Page 491 of 609

Proportion of antifreeze concentrate in
the
engine cooling sy stem:
R a minimum of 50% (antifreeze pr otection
down toappr oximately -37°C)
R a maximum of 55% (antifreeze pr otection
down to-45°C) Note
s on windscreen washer fluid Obser
vethe no tes on operating fluids
(/ page 480). &
WARNING ‑ Risk of fire and injury due to
windscreen washer concentrate
Wi ndsc reen washer concentrate is highly
fl ammable. It could ignite if it comes into
con tact wi thhot engine component parts or
th eex haust sy stem. #
Make sure that no windsc reen washer
concentrate spills out next tothefiller
opening. *
NO
TEDama getotheex terior lighting
due tounsuitable windsc reen washer
fl uid Uns
uitable windsc reen washer fluids may
damage the plastic sur face of theex terior
lighting. #
Only use windscreen washer fluids
which are also suitable for use on plas‐
tic sur faces, e.g. MB SummerFit or MB
Wi nterFit. *
NO
TEBlocked spr aynozzles caused by
mixing windscreen washer fluids #
Do not mix MB SummerFit and MB Win‐
te rFit with other windscreen washer flu‐
ids. Do not use distilled or de-ionised
water.Other‐
wise, thefill le vel sensor may be triggered er ro‐
neously.
Re commended windscreen washer fluid:
R abo vefreezing point: e.g. MB SummerFit
R below freezing point: e.g. MB WinterFit Fo
rth e cor rect mixing ratio, referto the informa‐
tion on the antif reeze conta iner.
Mix washer fluid with windsc reen washer fluid all
ye ar round. Ve
hicle data Ve
hicle dimensions The heights speci
fied may vary as a result of the
fo llowing factors:
R tyres
R load
R condition of the suspension
R optional equipment 488
Tech nical da ta
Page 492 of 609

Height when opened
Model
1
1Height
when
opened
All model s1 855 mm Ve
hicle dimensions All models
Ve
hicle lengt h5 179 mm
Ve hicle width including out‐
side mir rors 21
09 mm
Ve hicle width excluding out‐
side mir rors 19
54 mm
Ve hicle height 1503 mm
Wheelbase 3106 mm We
ights and loads Please no
tethefo llowing forth e specified vehi‐
cle data:
R Items of optional equipment increase the
unladen weight and reduce the pa yload.
R Vehicle-specific weight information can be
fo und on theve hicle identification plate
(/ page 478). Missing
values werenot available at the time of
going topress. Model
Maximumroof load
All models Tr
ailer hitch Gene
ral no tes on the trailer hit ch Modifications
tothe engine cooling sy stem may
be necessar y,depending on theve hicle model.
The retrofitting of a trailer hitch is only pe rmissi‐
ble if a towing capacity is specified in your vehi‐
cle documents.
Fu rther information can be obtained at a quali‐
fi ed specialist workshop. Te
ch nical da ta489
Page 500 of 609
Display messages
Possible causes/consequences and M
MSolutions
Á Key not detected (red dis‐
play message) *T
hekey cannot be de tected and may no longer be in theve hicle.
The key is no lon ger in theve hicle and you swit choff the engine:
R You can no lon gerst art the engine.
R You cannot centrally lock theve hicle. #
Ensure that theke y is in theve hicle.
If th eke y de tection function has a malfunction due toast ro ng radio signal source: #
Stop theve hicle immediately in accordance with the traf fic conditions. #
Place theke y in the slot forst arting the engine with theke y (/ page189).
Place the key in the
marked space See Owner's
Manual *K
eydetection is malfunctioning. #
Change the location of theke y in theve hicle. #
Place theke y in the slot forst arting the engine with theke y (/ page189). Displ
aymessa ges and warning/indicator lamps 497
Page 503 of 609

Display messages
Possible causes/consequences and M
MSolutions #
Consult a qualified specialist workshop.
Check dipped-beam set-
ting (left/right-side traffic) *T
he type of traf fic has been selected manual ly. #
Check the setting and change it manually if necessary (/ page161).
Dipped-beam setting (left/
right-side traffic) Manual
adjustment only *T
he automatic headlamp conversion for left-hand/right-hand traf fic has malfunctioned. #
Change the headlamps over manually (/ page161).
Adaptive Highbeam Assist
Plus currently unavailable
See Owner's Manual *A
daptive Highbeam Assist Plus is temp orarily una vailable.
Once the cause of the problem is no longer present, the sy stem will be available again. The Adaptive Highbeam
Assist Plus available again display message will appear. #
Drive on. #
Operate the high beam manually until Adaptive High Beam Assist Plus is available again.
Adaptive Highbeam Assist
Plus inoperative *A
daptive Highbeam Assist Plus is malfunctioning. #
Stop theve hicle in accordance with the tra ffic conditions and restart the engine. #
Ifth e display message still appears, consult a qualified specialist workshop.
Hazard warning lamp sys-
tem Malfunction *T
he hazard warning lamp switch is malfunctioning. #
Consult a qualified specialist workshop. 500
Display messages and warning/indicator lamps
Page 504 of 609
Climate control
Displ
aymessages
Possible causes/consequences and M
MSolutions
& inoperative See Owner's
Man. *T
hestationary heater is temp orarily malfunctioning. #
When theve hicle is stationary on a le vel sur face and the engine has cooled down, make up tofour attem ptsto
switch on thest ationary heater, waiting se veral minutes between each attem pt. #
Ifth est ationary heater does not swit chon, consult a qualified specialist workshop.
% The stationary heater cannot be activated if the outside temp erature is abo ve15°C.
& inoperative Battery low *T
he on-board electrical sy stem voltage is too lo w.
The stationary heater has swit ched itself off. #
Drive an extended di stance until the battery has reached a suf ficient charge leve l again.
&
Inoperative Refuel vehicle *T
here is too little fuel in the fuel tank. The stationary heater cannot be swit ched on. #
Refuel theve hicle. Display messages and
warning/indicator lamps 501
Page 505 of 609

Ve
hicle Display messages
Possible causes/consequences and M
MSolutions *T
he driver display is inoperative due toafa iled software update.
The display message is shown everytime the engine is star ted. &
WARNING Risk of accident due toa driver display malfunction
If th e driver display has failed or malfunctioned, the function restrictions applying tosaf etyre leva nt sy stems are
not visible.
The operating saf ety of your vehicle may be impaired. #
Drive on carefull y. #
Have theve hicle checked immediately at a qualified specialist workshop. If
th e operating saf ety of your vehicle is impaired, park theve hicle immediately and safely. Contact a qualified spe‐
cialist workshop.
If th e driver display fails, you may not recognise function restrictions af fecting sy stems releva nt tosaf ety or the
speed displa y,forex ample. The operating saf ety of theve hicle may be impaired (/ page312). #
Have theve hicle checkedby aqu alified specialist workshop immediatel y.502
Display messages and warning/indicator lamps
Page 509 of 609

Display messages
Possible causes/consequences and M
MSolutions
Ù Steering malfunction Stop
immediately See Owner's
Manual *T
hesteering is malfunctioning. Steering capability is significant lyimpaired. &
WARNING Risk of accident if steering capability is impaired
If th esteering does not function as intended, theve hicle's operating saf ety is jeopardised. #
Pull over and stop theve hicle safely as soon as possible, paying attention toroad and traf fic conditions.
Do not continue driving under any circums tances. #
Consult a qualified specialist workshop. Ù
Rear axle steering cur-
rently malfunctioning *T
herear axle steering is temp orarily una vailable. The turning circle may become wider. #
Stop theve hicle in accordance with the tra ffic conditions and restart the engine.
If th e display message does not disappear: #
Drive on carefull y. #
Consult a qualified specialist workshop.
Ù Rear axle steering Malfunc-
tion Visit workshop *T
herear axle steering is malfunctioning.
The rear axle has no steering capability.
The steering wheel may be tilted when you drive in a stra ight line. #
Adapt your speed and drive on carefull y. #
Consult a qualified specialist workshop immediatel y.506
Display messages and warning/indicator lamps
Page 511 of 609
Display messages
Possible causes/consequences and M
MSolutions
C *A
t least one door is open. #
Close all doors.
M *T
he bonnet is open. &
WARNING Risk of accident due todriving with the bonn etunlo cked
The bonn etmay open and block your vie w. #
Neverre lease the bonn etwhen driving. #
Before every trip, ensure that the engine bonn etis loc ked. #
Stop theve hicle immediately, paying attention toroad and traf fic conditions. #
Close the bonn et.
N *T
he boot lid is open. &
DANG ER Risk of exhaust gas poisoning
Combustion engines emit poisonous exhaust gases such as carbon monoxide. Exhaust gases can enter the
ve hicle interior if the boot lid is open when the engine is running, especially if theve hicle is in motion. #
Alw ays switch off the engine before opening the boot lid. #
Never drive with the boot lid open. 508
Display messages and warning/indicator lamps