SERVICING AND MAINTENANCE
SC \b \fED SERVICING
Your vehicle is equipped with an automatic oil
change indicator system. The oil change
indicator system will remind you that it is time to
take your vehicle in for scheduled maintenance.
Based on engine operation conditions, the oil
change indicator message will illuminate. This
means that service is required for your vehicle.
Operating conditions such as frequent
short-trips, trailer tow, or extremely hot or cold
ambient temperatures will influence when the
“Oil Change Required” message is displayed.
Severe Operating Conditions can cause the
change oil message to illuminate as early as 3,
500 miles (5,600 kmyf V L Q F H O D V W U H V H W + D Y H your vehicle serviced as soon as possible,
within the next 500 miles (805 kmyf . An authorized dealer will reset the oil change
indicator message after completing the
scheduled oil change. If a scheduled oil change
is performed by someone other than an
authorized dealer, the message can be reset by
referring to the steps described under
“Instrument Cluster Display” in “Getting to
Know Your Instrument Panel” for further
information.
NOTE:
Under no circumstances should oil change
intervals exceed 10,000 miles (16,000 kmyf
12 months or 350 hours of engine run time,
whichever comes first. The 350 hours of engine
run or idle time is generally only a concern for
fleet customers.
Severe Duty All Models
Change Engine Oil at 4,000 miles (6,500 kmyf R U
350 hours of engine run time if the vehicle is
operated in a dusty and off road environment or
is operated predominately at idle or only very
low engine RPM. This type of vehicle use is
considered Severe Duty.
At Every Fuel Stop:
Check engine oil level.
Check windshield washer fluid level.
Check tire pressure and look for unusual
wear or damage. Rotate tires at the first sign
of irregular wear, even if it occurs before the
oil indicator system turns on.
Check the fluid levels of the coolant reservoir
and brake master cylinder, fill as needed.
Check function of all interior and exterior
lights.
7
20_KL_OM_EN_USC_t.book Page 315
: $ 5 1 , 1 *
5 L G L Q J W K H E U D N H V F D Q O H D G W R E U D N H I D L O X U H
D Q G S R V V L E O \ D F R O O L V L R Q ' U L Y L Q J Z L W K \ R X U I R R W
U H V W L Q J R U U L G L Q J R Q W K H E U D N H S H G D O F D Q U H V X O W
L Q D E Q R U P D O O \ K L J K E U D N H W H P S H U D W X U H V
H [ F H V V L Y H O L Q L Q J Z H D U D Q G S R V V L E O H E U D N H
G D P D J H < R X Z R X O G Q R W K D Y H \ R X U I X O O E U D N L Q J
F D S D F L W \ L Q D Q H P H U J H Q F \
: $ 5 1 , 1 *
Use only manufacturer's recommended
brake fluid. Refer to “Fluids And Lubricants”
in “Technical Specifications” for further
information. Using the wrong type of brake
fluid can severely damage your brake
system and/or impair its performance. The
proper type of brake fluid for your vehicle is
also identified on the original factory
installed hydraulic master cylinder reservoir.
To avoid contamination from foreign matter
or moisture, use only new brake fluid or fluid
that has been in a tightly closed container.
Keep the master cylinder reservoir cap
secured at all times. Brake fluid in a open
container absorbs moisture from the air
resulting in a lower boiling point. This may
cause it to boil unexpectedly during hard or
prolonged braking, resulting in sudden
brake failure. This could result in a collision.
WARNING! (Continuedyf
