2020 DACIA LODGY height

JauneNoir Noir texte
1.41
ENG_UD33069_3
Poste de conduite direction à gauche (X92 - Renault)
ENG_NU_975-6_X92_Dacia_1
DRIVER’S POSITION, LEFT-HAND DRIVE (2/2)
The presence of the equipment DEPENDS ON THE VEHICLE VERSION AND COUNTRY.
1 Side air vent.
2 Side demister outlet.
3 Stalk for:
– direction indicator lights,
– exterior lights,
– front fog lights,
– rear fog lights,
– horn.
4 Instrument panel.
5 Location for driver’s airbag.
6 Steering column stalk for winds-
creen and rear screen wash/wipe.
On-board computer information
readout control.
7 Centre air vents.
8 Central demister outlet.
9 Location for passenger airbag or
storage compartment.
10 Side demister outlet. 11 Side air vent.
12 Passenger airbag activation/deac-
tivation switch.
13 Glovebox.
14 Hazard warning lights switch.
15 Electric central locking switch.
16 Location for radio or storage com-
partment.
17 Heating and ventilation controls.
18 Rear screen and door mirror de-
icing control
19 Cigarette lighter.
Accessories socket.
20 Handbrake.
21 LPG control
22 Location for ashtray or cup holder.
23 Gear lever.
24 ECO mode switch.
25 Cruise control/speed limiter main
control.
26 Ignition switch.
27 Radio remote control.
28 Cruise control/speed limiter
controls.
29 Beam height adjustment control.
30 Fuse box.
Storage box.
31 Bonnet release control.
32 Controls for:
– activating/deactivating the trac-tion control system,
– activating/deactivating the par- king distance control.
33 Door mirror adjustment control.

JauneNoir Noir texte
1.56
ENG_UD29272_2
Réglage de la hauteur des faisceaux (X92 - Renault)
ENG_NU_975-6_X92_Dacia_1
HEADLIGHT BEAM ADJUSTMENT
Control A is used to adjust the height
of the headlight beams according to the
load.
Turn control A anticlockwise to lower
the beams and clockwise to raise them.
A
If driving on the left in a left-hand
drive vehicle (or vice versa), drivers
must have the lights adjusted by an
authorised dealer for the duration of
the trip.
Examples of positions for adjusting control A according to the load
Driver alone or with front passenger 0
Driver with one front passenger and
one rear passenger 1
Do not use 2
Driver with one front passenger and
two or three rear passengers 3
Driver with one front passenger,
three rear passengers and luggage 3

JauneNoir Noir texte
3.8
ENG_UD24442_1
Vitres (X92 - Renault)
ENG_NU_975-6_X92_Dacia_3
ELECTRIC WINDOWS (1/2)
Safety of rear occupants
The driver can prevent op-
eration of the rear elec-
tric windows by pressing
switch 4.
Driver’s responsibility
Never leave your vehicle with the
key inside and never leave a child
(or a pet) unsupervised, even for a
short while. They may pose a risk
to themselves or to others by start-
ing the engine, activating equipment
such as the electric windows or by
locking the doors. If a body part
gets trapped, reverse the direction
of travel of the window as soon as
possible by pressing the relevant
switch.
Risk of serious injury.1
2
4
5
3
Electric windowsPress the window switch down or lift it
up to lower or raise the window to the
desired height. From the driver’s seat, use switch:
1 for the driver’s side;
2 for the front passenger side;
3 and 5 for the rear passengers.
From the passenger seats, use
switch 6.
6
Avoid resting any objects against
a half-open window: there is a risk
that the electric window could be
damaged.

JauneNoir Noir texte
3.9
ENG_UD24442_1
Vitres (X92 - Renault)
ENG_NU_975-6_X92_Dacia_3
ELECTRIC WINDOWS (2/2)
7
Manual window winders
Turn handle 7 to lower or raise the
window to the desired height.
Rear side screen
To half-open the window, turn handle 8
(movement A) then lock it by pushing
the handle to the right.
Make sure it is properly latched into po-
sition when it is closed.
8
A

JauneNoir Noir texte
3.17
ENG_UD28017_3
Appuis-tête arrière (X92 - Renault)
ENG_NU_975-6_X92_Dacia_3
REAR HEADRESTS (1/2)
Position for using headrest A
Lift the headrest to maximum height,
then lower it until it locks.
To raise the headrest A
Raise the headrest as far as it will go,
then press tab(s) 1 and remove the
headrest.
The headrest is a safety
component. Ensure that it is
fitted and in the correct po-
sition: the top of your head
should be in line with the top of the
headrest.
11
To put the headrest back in
place A
Insert the rods into the holes, press the
tab(s) 1 and lower the headrest.
Headrest A storage
position B
Press tab 1 and lower the headrest fully.
When the headrest is set at the
lowest position , Bthis is for storage
only: it should not be in this position
when a seat is occupied.
AAA
BBB
AA

JauneNoir Noir texte
3.18
ENG_UD28017_3
Appuis-tête arrière (X92 - Renault)
ENG_NU_975-6_X92_Dacia_3
To adjust the height of the
headrest C
(depending on vehicle)
Press lock tab 2 and simultaneously
slide the headrest to the required po-
sition.
To raise the headrest C
Press lock tab 2 and remove the head-
rest.
To put the headrest back in
place C
Insert the rods into the holes, press lock
tab 2 and lower the headrest.
The headrest is a safety
component. Ensure that it is
fitted and in the correct po-
sition: the top of your head
should be in line with the top of the
headrest.
REAR HEADRESTS (2/2)
C
2

JauneNoir Noir texte
3.28
ENG_UD24450_1
Coffre à bagages (X92 - Renault)
ENG_NU_975-6_X92_Dacia_3
LUGGAGE COMPARTMENT
To open
Electric central locking
With the opening elements unlocked,
press button 1 and lift the tailgate.
Manual locking
Insert the key in the boot lock, turn and
press button 1.
1
2
To close
Pull down the tailgate using handle 2
inside the tailgate to assist you.
When the tailgate reaches shoulder
height, gently push it shut.
For your safety, check that
all the vehicle’s doors are
properly closed before
starting the engine.

JauneNoir Noir texte
4.7
ENG_UD28037_3
Niveaux / Filtres (X92 - Renault)
ENG_NU_975-6_X92_Dacia_4
Coolant
With the engine switched off and on
level ground, the level when cold must
be between the MINI and MAXI marks
on reservoir 2.
Top this level up when cold before it
reaches the MINI mark.
No operations should be
carried out on the cooling
circuit when the engine is
hot.
Risk of burns.
Checking intervals
Check the coolant level regularly
(very severe damage is likely to be
caused to the engine if it runs out of
coolant).
If the level needs to be topped up, only
use products approved by our Technical
Department which ensure:
– protection against freezing;
– anti-corrosion protection of the cool- ing system.
Replacement intervals
Refer to the Maintenance Service
Booklet for your vehicle.
Consult an approved dealer at once
if you notice an abnormal or re-
peated drop in any of the fluid levels.
LEVELS (2/3)
2
Windscreen washer reservoir
Filling: Remove cap 3, fill until you can
see the fluid, then refit the cap.
This reservoir supplies the front and
rear headlight screen washers (if the
vehicle is equipped with them).
Liquid: Special windscreen washer
fluid (antifreeze product for winter).
Jets: Depending on the vehicle, use
a tool such as a needle to adjust the
height of the windscreen washer jets.
3
The engine may be hot
during operations in close
proximity. In addition, the
engine cooling fan may
come on at any moment.
Risk of burns.