Check and tighten the U-bolt nuts with
your vehicle at curb height and unloaded.
Inspect the U-bolt threads for rust and
debris. Clean the threads if contaminated.
U-bolt Nut Torque
Rear Axle
Note:
Check and tighten the U-bolt nuts
evenly using a criss-cross pattern in the
following stages. lb.ft (Nm)
Stage
70 lb.ft (100 Nm)
1.
150 lb.ft (200 Nm)
2.
220 lb.ft (300 Nm)
3.
300 lb.ft (400 Nm)
4.
379
Super Duty (TFE), enUSA, Edition date: 201909, Third-Printing- Maintenance
F-350 Dual Rear Wheel Vehicles
Remove the lug nuts with the lug wrench,
replace the flat tire with the spare, making
sure the valve stem of the spare is facing
outward when replacing a front wheel. For
the rear wheel position on vehicles with
single rear wheel fitments, install the spare
with the valve stem facing outward. For
vehicles with dual rear wheels, the valve
stem of the spare must face outward when
replacing an inner wheel, but must face
inward when replacing an outboard wheel.
Reinstall the lug nuts until the wheel is
snug against the hub. Do not fully tighten
the lug nuts until the wheel has been
lowered.
Lower the vehicle completely by turning
the jack handle counterclockwise until the
vehicle is completely lowered. Note:
For F-350 Dual Rear Wheel, F-450
and F-550 Vehicles, insert the notched end
of the jack handle to the release valve, open
the release valve slightly by turning the
handle counterclockwise. Stop turning the
release valve when vehicle start to lower.
Make sure to close the valve when you
completely lower your vehicle.
F-350 Dual Rear Wheel, F-450 and
F-550 Vehicles. Installing the lug Nuts and Ornaments
8-lug nut torque sequence
425
Super Duty (TFE), enUSA, Edition date: 201909, Third-Printing- Wheels and TiresE162811 E162819 E162812 E161441
13
4
27
6
5
8
10-lug nut torque sequence
Note:
When installing the wheel center
ornaments, make sure that the ornament
retention towers on the back side of the
ornament are aligned with the studs or nuts
and retain to the flange on the lug nuts. Note:
For dual rear wheels, align the
ornament with the lug nuts. (A) is the clip
in the ornament and (B) is the flange of the
lug nut. Make sure that each of the retention
clips are sitting on a lug nut flange. Note:
If the ornament retention clips are
aligned between the studs or lug nuts, the
ornament will be improperly installed. This
improper installation may appear and sound
correct, but will not keep the ornament on
the vehicle. Ornaments improperly installed
in this manner may become loose or fall off
during driving. Use your hand or a rubber mallet to tap the
ornament until the retention clips snap
over the lug nut flanges. Tap in a star
pattern until the ornament seats fully onto
the wheel. There should be an even gap
between the ornament and the wheel
when it is properly installed.
426
Super Duty (TFE), enUSA, Edition date: 201909, Third-Printing- Wheels and Tires1
2
3
4
5
6
7 8
9
10
E169375 E162820 AB
E162822 E162823
TECHNICAL SPECIFICATIONS
Wheel Lug Nut Torque Specifications
WARNING: When you install a wheel, always remove any corrosion, dirt or foreign
materials present on the mounting surfaces of the wheel or the surface of the wheel
hub, brake drum or brake disc that contacts the wheel. Make sure to secure any fasteners
that attach the rotor to the hub so they do not interfere with the mounting surfaces of
the wheel. Installing wheels without correct metal-to-metal contact at the wheel
mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while
your vehicle is in motion, resulting in loss of vehicle control, personal injury or death. lb.ft (Nm)
1
Bolt size
150 lb.ft (204 Nm)
M14 x 1.5
1 Torque specifications are for nut and bolt threads free of dirt and rust. Use only Ford
recommended replacement fasteners.
On vehicles equipped with single rear wheels, retighten the lug nuts to the specified torque
at 100 mi (160 km) after any wheel disturbance, such as tire rotation, changing a flat tire,
or wheel removal.
On vehicles equipped with dual rear wheels, retighten the wheel lug nuts to the specified
torque at
100 mi (160 km), and again at 500 mi (800 km) of new vehicle operation and
after any wheel disturbance, such as tire rotation, changing a flat tire, or wheel removal.
It is important to follow the proper wheel mounting and lug nut torque procedures. Wheel pilot bore
A
Inspect the wheel pilot hole and
mounting surface prior to installation.
Remove any visible corrosion or loose
particles.
428
Super Duty (TFE), enUSA, Edition date: 201909, Third-Printing- Wheels and TiresE145950
Special Instructions..............................................
15
Using a Slide-In Camper.................................... 15
Using your Vehicle as an Ambulance............15
Using your Vehicle as a Stationary Power Source.................................................................. 16
Using your Vehicle With a Snowplow............15
Special Operating Conditions Scheduled Maintenance..............................................562
Diesel Engine....................................................... 565
Exceptions............................................................ 570
Gasoline Engine................................................. 562
Speed Control See: Cruise Control........................................... 236
Spot Lamps.....................................................89
Spring U-Bolt Check - F-600..................378 U-bolt Nut Torque............................................. 379
Stability Control............................................222
Principle of Operation...................................... 222
Starter Switch See: Ignition Switch........................................... 168
Starting a Diesel Engine - 6.7L Diesel...............................................................171
Automatic Engine Shutdown......................... 173
Cold Weather Operation.................................. 173
Cold Weather Starting....................................... 173
Diesel Engine Fast Start Glow Plug System................................................................ 172
Vehicles with an Ignition Key.......................... 172
Vehicles with Keyless Start............................. 172
Starting a Gasoline Engine - 6.2L/ 7.3L..................................................................169
Automatic Engine Shutdown......................... 170
Cold Weather Starting (Flexible Fuel Vehicles Only)................................................... 171
Failure to Start..................................................... 170
Guarding Against Exhaust Fumes.................171
Important Ventilating Information................171
Stopping the Engine When Your Vehicle is Moving................................................................ 170
Stopping the Engine When Your Vehicle is Stationary......................................................... 170
Vehicles with an Ignition Key......................... 169
Vehicles with Keyless Start............................. 170
Starting and Stopping the Engine.........168 General Information.......................................... 168
Steering...........................................................256 Adaptive Learning.............................................. 257
Adaptive Steering............................................... 257Electronic Torque Overlay Steering............256
Hydraulic Power Steering...............................
256
Steering Wheel
................................................79
Storage Compartments.............................165
Sunroof See: Moonroof...................................................... 99
Sun Visors
.........................................................99
Illuminated Vanity Mirror................................... 99
Supplementary Restraints System.........43 Principle of Operation........................................ 43
Switching Automatic High Beam Control On and Off
.....................................................92
Activating the Automatic High Beam
Control................................................................. 92
Switching Cruise Control On and Off..................................................................236
Switching Cruise Control Off......................... 236
Switching Cruise Control On......................... 236
Switching Off the Engine - 6.7L Diesel..............................................................176
Switching Trail Control On and Off
.......225
Symbols Glossary.............................................8
SYNC™ 3
.........................................................501
General Information.......................................... 501
SYNC™ 3 Troubleshooting......................533 Additional Information and
Assistance....................................................... 545
Apps....................................................................... 540
Navigation............................................................ 539
Personal Profiles................................................ 543
Phone..................................................................... 537
Resetting the System....................................... 545
USB and Bluetooth Audio.............................. 534
Voice Recognition.............................................. 533
Wi-Fi Connectivity............................................. 542
SYNC™ Applications and Services.......................................................488
911 Assist.............................................................. 488
SYNC Mobile Apps........................................... 490
SYNC™...........................................................484 General Information......................................... 484
SYNC™ Troubleshooting.........................492
T
Tailgate Lock....................................................70
Tailgate Step
.....................................................71
Closing the Step.................................................... 72
625
Super Duty (TFE), enUSA, Edition date: 201909, Third-Printing- Index