Page 2 of 671

Event Data Recorders
This vehicle is equipped with an event data recorder (EDR). 
The main purpose of an EDR is to  record, in certain crash or near 
crash-like situations, such as an air bag deployment or hitting a 
road obstacle, data that will assi st in understanding how a vehicle’s 
systems performed.  The EDR is designed to record data related 
to vehicle dynamics and safety systems for a short period of 
time, typically 30 seconds or le ss. The EDR in this vehicle is 
designed to record such data as:
• How various systems in your  vehicle were operating;
• Whether or not the driver and passenger safety belts were 
buckled/fastened;
3WARNING
California Proposition 65 Warning
Operating, servicing and maintaining a 
passenger vehicle or off-highway motor 
vehicle can expose you to chemicals including 
engine exhaust, carbon monoxide, 
phthalates, and lead, which are known to the 
State of California to cause cancer and birth 
defects or other reproductive harm. To 
minimize exposure, avoid breathing exhaust, 
do not idle the engine except as necessary, 
service your vehicle in a well-ventilated area 
and wear gloves or wash your hands 
frequently when servicing your vehicle. For 
more information go to 
www.P65Warnings.ca.gov/passenger-vehicle.
• How far (if at all) the driver was depressing the accelerator 
and/or brake pedal; and,
• How fast the vehicle was traveling.
These data can help provide a better understanding of the
circumstances in which crashes and injuries occur. NOTE: EDR data
are recorded by your vehicle only  if a non-trivial crash situation
occurs; no data are recorded by  the EDR under normal driving
conditions and no personal data (e.g., name, gender, age, and
crash location) are recorded. Howeve r, other parties, such as law
enforcement, could co mbine the EDR data with the type of
personally identifying data routinely acquired during a crash
investigation.
To read data recorded by an ED R, special equipment is required, 
and access to the vehicle or the  EDR is needed. In addition to the 
vehicle manufacturer, other parties,  such as law enforcement, that 
have the special equipment, can re ad the information if they have 
access to the vehicle or the EDR. 
The data belongs to the vehicle ow ner and may not be accessed by 
anyone else except as legally requ ired or with the permission of the 
vehicle owner.
Service Diagnostic Recorders
This vehicle is equipped with serv ice-related devices that record 
information about powertrain perform ance. The data can be used 
to verify emissions law requirem ents and/or help technicians 
diagnose and solve service problems.  It may also be combined with 
data from other sources for res earch purposes, but it remains 
confidential. Some diagnostic and maintenance information is 
uploaded to Honda upon vehicle start up.
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  0 ページ  2019年10月3日 木曜日 午後4時55分 
         
        
        
     
        
        Page 8 of 671
Visual Index
6
Quick Reference Guide
❚Rearview Mirror (P196)
❚Driver's Front Airbag (P51)
❚Hood Release Handle (P570)
❚Driver’s Pocket
❚Fuel Fill Door Release Handle (P555)
❚Memory Buttons* (P 194)
❚Interior Fuse Box (P636)❚SET Button* (P 194)
❚Power Window Switches (P163)
❚Door Mirror Controls (P197)
❚Master Door Lock Switch (P 147)
❚Electric Parking Brake Switch 
(P528)
❚Automatic Brake Hold Button 
(P532)
❚Shift Lever (P474)
❚Auto Idle Stop OFF Button 
(P477)
❚ECON Button (P482)
❚Wireless Charger* (P218)
❚Passenger's Front Airbag 
(P51)
❚Accessory Power Socket 
(P217)
❚USB Port(s) (P235)
❚Glove Box (P212)
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  6 ページ  2019年10月3日 木曜日 午後4時55分 
         
        
        
     
        
        Page 11 of 671
9
Quick Reference Guide
Auto Idle Stop Function
To improve fuel economy, the engine stops and then restarts as detailed below.  When Auto Idle Stop is on, the Auto Idle Stop in dicator 
(green) comes on. (P476)
At Continuously variable transmissionEngine status
Deceleration
Stop
Start-up
Stop the vehicle and depress the brake pedal.On
Keep the brake pedal 
depressed.With the automatic brake hold system activated, 
you can release the brake pedal when the   
indicator comes on.
U.S.Canada
Off
Release the brake pedal. With the automatic brake hold system activated, 
depress the accelerator pedal.Restarting
* Not available on all models
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  9 ページ  2019年10月3日 木曜日 午後4時55分 
         
        
        
     
        
        Page 14 of 671

12
Quick Reference Guide
Instrument Panel (P77)
Gauges (P 112)/Driver Information Interface (P113)/System Indicators (P78)
U.S.
Canada
System Indicators
Malfunction Indicator 
Lamp
Low Oil Pressure 
Indicator
Charging System 
Indicator
Anti-lock Brake System 
( ABS ) Indicator
Vehicle Stability Assist
TM 
(VSA® ) System 
Indicator
Parking Brake and 
Brake System 
Indicator (Red) ECON Mode Indicator
Parking Brake and 
Brake System 
Indicator (Amber)
U.S.
Canada Automatic Brake Hold 
System Indicator
Automatic Brake Hold 
IndicatorU.S.
Canada Vehicle Stability Assist
TM 
(VSA® ) OFF  Indicator
Speedometer Fuel Gauge
Shift Lever Position 
Indicator/Transmission 
System Indicator Immobilizer System Indicator/
Security System Alarm Indicator
Temperature Gauge Tachometer
Low Tire Pressure/
TPMS Indicator
Turn Signal and 
Hazard Warning 
Indicators
System Indicators
System Message 
Indicator
Lights Indicators
Lights On Indicator
High Beam Indicator
Fog Light Indicator*
Auto High-beam 
System Indicator
Electric Power 
Steering (EPS) System 
Indicator
Seat Belt Reminder 
Indicator
System Indicators
Supplemental 
Restraint System 
Indicator Low Fuel Indicator
Adaptive Cruise 
Control (
ACC) with 
Low Speed Follow 
Indicator (Amber/
Green)
Collision Mitigation 
Braking SystemTM 
(CMBSTM) Indicator
Road Departure 
Mitigation (RDM) 
Indicator
Lane Keeping Assist 
System ( LKAS) 
Indicator (Amber/
Green) Auto Idle Stop System 
Indicator (Amber)/
Auto Idle Stop 
Indicator (Green)
Blind spot 
information System 
Indicator
*
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  12 ページ  2019年10月3日 木曜日 午後4時55分 
         
        
        
     
        
        Page 32 of 671

30
Quick Reference Guide
Why does the brake pedal 
pulsate slightly when 
applying the brakes?This can occur when the ABS activates and does not indicate a 
problem. Apply firm, steady pressure on the brake pedal. Never 
pump the brake pedal.u Anti-lock Brake System (ABS) 
(P534)
The rear door cannot be 
opened from inside the 
vehicle. Why?Check if the childproof lock is in the 
lock position. If so, open the rear 
door with the outside door handle.
To cancel this function, slide the 
lever up to the unlock position.
Why do the doors lock 
after I unlocked the doors?If you do not open the doors within 30 seconds, the doors are 
relocked automatically for security.
Why does the beeper 
sound when I open the 
driver's door?The beeper sounds when:
●The exterior lights are left on.
●The Auto Idle Stop is in operation.
●The key is left in the ignition switch.
●The power mode is in ACCESSORY.
Models without smart entry system
Models with smart entry system
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  30 ページ  2019年10月3日 木曜日 午後4時55分 
         
        
        
     
        
        Page 91 of 671
89
uuIndicators u
Continued
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Blind spot 
information 
System 
Indicator
*
●Comes on for a few seconds when 
you set the power mode to ON, 
then goes off.
●Stays on while blind spot 
information system is turned off.
—
●Comes on when mud, snow, or ice 
accumulates in the vicinity of 
sensor.●Comes on while driving  - Remove the 
obstacle in the vicinity of sensor.
2 Blind spot information System* 
P. 516
●Comes on if there is a problem 
with the system.●Comes on while driving  - Have your 
vehicle checked by a dealer.
ECON Mode 
Indicator●Comes on when you press the 
ECON  button.
2ECON Button  P. 482
Auto Idle Stop 
Indicator (Green)•Comes on when Auto Idle Stop is 
in operation. The engine 
automatically shuts off.
2 Auto Idle Stop  P. 476—
* Not available on all models
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  89 ページ  2019年10月3日 木曜日 午後4時55分 
         
        
        
     
        
        Page 92 of 671

90
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage
Auto Idle Stop 
System Indicator 
(Amber)
•Comes on for a few seconds 
when you turn the ignition switch 
to ON 
(w*1, then goes off.
——
•Comes on when Auto Idle Stop 
system has been turned off by the 
Auto Idle Stop  OFF button.
2Auto Idle Stop System ON/OFF  P. 477
•Blinks if there is a problem with 
the Auto Idle Stop system.•Blinks  - Have your vehicle checked by a 
dealer.
Road Departure 
Mitigation (RDM) 
Indicator
●Comes on for a few seconds 
when you turn the  ignition switch 
to ON 
(w*1, then goes off.●Comes on if there is a problem 
with the RDM system.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
●Comes on if the RDM is 
deactivated temporarily after the 
battery has been disconnected, 
then re-connected.●Drive a short distance at more than 12 
mph (20 km/h). The indicator should go 
off. If it does not, have your vehicle 
checked by a dealer.
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  90 ページ  2019年10月3日 木曜日 午後4時55分 
         
        
        
     
        
        Page 106 of 671

104
uuIndicators uDriver Information Interface Wa rning and Information Messages
Instrument Panel
MessageConditionExplanation
•Appears if the area around the front sensor camera 
is blocked by dirt, mud, etc. and be prevented from 
detecting a vehicle in front.
• May appear when driving in bad weather (rain, 
snow, fog, etc.)•When the front window gets dirty, stop your vehicle in 
a safe place, and wipe  it off with a soft cloth.
• Have your vehicle checked by  a dealer if the message 
does not disappear even after you cleaned the area 
around the camera.
2 Front Sensor Camera  P. 483
2 Auto High-Beam  P. 181
●Appears if there is a prob lem with the Auto high-
beam system.●Manually operate the headlight switch.●If you are driving with the high-beam headlights when 
this happens, the headlights are changed to low beams.
• Appears when the hood is opened.•Close the hood.
•Appears when the engine does not restart 
automatically due to the following reason:
• The hood is open.
• There is a problem in the system that disables Auto 
Idle Stop.•Follow the normal procedure to start the engine.
2 Starting the Engine  P. 465, 467
•Close the hood.
Models with smart 
entry system
Models without 
smart entry system
20 CR-V PET ELP_MAP_HMIN_HCM_J-31TLA6310.book  104 ページ  2019年10月3日 木曜日 午後4時55分