Page 296 of 378

Chassis
Component Fluid, Lubricant, or Genuine Part
Automatic Transmission We recommended you use TUTELA TRANSMISSION AS8 Fluid, or equivalent, meeting require-
ments of FCA Material Standard 9.55550-AV5 or MS.90030-A5. Failure to use the correct fluid
may affect the function or performance of your transmission.
Transfer Case – Single-Speed (Quadra-Trac I) We recommended you use TUTELA TRANSMISSION POWERGEAR 4 Fluid, or equivalent, meet-
ing requirements of FCA Material Standard MS-10216.
Transfer Case – Two-Speed (Quadra-Trac II) We recommended you use TUTELA TRANSMISSION FORCE 4 Fluid, or equivalent, meeting re-
quirements of FCA Material Standard 9.55550-AV4 or MS-9602 (ATF+4).
Axle Differential (Front) We recommend you use TUTELA TRANSMISSION MULTIAXLE or equivalent, SAE 75W-85 (API-
GL5).
Axle Differential (Rear) – With Electronic
Limited-Slip Differential (ELSD)We recommend you use TRANSMISSION AXLE-DRIVE with friction modifier, or equivalent, SAE
75W-85 (API-GL5).
Axle Differential (Rear) – Without Electronic
Limited-Slip Differential (ELSD)We recommend you use TUTELA TRANSMISSION MULTIAXLE or equivalent, SAE 75W-85 (API-
GL5).
Brake Master Cylinder We recommend you use DOT 3, SAE J1703 brake fluid. If DOT 3 brake fluid is not available
then TUTELA TOP4/S, FMVSS no. 116 DOT 4, ISO 4925 SAE J1704, or equivalent, is accept-
able.
DOT 4 Brake fluid must be replaced every 24 months regardless of mileage.
TECHNICAL SPECIFICATIONS
294
Page 298 of 378

CAUTION!
• Mixing of engine coolant (antifreeze)
other than specified Organic Additive
Technology (OAT) engine coolant (anti-
freeze), may result in engine damage
and may decrease corrosion protection.
Organic Additive Technology (OAT) en-
gine coolant is different and should not
be mixed with Hybrid Organic Additive
Technology (HOAT) engine coolant (an-
tifreeze) or any “globally compatible”
coolant (antifreeze). If a non-OAT engine
coolant (antifreeze) is introduced into
the cooling system in an emergency, the
cooling system will need to be drained,
flushed, and refilled with fresh OAT
coolant (conforming to MS.90032), by
an authorized dealer as soon as possible.
• Do not use water alone or alcohol-based
engine coolant (antifreeze) products. Do
not use additional rust inhibitors or an-
tirust products, as they may not be com-
patible with the radiator engine coolant
and may plug the radiator.
CAUTION!
• This vehicle has not been designed for
use with propylene glycol-based engine
coolant (antifreeze). Use of propylene
glycol-based engine coolant (antifreeze)
is not recommended.
• The use of products with different speci-
fications than those indicated above
could cause damage to the engine that
is not covered by the warranty.
• Use AdBlue
®only according to DIN
70 070 and ISO 22241-1. Other fluids
may cause damage to the system: also
exhaust emissions would no longer com-
ply with the law.
• The distribution companies are respon-
sible for the compliance of their prod-
uct. Observe the precautions of storage
and servicing, in order to preserve the
initial qualities. The manufacturer of the
vehicle does not recognize any guaran-
tee in case of malfunctions and damage
caused to the vehicle due to the use of
AdBlue
®not in accordance with
regulations.
TECHNICAL SPECIFICATIONS
296
Page 300 of 378

FUEL CONSUMPTION AND
CO
2EMISSIONS
The fuel consumption and CO2emission fig-
ures declared by the manufacturer are deter-
mined on the basis of the type-approval tests
laid down by the applicable standards in the
country where the vehicle is registered.
The type of route, traffic conditions, weather
conditions, driving style, general condition of
the vehicle, trim level/equipment/ accesso-
ries, use of the climate control system, ve-
hicle load, presence of roof racks and other
situations that adversely affect the aerody-
namics or wind resistance lead to different
fuel consumption values than those mea-
sured.The fuel consumption will only become more
regular after driving the first 1,864 miles
(3000 km).
To find the specific fuel consumption and
CO
2emission figures for this vehicle, please
refer to the data in the Certificate of Confor-
mity (if equipped), and the related documen-
tation that accompanies the vehicle (if
equipped).
MOPAR ACCESSORIES
Authentic Accessories By Mopar
In choosing Authentic Accessories you gain
far more than expressive style, premium pro-
tection, or extreme entertainment, you also
benefit from enhancing your vehicle with
accessories that have been thoroughly tested
and factory-approved.
The following highlights just some of the
many Authentic Jeep Accessories by Mopar
featuring a fit, finish, and functionality spe-
cifically for your Jeep Grand Cherokee.
TECHNICAL SPECIFICATIONS
298
Page:
< prev 1-8 9-16 17-24