Switching
the interior lighting switch-off
delay time on/off Multimedia sy
stem:
4 © 5
Settings 5
Lights
5 Int. light. del. sw. off #
Switch the switch-off delay time on or off.
When this function is active, the interior light‐
ing lights up for a short time af terth eve hicle
is loc ked. Wi
ndscreen wipers and windscreen washer
sy stem Switching
the windscreen wipers on/off 1
gWindsc reen wipers off
2 Ä Intermittent wiping, normal
3 Å Intermittent wiping, frequent 4
° Continuous wiping, slow
5 ¯ Continuous wiping, fast #
Turn the combination switch tothe cor re‐
sponding position 1-5. #
Single wipe/washing: pushthe button on
th e combination switch in the direction of
ar row 1.
R í Single wipe
R î Wiping with washer fluid Re
placing the windsc reen wiper blades &
WARNING Risk of becoming trapped if
th e windscreen wipers are switched on
while wiper blades are being replaced
If th e windscreen wipers begin tomo vewhile
yo u are changing the wiper blades, you can
be trapped bythe wiper arm. #
Alw ays switch off the windscreen wip‐
ers and ignition before changing the
wiper blades. 13 2
Light and sight
Moving
the wiper arms into there placement
position #
Switch the ignition on and switch off again
immediatel y. #
Within around 15seconds, press and hold
th eî button on the combination switch
fo r appro ximately thre e seconds
(/ page 132).
The wiper arms will mo veinto there place‐
ment position.
Re moving the wiper blades #
Foldthe wiper arms away from the wind‐
screen. #
Hold the wiper arm with one hand. With the
ot her hand, turn the wiper blade in the direc‐
tion of ar row1away from the wiper arm as
fa r as it will go. #
Slide catch 2inthe direction of ar row 3
until it engages in there mo val position. #
Remo vethe wiper blade from the wiper arm
in the direction of ar row4. Fi
tting the wiper blades #
Inse rtthe new wiper blade into the wiper
arm in the direction of ar row1. #
Slide catch 2inthe direction of ar row 3
until it engages in the locking position. #
Make sure that the wiper blade is seated cor‐
re ctly. Light and sight
13 3
#
Foldthe wiper arms back onto the wind‐
screen. #
Switch on the ignition. #
Press theî button on the combination
switch.
The wiper arms will mo veinto the original
position. #
Switch the ignition off.
Maintenance display
The maintenance display is available on lywith
st andard windsc reen wipers. #
Remo veprotective film 1 from the mainte‐
nance display on the tip of the newly fitted
wiper blades.
When the colour of the maintenance display
ch anges from black to yellow, the wiper blades
should be replaced.
% The duration until the colour changes varies
depending on the usage conditions. Re
placing the windsc reen wiper blades
(MAGIC VISION CONT ROL) Moving
the wiper arms tothere placement
position #
Switch the ignition on and switch off again
immediatel y. #
Within around 15seconds, press and hold
th eî button on the combination switch
fo r appro ximately 3 seconds (/ page132).
The wiper arms will mo veinto there place‐
ment position. 134
Light and sight
Re
moving the wiper blades #
Tobring the wiper blade into position to
be remo ved: raise the wiper arm away from
th e windscreen and hold it with one hand.
Wi th th eot her hand, turn the wiper blade in
th e direction of ar row1beyond the point of
re sis tance.
The wiper blade will engage in there mo val
position with a clic k. #
Toremo vethe wiper blade: pressrelease
knob 2, pull the wiper blade in the direction
of ar row3and remo ve.
Fi tting the wiper blades #
Push the new wiper blade onto the wiper arm
in the direction of ar row1until release
knob 2engages. #
Press the wiper blade be yond the point of
re sis tance in the direction of ar row3on
th e wiper arm.
The wiper blade will engage with a noticeable
click and mo vefreely again. #
Foldthe wiper arm back onto the wind‐
screen. #
Switch on the ignition. #
Press button îonthe combination
switch (/ page132).
The wiper arms will mo veinto the original
position. Light and sight
13 5
#
Clean the net of thefo lding draught stop with
a damp clo thin conjunction with the care
products and cleaning agents recommended
and appr ovedby Mercedes-Benz. Note
s on care of car parts &
WARNING Risk of entrapment if the
windscreen wipers are swit ched on while
th e windscreen is being cleaned
If th e windscreen wipers are set in motion
while you are cleaning the windscreen or
wiper blades, you can be trapped bythe
wiper arm. #
Alw ays switch off the windscreen wip‐
ers and the ignition before cleaning the
windscreen or wiper blades. &
WARNING Risk of bu rns from theta il‐
pipe and tailpipe trims
The exhaust tailpipe and tailpipe trims can
become very hot. If you come into contact with
these parts of theve hicle, you could
burn yourself. #
Alw ays be particular lycareful around
th eta ilpipe and theta ilpipe trims and
supervise children especially closely in
th is area. #
Allow vehicle parts tocool down before
to uching them. To
avo id damage totheve hicle, obser vethe
no tes on cleaning and care of thefo llowing vehi‐
cle parts.
Wheels and rims
R Use wate r and acid-free wheel cleaners.
R Do not use acidic wheel cleaners toremo ve
brake dust. This could damage wheel bolts
and brake components.
R Toavo id cor rosion of the brake discs and
brake pads, drive theve hicle for a few
minutes af ter cleaning before parking it. The
brake discs and brake pads warm up and dry
out. Wi
ndo ws
R Clean wind owsinside and outside with a
damp clo thand with a cleaning agent recom‐
mended for Mercedes-Benz.
R Do not use dry clo ths or abrasive or solvent-
based cleaning agents toclean the inside of
windo ws.
Wi per blades
R Fold out the wiper blades and clean them
using a damp clo th.
R Do not clean the wiper blades too of ten.
Ex terior lighting
R Clean the lenses with a wet sponge and mild
cleaning agent, e.g. car sha mpoo.
R Only use cleaning agents or cleaning clo ths
th at are suitable for plast ic lenses.
Sensors
R Clean the sensors in the front and rear
bumpers with a soft clo thand car shampoo
(/ page 181).
R When using a high -pressure cleaner,maintain
a minimum dis tance of 30 cm. Maintenance and care
301
Wheel
change
Fitting a new wheel ............................ .338
Lo we ring theve hicle ........................... 339
Preparation ......................................... 335
Ra ising theve hicle .............................. 335
Re moving a wheel .............................. .338
Re moving/fitting hub caps .................. 335
Wheel change
see Emer gency spa rewheel
Wheel rotation ........................................ .333
Wheels Care ..................................................... 301
Changing hub caps .............................. 335
Checking ............................................. 325
Checking the tyre pressure (tyre
pressure monitoring sy stem) ............... 328
Fitting .................................................. 338
Flat tyre ............................................... 306
Inter changing ...................................... 333
MOExtended tyres .............................. .306
Noise ................................................... 325
No tes on fitting ................................... 330
Re moving ............................................ 338
Re placing .................................... 330, 335 Re
starting the tyre pressure loss
wa rning sy stem ................................... 330
Re starting the tyre pressure monitor‐
ing sy stem ...........................................3 29
Selection ............................................. 330
Snow chains ........................................ 325
St oring ................................................ 334
TIREFIT kit ...........................................3 08
Ty re pressure (N otes) .......................... 326
Ty re pressure loss warning sy stem
(function) ............................................. 329
Ty re pressure monitoring sy stem
(function) ............................................. 328
Ty re pressure table .............................. 327
Un usual handling characteristics ........ 325
Wi -Fi
Setting ................................................ .255
Wi nd deflector
Care ....................................................2 99
Wi ndo ws
Closing (all) .......................................... .88
Opening (all) .......................................... 88
Wi ndo ws
see Side windo ws Wi
ndo ws(care) ........................................ 301
Wi ndscreen ...................................... 134, 13 9
Demi sting ............................................ 13 9
Re placing wiper blades (MAGIC
VISION CONTROL) ............................... 13 4
Wi ndscreen
see Windsc reen
see Windshield
Wi ndscreen washer fluid ........................ 354
No tes ................................................... 354
Wi ndscreen washer sy stem
To pping up ...........................................2 94
Wi ndscreen wipers
Changing the wiper blades .................. 13 2
Re placing wiper blades (MAGIC
VISION CONTROL) ............................... 13 4
Switching on/off ................................. 13 2
Wi ndshield ............................................... 13 2
Changing the wiper blades .................. 13 2
Wi nter operation
Snow chains ........................................ 325
Wi nter tyres
Setting the permanent speed limit .......1 94 Index
461