773
Maintenance
Fuse NameFuse ratingCircuit Protected
PASSENGER SEATHEAT20APassenger CCS (Climate Control Seat) Module, Passenger Seat Warmer Control Module
DRIVER SEAT HEAT20ADriver CCS (Climate Control Seat) Module, Driver Seat Warmer Control Module
REAR LH SEAT HEAT20ARear Seat CCS (Climate Control Seat) Module Left Handle side, Rear Seat Warmer Control Module
Left Handle side
POWER DOOR RR LH15ARear Power Door Latch Left Handle side
REAR RH SEAT HEAT20ARear Seat CCS (Climate Control Seat) Module Right Handle side, Rear Seat Warmer Control Module
Right Handle side
REAR RH
POWER SEAT215ARear Seat Relay Module Right Handle side
POWER DOOR PAS- SENGER15APassenger Power Door Latch
ECS15AECS (Electronic Control Suspension) Unit
HEATED
INDICATOR10AFront Air Conditioner Controller
REAR LH
POWER SEAT315ARear Seat Lumbar Support Unit Left Handle side
AMP25AAMP (Amplifier) (Premium/Premium High)
POWER TRUNK20APower Trunk Module
Rear fuse box panel
Maintenance
78
7
✽ ✽
NOTICE
• If the light bulb or lamp connector
is removed while the lamp is still
on, the fuse box's electronic sys-
tem may log it as a malfunction.
Therefore, a lamp malfunction
incident may be recorded as a
Diagnostic Trouble Code (DTC) in
the fuse box.
• It is normal for an operating lamp to flicker momentarily. This is due
to a stabilization function of the
vehicle’s electronic control device.
If the lamp lights up normally
after momentarily blinking, then
it is functioning as normal.
However, if the lamp continues to
flicker several times or turns off
completely, there may be an error
in the vehicle’s electronic control
device. Please have the vehicle
checked by an authorized K900
Kia dealer immediately.
✽ ✽ NOTICE
We recommend that the headlight
aiming be adjusted after an accident
or after the headlight assembly is rein-
stalled at an authorized K900 Kia
dealer.
✽ ✽NOTICE
You can find moisture inside the lens
of lamps after a car wash or driving
in the rain. It is a natural event
caused by the temperature differ-
ence between the inside and the out-
side of the lamp and does not mean a
problem with its functions. The
moisture inside the lamp would dis-
appear if you drive the vehicle with
the headlamp turned on, however,
the level at which the moisture is
removed may differ depending on
the size/location/condition of the
lamp. If the moisture continues to
stay inside the lamp, have the vehicle
checked by an authorized K900 Kia
dealer.
If you don’t have the necessary tools,
the correct bulbs and the expertise,
consult an authorized K900 Kia deal-
er. In many cases, it is difficult to
replace vehicle light bulbs because
other parts of the vehicle must be
removed before you can get to the
bulb. This is especially true if you
have to remove the headlamp
assembly to get to the bulb(s).
Removing/installing the headlamp
assembly can result in damage to
the vehicle.
If non-genuine parts or substandard
bulbs are used, it may lead to blow-
ing a fuse or other wiring damages.
Do not install extra lamps or LEDs to
the vehicle. If additional lights are
installed, it may lead to lamp mal-
functions and flickering. Additionally,
the fuse box and other wiring may be
damaged.
