2020 Alfa Romeo 4C fuel

KNOWING THE INSTRUMENT PANEL TOOLS
46
Warning lights on panelMeaningWhat to do
GENERIC FAILURE INDICATION
(where provided)
The symbol appears on the display together with the
events shown below.
Engine oil pressure sensor
The symbol appears when a failure is detected in the
engine oil pressure sensor. The display shows the
dedicated message.In this case, go to a dedicated
Alfa Romeo Dealership as soon as possible to have the
fault corrected.
Clutch overheating message
The
symbol, together with a message on the display,
lights up to indicate clutch overheating.
If you continue driving, the symbol
will disappear and
the warning light will come on (on some versions
together with a message on the display) to indicate a
gearbox fault.
If the symbol comes on together with a message on
the display, limit the gear shifting and/or change the
condition of use, until normal operating conditions are
restored.
If the warning light lights up (a message will appear on
the display, on some versions) stop immediately, operate
the handbrake, switch off the engine and wait 5 minutes:
after this, normal transmission operating conditions will
be restored.
Should the transmission failure condition persist, contact
the dedicated Alfa Romeo Dealership.
FUEL CUT-OFF SYSTEM
The symbol and the corresponding message are shown on
the display in the following cases:
❒ fuel cut-off system intervention:
the yellow symbol lights up;
❒ fuel cut-off system failure:
the red symbol lights up.For reactivating the fuel cut-off system, refer to the
description in the
“Fuel cut-off system” section in the “In an emergency”
chapter. If it is not possible to restore the fuel supply,
contact a dedicated Alfa Romeo Dealership.
s è

53
TPMS
(Tyre Pressure Monitoring
System)
(where provided)
DESCRIPTION
The tyre pressure monitoring system
(TPMS) warns the driver of low tyre
pressure on the basis of the cold
inflation pressure prescribed for the car.
Changes in outside temperature may
cause tyre pressure to vary.
This means that a decrease in the
outside temperature corresponds to a
decrease in the tyre pressure.
The tyre pressure must always be
adjusted according to the cold tyre
inflation pressure.
Cold tyre inflation pressure is the tyre
pressure after letting the car at a
standstill for at least three hours or a
travel shorter than 1.6 km after an
interval of three hours.
The cold tyre inflation pressure must not
exceed the maximum pressure indicated
on the tyre sidewall.Tyre pressure increases also while
driving: this is a normal condition and no
pressure adjustment is needed.
The TPMS continues to advise the driver
of the low tyre pressure condition until
this is corrected; the warning continues
until the pressure corresponds or
exceeds the pressure prescribed for the
cold tyres. When the low tyre pressure
warning light
nappears on the
instrument panel, the inflation pressure
must be adjusted up to the prescribed
cold inflation value.
The tyre pressure warning light switches
off after the system refreshes
automatically. You may need to drive the
car for about 20 minutes at a speed
higher than 20 km/h to allow the TPMS
to receive this information.
NOTE
❒ The TPMS does not replace the
normal tyre maintenance service and
does not indicate any fault in a tyre.
❒ The TPMS must not be used as a
pressure gauge while adjusting tyre
pressure❒ Driving with low tyre pressure causes
overheating and may cause a fault in the
tyres themselves. The low inflation
pressure reduces fuel efficiency and tyre
tread life and may also affect handling
and braking performance of the car.
❒ The TPMS does not replace the
correct tyre maintenance.
It is up to the driver to maintain the
correct tyre pressure level measuring it
with a suitable pressure switch. This is
necessary even if the decrease in the
inflation pressure value does not cause
the tyre pressure control warning light to
switch on.
❒ The TPMS warns the driver of any
condition of insufficient tyre pressure.
If this drops below the insufficient
pressure limit for any reason including
low temperature and normal pressure
loss of the tyre.
❒ The seasonal temperature changes
affect tyre pressure.

STARTING AND DRIVING
STARTING THE ENGINE........................................................................................ 68
PARKING .......................................................................................................................69
TCT TWIN CLUTCH TRANSMISSION ............................................................ 70
CRUISE CONTROL.................................................................................................... 75
PARKING SENSORS ............................................................................................... 77
REFUELLING THE CAR ......................................................................................... 79
Let’s get to the heart of the matter: seeing how you can exploit
all the potentials of your car to the fullest.
This is how to drive your car safely in all conditions for
pleasantly comfortable and cost-efficient travelling.

STARTING AND DRIVING
68
STARTING THE ENGINE
Before starting the engine, adjust the
seat, the interior rear view mirrors, the
door mirrors and fasten the seat belt
correctly. Never press the accelerator
pedal for starting the engine.
Procedure
73) 74) 75) 5)
The metal insert 1 fig. 2 operates:
❒ press the brake pedal;
❒ turn the ignition key to AVV and
release it as soon as the engine starts.
If the engine does not start at the first
attempt, return the ignition key to STOP
before repeating the starting procedure.
❒ If, when the ignition key is at MAR, the
instrument panel warning light stays on
together with the warning light, turn the
key to STOP and then back to MAR; if the
warning light stays on, try the other keys
provided with the vehicle. If it is still not
possible to start the engine, contact a
dedicated Alfa Romeo Dealership.
❒ Do not leave the ignition key at MAR
when the engine is stopped.
SWITCHING OFF THE ENGINE
Procedure
Turn the ignition key to STOP while the
engine is idling.
6) 7)
73)It is dangerous to run the engine in
enclosed areas. The engine takes in
oxygen and releases carbon dioxide,
carbon monoxide and other toxic gases.
74)The brake servo is not active until the
engine is started, so you would need to
apply much more force than usual to the
brake pedal.
75)Do not start the engine by pushing,
towing or driving downhill. These
manoeuvres may damage the catalytic
converter.
IMPORTANT
5)It is advisable not to demand maximum
performance from your car (e.g. excessive
acceleration, long distances at maximum
rpm, excessively intense braking, etc.)
when it is first used.
6)When the engine is switched off never
leave the ignition device in the MAR
position to prevent useless current
absorption from draining the battery.
7)A quick burst on the accelerator before
stopping the engine serves no practical
purpose; it wastes fuel and is especially
damaging to turbocharged engines.
WARNING

79
REFUELLING THE CAR
The car features the “Fast Fuel” system,
which prevents refuelling with incorrect
fuels (e.g. diesel for a petrol engine).
Stop the engine before refuelling.
Only refuel with unleaded petrol with
octane rating (RON) not less than 95, in
compliance with the European
specification EN228. In particular, the
engine of Alfa 4C has been designed to
comply with all emission limits while
simultaneously guaranteeing minimal
consumption and maximum performance,
using premium-quality unleaded petrol
with octane rating (RON) 98 or higher.
In order to prevent damage to the
catalytic converter never introduce even
the smallest amount of leaded petrol,
even in the event of an emergency.
IMPORTANT An inefficient catalytic
converter leads to harmful exhaust
emissions, thus contributing to air
pollution.
FILLING THE TANK
To ensure that you fill the tank
completely, top up twice after the first
click of the fuel supply gun. Further top-
ups could cause faults in the fuel feeding
system.
REFUELLING PROCEDURE
The car features a “Fast Fuel” device,
integrated with the opening for the fuel
tank: it opens and recloses automatically
when the fuel supply gun is
inserted/removed.
The “Fast Fuel” device is provided with an
inhibitor which prevents refuelling with
incorrect fuel.
The refuelling procedure described below
is illustrated on the label
fig. 51 located inside the fuel flap.
The label also indicates the fuel type
(UNLEADED FUEL=petrol).
Procedure
❒ open flap 1 fig. 52, pulling it outwards;
❒ introduce the dispenser in the filler
and refuel;
❒ after refuelling, before removing the
dispenser, wait for at least 10 seconds in
order for the fuel to flow inside the tank;
❒ then remove the dispenser from the
filler and close flap 1.
The flap is provided with a dust boot 2
which prevents the introduction of dirt
and dust into the end of the filling when
the flap is closed.
82) 83) 84)
51A0L0045

STARTING AND DRIVING
80
Emergency refuelling
If there is no fuel in the vehicle or the
supply circuit is completely empty,
proceed as follows to reintroduce fuel to
the tank:
❒ take the dedicated funnel fig. 53 from
the tool kit located in the boot;
❒ open the flap 1 fig. 52 by pulling it
outwards;
❒ insert funnel C in the filler as
illustrated in fig. 53 and refuel;
❒ after refuelling, remove the funnel and
close the flap;
❒ finally, put the funnel back in its case
and put this back in the boot.
52A0L0046
IMPORTANT If the filler compartment is
washed with a high pressure jet, keep it at
a distance of at least 20 cm.
Fuel - Vehicle compatibility
identification Graphic symbol for
informing consumers in accordance
with EN16942
The symbols shown below facilitated
recognising the correct fuel type to be
used on your car.
Before refuelling, check the symbols
inside the fuel filler flap (where provided)
and compare them with the symbol on
the fuel pump (where provided).
53A0L0151
82)Do not apply any object/cap to the
end of the filler which is not provided for
the vehicle. The use of non-compliant
objects/caps could cause a pressure
increase inside the tank, resulting in
dangerous situations.
83) Do not bring naked flames or lit
cigarettes near to the fuel tank opening:
risk of fire. Keep your face away from the
fuel filler to prevent breathing in harmful
vapours.
84)Do not use a mobile phone near the
refuelling pump: risk of fire.
IMPORTANT
E5: Unleaded petrol containing up to
2.7% (m/m) oxygen and with maximum
5.0% (V/V) ethanol compliant with
EN228
E10: Unleaded petrol containing up to
3.7% (m/m) oxygen and with maximum
10.0% (V/V) ethanol compliant with
EN228

IN AN EMERGENCY
HAZARD LIGHTS ...................................................................................................... 82
WHEN NEEDING TO CHANGE A BULB ........................................................ 82
REPLACING AN EXTERNAL BULB .................................................................. 84
REPLACING FUSES ................................................................................................ 87
IF A TYRE IS PUNCTURED................................................................................... 90
“FIX&GO AUTOMATIC” KIT ................................................................................. 94
EMERGENCY STARTING ..................................................................................... 97
FUEL CUT-OFF SYSTEM ...................................................................................... 98
TOWING THE VEHICLE . ........................................................................................ 99
A punctured tyre or a burnt-out bulb?
At times, a problem may interfere with our journey.
The pages on emergencies can help you to deal with critical
situations independently and with calm.
In an emergency we recommend you call the freephone number
found in the Warranty Booklet. It is also possible
to call the national or international
universal freephone number to search
for the nearest dedicated Alfa Romeo Dealership.

IN AN EMERGENCY
98
❒ with a second cable, connect the
negative terminal (–) of the auxiliary
battery to an earthing point
Eon the
engine or the transmission of the car to
be started;
❒ start the engine; when the engine has
started, remove the leads, reversing the
order above.
If after a few attempts the engine does
not start, do not persist but contact a
dedicated Alfa Romeo Dealership.
IMPORTANT Do not connect the negative
terminals of the two batteries directly!
If the auxiliary battery is installed on
another car, check that there is no
accidental contact between metallic
parts of the two cars.
BUMP STARTING
Never, under any circumstances, jump
start the engine by pushing, towing or
coasting downhill.
FUEL CUT-OFF SYSTEM
OPERATION
This intervenes in the case of an impact
causing:
❒ the fuel supply cut-off with the engine
consequently switching off;
❒ automatic door lock release;
activation of all lights inside the car;
❒ the switching on of the hazard
warning lights.
The digital warning light and the
dedicated message on the display
indicate the intervention of the system.
Carefully check the vehicle for fuel leaks,
for instance in the engine compartment,
under the vehicle or near the tank area.
112)
111)This procedure must be performed
by qualified personnel as incorrect
actions may cause high-intensity
electrical discharge. Furthermore,
battery fluid is poisonous and corrosive:
avoid contact with skin and eyes. Keep
naked flames and lighted cigarettes away
from the battery and do not cause sparks.
IMPORTANT
13)Never use a fast battery charger to
start the engine as this could damage the
electronic systems and the ignition and
engine supply control units.
WARNING