2020 KIA K900 mirror

CENTER PANEL
40
Automatic Transmission (Shift by Wire)
Quick Tips
§ Press the Unlock button A when shifting from P (Park) to any gear
§ The instrument cluster and the light on top of the shift lever identifies the gear the vehicle is currently in
REMINDERS:
§
When in P (Park), if the Unlock button is not pressed while shifting, the transmission does not shift
§
If the vehicle is turned off while in Neutral without shifting into Park, it will remain in Neutral until the driver’s door is opened. At that point it will automatically shift into Park
§
If going through a car wash, remind the attendant to keep the vehicle in Neutral (N) and keep the engine running. Also, disable the power Trunk lid control, turn off the auto rain sensing wipers and fold in the mirrors
To shift into any gear from Park, depress the brake pedal,
then press the Unlock button A, located on the side of the
gear shift lever, and shift.
P: Park – To shift into Park from any gear, press the P button B on the gear shift while vehicle is stationary and the brake
pedal is depressed (Shift by Wire only).
R: Reverse – To shift into Reverse, depress brake pedal,
press the Unlock button A, and move the shift lever forward
twice to skip over Neutral and into Reverse.
N: Neutral
D: Drive
Paddle Shifters (Manual Mode): Paddle Shifters are
operable when the shift lever C is moved into the left gate
of the D position (Manual mode).
Paddle Shifting: Pull the [+] or [-] paddle shifter once to shift
up or down one gear.
REMINDERS:
§ Press and hold the [+} right paddle shifter to return to Automatic mode
§ When in Manual mode, pulling the left and right paddle shifters at the same time will NOT shift gears
A
B
C
C
For illustrative purposes only. Your actual display, buttons and/or features may vary.

S E AT I N G
Driver Position Memory System
The integrated system stores into memory the position of
the driver’s seat, outside rearview mirrors, and steering
wheel positions. To store positions into memory, first place
the gear shift into P (Park) while the Engine Start /Stop
button is in the ON position. Then:
1.
Adjust the driver’s seat, outside rearview mirrors,
settings and steering wheel positions
2.
Press the SET button B on the control panel. System
will beep once
3.
Press one of the memory buttons 1, 2 or 3 C within
4 seconds. The system will beep twice when memory
has been stored
1
2 31
2 3
(Located on driver

OTHER KEY FEATURES
49ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPERATING INFORMATION AND SAFETY WARNINGS.†LEG AL DISCL AIMERS ON BACK INSIDE COVER
ABC
Auto-Dimming Rearview Mirror
The Auto-Dimming Rearview Mirror is designed to help reduce
glare from a vehicle’s headlights located in the rear and also
connect up to three electronic transmitters in one location.
REMINDER: Mirror indicator light will illuminate when automatic dimming is ON.
HomeLink® Setup - How to Sync Transmitter
If programming for the first time, begin with Step 1 (repeating this step will delete all information).
To program non-rolling and rolling code garage door openers and other devices:
1. Press and hold the A and C buttons simultaneously until the indicator light begins
to flash (to reprogram buttons, skip this step)
2. Press and hold the desired button A, B or C and hold the button on the transmitter while it is
approximately 1 to 3 inches away from the mirror. The HomeLink® Indicator light will flash
rapidly once the frequency signal has been successfully programmed
To finish programming rolling code garage door openers, complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s motor head unit. Press and release the button
and complete Step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink® button up to three times
5. Press and release the Homelink button just programmed. The Homelink indicator on the mirror will
illuminate
6. To program the remaining two Homelink buttons, follow
steps 1-4 for other Rolling Code devices, or steps 2-5 to
program standard devices
For some older garage doors, see Owner’s Manual for information on how to do Two-Way Communication Programming.
Operating HomeLink®:
Press one of the programmed HomeLink® buttons.
Erasing programmed buttons:
Press and hold the A and C buttons simultaneously for
approximately 20 seconds, and then release both buttons
within 30 seconds.
HomeLink® with Auto-Dimming Rearview Mirror† 13
A HomeLink® button
B HomeLink® button
C HomeLink® button
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink® system, you may need to purchase a HomeLink Repeater Kit. For more information, go to www.HomeLink.com or call (800) 355-3515.
For illustration purposes only. Your system buttons may vary. See the Owner’s Manual for more information.
Quick Tips
§ You can reprogram a single HomeLink® button by repeating Step 2
§ Erasing programmed buttons will delete all trained transmitters
HOMELINK REARVIEW MIRROR SETUP VIDEO
To view a video on your mobile device, snap this QR Code or visit the listed website. Refer to page 2 for more information.www.youtube.com/KiaFeatureVideos

OTHER KEY FEATURES
51
Smart Power Trunk (Continued)
Opening with no-touch activation:
When the Smart Key fob is on your person and you are near
the back of the vehicle, within close proximity, the hazard
lights will blink and a chime will sound for about 3 seconds as
an alert that the Smart Power Trunk is about to open.
Then the alert system will blink and chime two additional
times before opening the Smart Power Trunk.
The Smart Power Trunk feature is OFF by default. To enable
the Smart Power Trunk, go to Vehicle Settings in the audio
head unit and select Door/ Trunk.
Smart Key:
To open the Smart Power Trunk, press and hold the
Smart Key Trunk button D until the Trunk begins opening.
Press again and hold to close.
KIA KEY FOB VIDEO
To view a video on your mobile device, snap this QR Code or visit the listed website. Refer to page 2 for more information.
Quick Tips
§ The Trunk must be unlocked before it can be opened by the Trunk Release button
§ The Trunk unlocks automatically and then can be opened manually when the Smart Key is within close proximity to the vehicle
REMINDERS:
§
Smart Power Trunk may be damaged if attempting to open or close manually
§ When not in use, keep the Trunk Lid Control button in the OFF position
§ If going through a car wash, remind the attendant to keep the vehicle in Neutral (N) and keep the engine running. Also, disable the Smart Power Trunk lid control using the button inside the glove compartment, turn off the auto rain-sensing wipers and fold in the mirrors
§ Ensure all obstacles are out of the way of the Trunk lid when operating the Smart Power Trunk
D
www.youtube.com/KiaFeatureVideos
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPERATING INFORMATION AND SAFETY WARNINGS.

Sales Consultant:
Sales Manager:
Customer:
Date:
Date:
Date:
K900 CUSTOMER DELIVERY CHECKLIST
Smart Cruise Control (SCC)
with Stop & Go – page 26 Demonstrate operation
Key Feature Walkthrough
During Delivery
Multimedia USB Port, Power Outlets & USB Charger Ports – page 35
Blind-Spot Collision-Avoidance Assist (BCA) – page 15
Clock Setup – page 35
Electric Parking Brake (EPB) / Auto Hold - pages 41-42
Engine S tar t / S top Button – page 22
Head-Up Display (HUD) – page 11
Sunroof Operation – page 53
Parking Distance Warning - Reverse/Forward – page 20
Passenger Air Bag Off Indicator – page 57
Front Seat Headrest Adjustment – page 46
Seat Warmers/ Ventilated Seats – page 44
Smart Key – page 48
Sunvisor – page 54
Tire Pressure Monitoring System ( TPMS) – page 7
Explain first service process and schedule first service appointment
Tour Parts & Service departments, introduce staff and explain value of Kia Parts and Service
Review recommended maintenance schedule and maintenance requirements to validate warranty
Review business hours
Review the Kia 10-year/100,000-mile warranty program
Ensure 100% satisfaction with sales and delivery process and no problems with the vehicle
Confirm time and best contact number for initial dealer follow-up
Bluetooth® Wireless
Technology – page 28 Demonstrate operation
HomeLink® with Auto-Dimming
Rearview Mirror – page 49

Windshield Wipers &
Washers – page 25
'30/5
MIST
OFF
AUTO LOHIAUTO
CRUISE
CANCEL
RES
OKSET
MODE