172Vehicle careNo.Circuit1-2-3Battery sensor4Chassis control module, fuel
pump5ABS6Low beam and daytime running
light left, Xenon high beam7–8LPG control module9Body control module10Headlamp levelling11Rear wiper12Heated rear window13Low beam and daytime running
light right14Heated exterior mirror15–No.Circuit16Brake booster kit17Ignition signal, waterpump18Engine control module19Fuel pump20–21Engine solenoids, engine
sensors22–23Ignition coils, injectors24Washer system25–26Engine sensors27Engine management28Engine control module29Engine control module30Engine control module31High beam left, Xenon low
beam left
Vehicle care175No.Circuit18Air conditioning system19–20Parking assist, rain sensor, front
camera21Brake switch22Infotainment system23Display24–25Auxiliary jack26Instrument panel27–28–29–30–31Horn32–33Heated steering wheelNo.Circuit34–35Tyre repair kit36–37Rear wiper38Cigarette lighter39Power windows, automatic
transmission display40–Vehicle tools
Tools
Vehicles without spare wheel
The tools and the towing eye are
located in the load compartment below the floor cover.
Vehicle care181
Select● Light for comfort pressure up to
three people.
● Eco for Eco pressure up to three
people.
● Max for full loading.
Tyre pressure sensor matching process
Each pressure sensor has a unique identification code. The identification
code must be matched to a new
wheel position after rotating the
wheels or exchanging the complete
wheel set and if one or more tyre
pressure sensors were replaced. The
tyre pressure sensor matching
process should also be performed
after replacing a spare wheel with a
road wheel containing a tyre pressure
sensor.
The malfunction light w and the
warning message or code should
extinguish at the next ignition cycle.
The sensors are matched to the
wheel positions, using a relearn tool,
in the following order: left side front
wheel, right side front wheel, right
side rear wheel and left side rear
wheel. The turn light at the current
active position is illuminated until
sensor is matched.
Consult a workshop for service. There are 2 minutes to match the first wheel
position, and 5 minutes overall to
match all four wheel positions. If it
takes longer, the matching process
stops and must be restarted.
The tyre pressure sensor matching
process is:
1. Apply the parking brake.
2. Turn the ignition on.3. On vehicles with automatic transmission: set the selector
lever to P.
On vehicles with manual
transmission: select neutral.
4. Use MENU on the stalk to select
the Vehicle Information
Menu ? in the Driver
Information Centre.
5. Turn the adjuster wheel to scroll to
the tyre pressure menu.
Midlevel display:
Uplevel display:
Vehicle care189General informationNotice
The driving characteristics of the
repaired tyre are severely affected,
therefore have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off for at least 30 min.
The built-in safety valve opens at a
pressure of 7 bar (102 psi).
Note the expiry date of the kit. After
this date its sealing capability is no
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Replace the used sealant bottle. Dispose of the bottle as prescribed
by applicable laws.
The compressor and sealant can be
used from approx. -30 °C.
The adapters possibly supplied can
be used to pump up other items e.g. footballs, air mattresses, inflatable
dinghies etc. They can be located on the underside of the compressor. To
remove, screw on compressor air
hose and withdraw adapter.Wheel changing
Make the following preparations and
observe the following information:
● Park the vehicle on a level, firm and non-skid surface. The front
wheels must be in the straight- ahead position.
● Apply the parking brake and engage first gear, reverse gear or
P .
● If the ground on which the vehicle
is standing is soft, a solid board
(max. 1 cm thick) should be
placed under the jack.
● Take heavy objects out of the vehicle before jacking up.
● No people or animals may be in the vehicle when it is jacked-up.
● Never crawl under a jacked-up vehicle.
● Do not start the vehicle when it is
raised on the jack.
● Before screwing in the wheel bolts, clean them and lightly coat
the taper of each wheel bolt with
commercially available grease.9 Warning
Do not grease the thread of the
wheel bolt.
Jacking positions
The jacking positions shown refer to the use of lifting arms and accessory
jacks used for changing winter /
summer tyres.
Rear arm position of the lifting
platform located centrally under the
recess of the sill.
Vehicle care195
Screw in the towing eye as far as it will
go until it stops in a horizontal
position.
Attach a tow rope – or better still a tow
rod – to the towing eye.
The towing eye must only be used for towing and not for recovering the
vehicle.
Switch on ignition to release steering
wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.
Switch the selector lever to neutral.
Release the parking brake.
Caution
Drive slowly. Do not drive jerkily.
Excessive tractive force can
damage the vehicle.
When the engine is not running,
considerably more force is needed to
brake and steer.
To prevent the entry of exhaust gases from the towing vehicle, switch on the
air recirculation and close the
windows.
Vehicles with automatic transmission: the vehicle must be towed facing
forwards, not faster than 50 mph nor
further than 60 miles. In all other
cases and when the transmission is
defective, the front axle must be
raised off the ground.
Seek the assistance of a workshop. After towing, unscrew the towing eye.
Insert cap at the top and engage
downwards.
Towing another vehicle
Wrap a cloth around the tip of a flat
screwdriver to prevent paint damage. Insert the screwdriver in the slot at the
lower part of the cap. Release the cap by carefully moving the screwdriver
downwards.
The towing eye is stowed with the
vehicle tools 3 175.
Customer information219Operating data in the vehicleControl units process data for
operation of the vehicle.
This data includes, e.g.: ● vehicle status information (e.g. speed, movement delay, lateral
acceleration, wheel rotation rate,
"seat belts fastened" display)
● ambient conditions (e.g. temperature, rain sensor,
distance sensor)
As a rule such data is transient, not
stored for longer than an operational
cycle, and only processed on board
the vehicle itself. Control units often
include data storage (including the
vehicle key). This is used to allow
information to be documented
temporarily or permanently on vehicle
condition, component stress,
maintenance requirements and
technical events and errors.Depending on technical equipment
levels, the data stored is as follows:
● system component operating states (e.g. fill level, tyre
pressure, battery status)
● faults and defects in important system components (e.g. lights,brakes)
● system reactions in special driving situations (e.g. triggering
of an airbag, actuation of the
stability control systems)
● information on events damaging the vehicle
● for electric vehicles the amount of
charge in the high-voltage
battery, estimated range
In special cases (e.g. if the vehicle
has detected a malfunction), it may be
necessary to save data that would
otherwise just be volatile.
When you use services (e.g. repairs,
maintenance), the operating data
saved can be read together with the
vehicle identification number and
used where necessary. Staff working
for the service network ( e.g. garages,
manufacturers) or third parties (e.g.breakdown services) can read the
data from the vehicle. The same
applies to warranty work and quality
assurance measures.
Data is generally read via the OBD
(On-Board Diagnostics) port
prescribed by law in the vehicle. The operating datawhich is read out,
documents the technical condition of
the vehicle or individual components
and assists with fault diagnosis,
compliance with warranty obligations
and quality improvement. This data,
in particular information on
component stress, technical events,
operator errors and other faults, is
transmitted to the manufacturer
where appropriate, together with the
vehicle identification number. The
manufacturer is also subject to
product liability. The manufacturer
potentially also uses operating data
from vehicles for product recalls. This
data can also be used to check
customer warranty and guarantee
claims.
Fault memories in the vehicle can be
reset by a service company when
carrying out servicing or repairs or at
your request.
222IndexAAccessories and vehicle modifications .......................... 154
Adjustable air vents ...................115
Airbag and belt tensioners ...........76
Airbag deactivation ................45, 77
Airbag label................................... 40 Airbag system .............................. 40
Air conditioning regular operation ................................ 116
Air conditioning system .............. 109
Air intake .................................... 116
Air vents...................................... 115
Antilock brake system ................ 129
Antilock brake system (ABS) .......78
Anti-theft alarm system ................25
Anti-theft locking system .............. 25
Appearance care ........................196
Ashtrays ....................................... 68
Automatic anti-dazzle ..................28
Automatic light control .................99
Automatic locking ........................23
Automatic transmission .............125
Autostop ............................... 80, 120
B Battery discharge protection ......106
Battery voltage ............................. 90
Belts.............................................. 37
Bonnet ....................................... 156Brake and clutch fluid.................201
Brake and clutch system .............77
Brake assist ............................... 130
Brake fluid .................................. 160
Brakes ............................... 129, 160
Breakdown.................................. 194
Bulb replacement ....................... 162
C Capacities .................................. 210
Catalytic converter .....................124
Central locking system ................21
Centre high-mounted brake light 169
Changing tyre and wheel size ...183
Charging system .......................... 77
Child locks ................................... 23
Child restraint installation locations ................................... 50
Child restraints.............................. 46
Child restraint systems ................46
Cigarette lighter ........................... 68
City mode ................................... 132
Climate control ............................. 15
Climate control systems .............108
Clock ............................................ 66
Code ............................................. 87
Control indicators.......................... 73
Control of the vehicle .................117
Controls ........................................ 62
Convex shape .............................. 27
223Coolant and antifreeze...............201
Corner lighting ............................ 101
Cruise control ...................... 81, 133
Cupholders .................................. 53
Curtain airbag system .................. 45
D Danger, Warnings and Cautions ...4
Daytime running lights ...............101
Declaration of conformity ............213
Door open .................................... 81
Doors ............................................ 24
Driver assistance systems ..........133
Driver Information Centre .............81
Driving hints ................................ 117
E Easy entry..................................... 35Electric adjustment ......................27
Electrical system......................... 170
Electronic climate control system 111
Electronic driving programmes ..126
Electronic Stability Control.......... 131
Electronic Stability Control and Traction Control system ............79
End-of-life vehicle recovery .......155
Engine compartment fuse box ...171
Engine coolant ........................... 158
Engine coolant temperature gauge ....................................... 72
Engine data ............................... 208Engine exhaust .......................... 123
Engine identification ...................204
Engine oil ...........157, 201, 205, 210
Engine oil pressure ......................79
Entry lighting .............................. 105
Event data recorders ..................218
Exhaust filter ......................... 79, 123
Exit lighting ................................ 106
Exterior care .............................. 196
Exterior light ................................. 80
Exterior lighting ......................12, 98
Exterior mirrors ............................. 27
F Fault ........................................... 127First aid ......................................... 59
First aid kit ................................... 59
Fixed air vents ........................... 116
Folding mirrors ............................. 27
Following distance indication ......138
Forward collision alert................. 136
Front airbag system .....................43
Front fog lights .............80, 102, 166
Front seats.................................... 33
Front storage ................................ 54
Front turn lights .......................... 166
Fuel............................................. 148
Fuel for liquid gas operation .......150
Fuel for petrol engines ...............148
Fuel gauge ................................... 70Fuel selector ................................ 71
Fuel tank ..................................... 210
Fuses ......................................... 170
G
Gauges ......................................... 69
Gear shifting ................................. 78
Glovebox ..................................... 53
H
Halogen headlights ....................162
Hand brake ......................... 129, 130
Hazard warning flashers ............102
Headlight flash ........................... 100
Headlight range adjustment ......100
Headlights..................................... 98
Headlights when driving abroad 100
Head restraint adjustment .............8
Head restraints ............................ 32
Heated mirrors ............................. 28
Heated rear window ..................... 30
Heated steering wheel .................62
Heated windscreen .......................31
Heating ........................................ 36
Heating and ventilation system . 108
High beam ........................... 80, 100
Hill start assist ........................... 130
Horn ....................................... 13, 63