2020 HYUNDAI GENESIS G70 height adjustment

2-4
Safety system of your vehicle
SEATS
OIK037001N
Front seats
(1) Seat sliding forward or rearward
(2) Seat tilt/height adjustment
(3) Seat cushion length adjustment*
(4) Seatback angle adjustment
(5) Lumbar support adjustment*
(6) Seat bolster adjustment*
(7) Head restraint
(8) Seat warmer*
(9) Air ventilation seat*
(10) Front passenger seat adjustment*
Rear seats
(11) Seat warmer*
(12) Armrest
(13) Head restraint
* : if equipped

2-10
Safety system of your vehicle
Seat back bolster adjustment
(for driver's seat, if equipped)
1. Turn the adjustment switch clock-
wise, the right and left seatback
bolsters will be adjusted inward.
Turn the switch counterclockwise,
the seatback bolster will be adjust-
ed outward.
2. To adjust the bolster height to its
maximum in the default state,
operate the switch for approxi-
mately 8 seconds. After that,
release the switch because there
is no change in height even if you
continue to operate the switch.
3. Once adjustment is done, release
the switch.
Front passenger seat control
(if equipped)
The rear seat passenger may use
the switches to control the front pas-
senger seat.
• Sliding forward or rearward:
To move the front passenger seat
forward, press the switch (1). To
move the front passenger seat
rearward, press the switch (2).
• Angle adjustment:
To recline the front passenger seat
forward, press the switch (3).
To recline the front passenger seat
rearward, press the switch (4).
Seatback pocket
The seatback pocket is provided on
the back of the driver's and front pas-
senger's seatback.
To prevent the Occupant
Classification System from mal-
functioning:
Do not hang onto the driver's
and front passenger's seatback.
WARNING
OIK037020
OIK037065OIK037021

2-25
Safety system of your vehicle
2
If you are not able to smoothly pull
enough of the seat belt out from
the retractor, firmly pull the seat
belt out and release it. After
release, you will be able to pull the
seat belt out smoothly.
Height adjustment
You can adjust the height of the
shoulder belt anchor to one of the
three different positions for maximum
comfort and safety.
The shoulder portion should be
adjusted so it lies across your chest
and midway over your shoulder near-
est the door, not over your neck.To adjust the height of the seat belt
anchor, lower or raise the height
adjuster into an appropriate position.
To raise the height adjuster, pull it up
(1). To lower it, push it down (3) while
pressing the height adjuster button (2).
Release the button to lock the anchor
into position. Try sliding the height
adjuster to make sure that it has
locked into position.
To release your seat belt:
Press the release button (1) in the
locking buckle.
When it is released, the belt should
automatically draw back into the
retractor. If this does not happen,
check the belt to be sure it is not
twisted, then try again.
NOTICE
OIG036022OHSS038103