2020 HYUNDAI VELOSTER high beam

3-66
Convenient features of your vehicle
Turn By Turn (TBT) mode
This mode displays the state of the
navigation.
Assist mode (if equipped)
SCC/LKA/DAW
This mode displays the state of the
Smart Cruise Control (SCC), Lane
Keeping Assist (LKA) and Driver
Attention Warning (DAW).
For more details, refer to each
system in chapter 5.
Warning mode
If one of followings occurs, warning
messages will be displayed on the
LCD display for several seconds.
- Low washer fluid
- Exterior lamp malfunction
(if equipped)
- Blind-Spot Collision Warning
(BCW) system malfunction
(if equipped)
- High Beam Assist (HBA) malfunc-
tion (if equipped)
- Forward Collision-Avoidance
Assist (FCA) malfunction
(if equipped)
OJS048118NOPDE046147

7-69
7
Maintenance
[1] : High beam, [2] : Low beam
Headlamp
1. Open the hood.
2. Disconnect the negative battery
cable.
3. Remove the headlamp bulb cover
by turning it counterclockwise.
4. Disconnect the headlamp bulb
socket-connector.5. Remove the bulb from the head-
lamp assembly.
6. Install a new headlamp bulb and
snap the headlamp bulb retaining
wire into position by aligning the
wire with the groove on the bulb.
7. Connect the headlamp bulb sock-
et-connector.
8. Install the headlamp bulb cover by
turning it clockwise.
Information
The headlamp aiming should be
adjusted after an accident or after the
headlamp assembly is reinstalled at an
authorized HYUNDAI dealer.
Turn signal
1. Open the hood.
2. Disconnect the negative battery
cable.
3. Remove the socket (1) from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
4. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
iOJS078028OJS078027 ■High/Low beam

7-71
7
Maintenance
Always handle them carefully, and
avoid scratches and abrasions. If
the bulbs are lit, avoid contact with
liquids.
Never touch the glass with bare
hands. Residual oil may cause the
bulb to overheat and burst when lit.
A bulb should be operated only
when installed in a headlamp.
If a bulb becomes damaged or
cracked, replace it immediately
and carefully dispose of it.
Headlamp (Low beam), side mark-
er, position lamp and daytime run-
ning light
Your vehicle is equipped with LED
lamps. LED lamps do not have
replaceable bulbs. If the LED lamp
does not operate, have the vehicle
checked by an authorized HYUNDAI
dealer.
Headlamp (High beam)
1. Open the hood.
2. Disconnect the negative battery
cable.
3. Remove the headlamp bulb cover
by turning it counterclockwise.
4. Disconnect the headlamp bulb
socket-connector.
5. Remove the bulb from the head-
lamp assembly.
6. Install a new headlamp bulb and
snap the headlamp bulb retaining
wire into position by aligning the
wire with the groove on the bulb.
7. Connect the headlamp bulb sock-
et-connector.
OJS078029
Handle halogen bulbs with
care. Halogen bulbs contain
pressurized gas that will pro-
duce flying pieces of glass that
could cause injuries if broken.
Wear eye protection when
changing a bulb. Allow the
bulb to cool down before han-
dling it.
WARNING
OLMB073042L

I-5
Exterior Lights ................................................................3-81
AUTO light position...................................................3-81
Battery saver function ................................................3-87
Daytime running light (DRL) ....................................3-88
Headlamp delay function ...........................................3-87
Headlamp position......................................................3-82
High Beam Assist (HBA) ...........................................3-83
High beam operation ..................................................3-82
Lane change signals ...................................................3-86
Parking lamp position ................................................3-82
Turn signals ................................................................3-86
Exterior Overview.............................................................1-2
Floor Mat Anchor(s) .....................................................3-132
Forward Collision-Avoidance Assist (FCA) System
(Camera) ......................................................................5-64
FCA Sensor ................................................................5-68
FCA Warning Message and System Control..............5-66
Limitations of the System ..........................................5-71
System Malfunction ...................................................5-69
System Setting and Activation ...................................5-64
Forward Collision-Avoidance Assist (FCA) System
(Fusion Sensor) ............................................................5-76
FCA Sensor ................................................................5-80
FCA Warning Message and System Control..............5-78
Limitations of the System ..........................................5-83
System Malfunction ...................................................5-81
System Setting and Activation ...................................5-76Front Seats ........................................................................2-5
Driver seat folding lever...............................................2-8
Forward and rearward adjustment................................2-6
Lumbar support ............................................................2-7
Seat cushion height ......................................................2-7
Seatback angle ..............................................................2-6
Fuel Filler Door ..............................................................3-38
Fuses ...............................................................................7-52
Engine Compartment Panel Fuse Replacement .........7-54
Fuse/Relay Panel Description ....................................7-56
Instrument Panel Fuse Replacement ..........................7-53
Gauges and Meters .........................................................3-43
Glove Box .....................................................................3-124
Hazard Warning Flasher ...................................................6-2
Head Restraints ...............................................................2-10
Front seat head restraints ............................................2-11
Rear seat head restraints .............................................2-13
Head Up Display (HUD) ................................................3-78
Headlamp ........................................................................7-68
Heated Steering Wheel ...................................................3-23
High Mounted Stop Lamp Replacement ........................7-76
Hill-Start Assist Control (HAC) .....................................5-48
Hood................................................................................3-35
Horn ................................................................................3-22
I
Index
F
G
H