2020.25 OPEL VIVARO C stop start

238Vehicle care1.Identify the engine identifier code.
Engine data 3 268.
2. Identify the respective tyre.
The tyre pressure tables show all
possible tyre combinations 3 271.
For the tyres approved for your
vehicle, refer to the EEC Certificate of
Conformity provided with your vehicle or other national registration
documents.
The driver is responsible for correct
adjustment of tyre pressure.9 Warning
If the pressure is too low, this can
result in considerable tyre warm-
up and internal damage, leading to tread separation and even to tyre
blow-out at high speeds.
9 Warning
For specific tyres the
recommended tyre pressure as
shown in the tyre pressure table may exceed the maximum tyre
pressure as indicated on the tyre.
Never exceed the maximum tyre
pressure as indicated on the tyre.
Temperature dependency
The tyre pressure depends on the
temperature of the tyre. During
driving, tyre temperature and
pressure increase. Tyre pressure
values provided on the tyre
information label and tyre pressure
chart are valid for cold tyres, which means at 20 °C.
The pressure increases by nearly
10 kPa for a 10 °C temperature
increase. This must be considered
when warm tyres are checked.
Tyre deflation detectionsystem
The tyre deflation detection system
continually checks the rotation speed
of all four wheels and warns on low
tyre pressure condition once vehicle
is driving. This is achieved by
comparing tyre rolling circumference
with reference values and further
signals.
If a tyre loses pressure the control
indicator q illuminates, a warning
chime is given and a warning
message is displayed in the Driver
Information Centre.
In this case reduce speed, avoid
sharp cornering and strong braking.
Stop at next safe opportunity and
check tyre pressure.
Control indicator q 3 114.
After adjusting tyre pressure initialise
system to extinguish the control
indicator and restart system.Caution
Deflation detection system warns
just about low tyre pressure
condition and does not replace
regular tyre maintenance by the
driver.
In case of a system malfunction, the
control indicators q and R
appear at the same time or a
message is displayed in the Driver
Information Centre. Set correct tyre
pressure and reinitialise system. If the
failure continues to be displayed,

Vehicle care24310. Detach the tyre repair kit. Stowtyre repair kit in load
compartment.
11. Remove any excess sealant using a cloth.
12. Start driving immediately so that sealant is evenly distributed in the
tyre. After driving approx. 5 km but no more than ten minutes, stop
and check tyre pressure. Turn
selector on the kit to the air pump
symbol. Connect compressor air
hose to tyre valve. Fill tyre as
described before. Drain excess
tyre pressure with the button on
the kit.
If tyre pressure hasn't decreased
under 150 kPa (1.5 bar), set it to
the correct value. Otherwise the
vehicle must not be used. Seek
assistance of a workshop. 3 271
Repeat the checking procedure
once more after driving further
10 km but no more than ten
minutes to check that there is no
more loss of pressure.
If the tyre pressure has fallen
below 150 kPa (1.5 bar), the
vehicle must not be used. Seek
the assistance of a workshop.
13. Stow away tyre repair kit in load compartment.
Note
The driving characteristics of the
repaired tyre are severely affected,
therefore have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off for at least
30 minutes.Note the expiry date of the kit. After
this date its sealing capability is no
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Replace the used sealant cartridge. Dispose of the bottle as prescribed
by applicable laws.
The compressor and sealant can be
used from approx. -30 °C.
Removing the pipe and cartridge
1. Turn pipe assembly to the left until
it contacts the unit.

Vehicle care2513. Connect the black lead to thenegative terminal of the booster
battery.
4. Connect the other end of the black
lead to a vehicle grounding point
of your vehicle in the engine
compartment.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine: 1. Start the engine of the vehicle providing the jump.
2. After 5 minutes, start the other engine. Start attempts should be
made for no longer than 15
seconds at an interval of 1 minute.
3. Allow both engines to idle for approx. three minutes with the
leads connected.
4. Switch on electrical consumers e.g. headlights, heated rear
window of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle
Press in the middle of the cover plate
and slide to the upper left corner to
unclip it.
The towing eye is stowed with the vehicle tools 3 234.
Screw in the towing eye clockwise as
far as it will go until it stops in a
horizontal position.
Attach a tow rope – or better a tow rod
– to the towing eye.
The towing eye must only be used for
towing and not for recovering the
vehicle.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.

Service and maintenance259General information
Service information
In order to ensure economical and
safe vehicle operation and to
maintain the value of your vehicle, it
is of vital importance that all
maintenance work is carried out at the proper intervals as specified.
The detailed, up-to-date service
schedule for your vehicle is available
at the workshop.
Severe operating conditions exist if one or more of the following
circumstances occur frequently: Cold starting, stop and go operation, e.g.
for taxis and police vehicles, trailer
operation, mountain driving, driving
on poor and sandy road surfaces,
increased air pollution, presence of
airborne sand and high dust content,
driving at high altitude and large
variations of temperature.
Under these severe operating
conditions, certain service work may
be required more frequently than the
regular service interval indicated inthe service display. Contact a
workshop for customised service
schedules.
Service display 3 109.

283Parking heater............................ 147
Particulate filter ........................... 161
Performing work ........................213
Peripheral lighting .......................138
Power button .............................. 154
Power outlets ............................... 98
Power seat adjustment ................50
Power sliding doors ......................31
Power windows ............................ 42
Preheating ................................. 113
Puncture ..................................... 245
R Radio Frequency Identification (RFID) ..................................... 278
Radio (Infotainment system)....... 124
Radio remote control ...................23
Rain sensor ................................ 115
REACH ....................................... 274
Reading lights ............................ 136
Rear doors .................................... 31
Rear fog light .............115, 134, 226
Rear seats ................................... 53
Rear view camera ...................... 199
Rear windows .............................. 43
Rear window wiper and washer ..97
Recommended fluids and lubricants ........................ 262, 266
Refuelling ................................... 204
Registered trademarks ...............275Reversing lights .........................135
Ride control systems ..................171
Roadside assistance ..................128
Roller blinds ................................. 45
Roof .............................................. 46
Roof bars ...................................... 90
Roof load ...................................... 91
Roof rack ..................................... 90
S Safety net .................................... 84
Seat adjustment ............................. 7
Seat belt ........................................ 8
Seat belt reminder .....................110
Seat belts ..................................... 57
Seat folding .................................. 51
Seat heating ................................. 52
Seat position ................................ 48
Selective catalytic reduction .......162
Selective ride control ..................172
Selector lever.............................. 166
Service ............................... 151, 259
Service display .......................... 109
Service information ....................259
Service vehicle soon .................. 112
Side airbag system ......................64
Side blind spot alert ............116, 194
Sidelights .................................... 130
Side turn lights ........................... 228
Sliding doors ................................ 31Sliding side doors.........................31
SOS ............................................ 128
Spare wheel ............................... 245
Speed limiter....................... 116, 177 Speedometer ............................. 105
Starting and operating ................153
Starting off ................................... 19
Starting the engine ....................155
Steering ...................................... 153
Steering column controls ..............95
Steering wheel .............................. 95
Steering wheel adjustment ......9, 94
Steering wheel controls ...............94
Stop engine ................................ 112
Stop-start system........................ 157
Storage ......................................... 78
Storage compartments .................78
Sunvisor lights ........................... 137
Sun visors .................................... 45
Symbols ......................................... 4
System check ............................. 112
T
Table............................................. 87
Tachometer ............................... 107
Tailgate ......................................... 33
tailgate window ............................. 43
Tail lights ................................... 226
Three-point seat belt .................... 58
Tools .......................................... 234