It is also possi-
ble that the fan turns itself on once more if
the coolant temperature increases due to
the heat accumulated in the engine com-
partment or due to its prolonged exposure
to solar radiation. Electronic immobilizer
The electronic immobiliser prevents unau-
thorised persons fr
om driving the v
ehicle
.
Inside the k

ey there is a chip that deactivates
the electronic immobiliser automatically
when the key is inserted into the ignition.
The electronic immobiliser will be activated
again automatically as soon as you pull the
key out of the ignition lock. For vehicles with
the “Keyless Access” system, the key has to
be outside the vehicle.
If the following message is shown on the in-
strument panel display: SAFE , the vehicle
cannot be started.
The engine can only be started using a genu-
ine SEAT key with its correct code. Note
A perfect operation of the vehicle is ensur-
ed if genuine SEAT keys are used. Emergency starting function
Fig. 210
On the right of the steering column:
emer gency st art. If no valid key is detected inside the vehicle,
an emer
gency st
art-up will be r
equir

ed. The
relevant message will appear in the dash
panel display. This may happen when, for ex-
ample, the vehicle key battery is very low:

Driving
Manual release of the selector lev-
er Fig. 217
Gear selector lever: manual release
fr om the parking position. In the event of a power failure when starting
(e
.g. dischar
ged battery), the l
e
ver will remain
locked in position P. To move it to position N to
move the vehicle, there is an emergency re-
lease device under the centre console, on the
right side. Releasing the selector lever re-
quires a certain degree of practical skill.
Removing the cover from the selector lev-
er