Page 72 of 568
721-1. For safe use
PRIUS +_OM_OM47D30E_(EE) 
■Junior seat 
Adjusting the angle of the seatback.
Second seats 
While pulling the lever (either 
 [outboard seats only] or 
), fold the seatback for- 
ward and then back to the 1st 
lock position (most upright 
position) until it locks into 
place. Adjust the seatback to 
the 5th lock position. 
1st lock position 
5th lock position 
Move the seat as far back as 
possible.
Third seats 
Adjust the second seat for- 
ward so that it does not inter- 
fere with the child restraint 
system. 
While pulling the lever, fold 
the seatback forward and 
then back to the 1st lock 
position (most upright posi- 
tion) until it locks into place.
1
1
2
A
B 
     
        
        Page 73 of 568
731-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
Place the child restraint sys- 
tem on the seat facing the 
front of the vehicle. 
Sit the child in the child 
restraint system. Fit the seat 
belt to the child restraint sys- 
tem according to the manu- 
facturer’s instructions and 
insert the plate into the 
buckle. Make sure that the 
belt is not twisted.
Check that the shoulder belt is 
correctly positioned over the 
child’s shoulder and that the lap 
belt is as low as possible. 
( P.  3 8 )
Press the buckle release button 
and fully retract the seat belt. 
2
3
Removing a child restraint installed with a seat belt 
     
        
        Page 74 of 568
741-1. For safe use
PRIUS +_OM_OM47D30E_(EE)
Adjusting the angle of the seatback. 
While pulling the lever (either 
 or  ), fold the seatback for- 
ward and then back to the 1st 
lock position (most upright posi- 
tion) until it locks into place. 
Adjust the seatback to the 5th 
lock position. 
1st lock position 
5th lock position 
Move the seat as far back as 
possible. 
Remove the head restraint. ( P. 200)
Installation with ISOFIX rigid anchor (ISOFIX child restraint sys- 
tem) (second outboard seats only)
1
12
A
B
2 
     
        
        Page 75 of 568
751-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
Open the covers. 
Install the child restraint system 
to the seat.
If the child restraint has a top strap, 
the top strap should be latched 
onto the anchors.
3
4 
     
        
        Page 76 of 568
761-1. For safe use
PRIUS +_OM_OM47D30E_(EE)
Latch the hook onto the anchor 
bracket and tighten the top strap.
Make sure the top strap is securely 
latched. 
■ When installing a child restraint system 
You need a locking clip to install the child restraint system. Follow the instruc- 
tions provided by the manufacturer of the system. If your child restraint sys- 
tem does not provide a locking clip, you can purchase the following item from
any authorized Toyota retailer or Toyota authorized repairer, or any reliable 
repairer:  
Locking clip for child restraint system 
(Part No. 73119-22010)
Child restraint systems with a top strap (second outboard seats 
only) 
     
        
        Page 77 of 568

771-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
WARNING
■When installing a child restraint system 
Follow the directions given in the child restraint system installation manual 
and fix the child restraint system securely in place. 
If the child restraint system is not correctly fixed in place, the child or other 
passengers may be seriously injured or even killed in the event of sudden
braking, sudden swerving or an accident.
● If the driver’s seat interferes with the 
child restraint system and prevents it 
from being attached correctly, attach the 
child restraint system to the right-hand
rear seat (left-hand drive vehicles) or 
the left-hand rear seat (right-hand drive 
vehicles). 
● Adjust the front passenger seat so that 
it does not interfere with the child 
restraint system. 
● Only put a forward-facing child restraint 
system on the front seat when unavoid- 
able. When installing a forward-facing
child restraint on the front passenger 
seat, move the seat as far back as pos- 
sible. 
Failing to do so may result in death or 
serious injury if the airbags deploy 
(inflate). 
     
        
        Page 78 of 568
781-1. For safe use
PRIUS +_OM_OM47D30E_(EE)
WARNING
■When installing a child restraint system
●Never use a rear-facing child restraint 
system on the front passenger seat 
when the airbag manual on-off switch is
on. ( P. 56) 
The force of the rapid inflation of the 
front passenger airbag can cause
death or serious injury to children in the 
event of an accident. 
● There is a label(s) on the passenger 
side sun visor, indicating it is forbidden 
to attach a rear-facing child restraint 
system to the front passenger seat.
Details of the label(s) are shown in the 
illustration below. 
     
        
        Page 79 of 568

791-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
WARNING
■When installing a child restraint system 
● If child restraint system regulations exist in the country where you reside, 
please contact any authorized Toyota retailer or Toyota authorized 
repairer, or any reliable repairer for the child restraint system installation. 
● If other second seats interfere with the child restraint system when install- 
ing a child restraint system in the second seat, adjust the seat cushions to 
the same position and align the seatbacks at the same angle. Otherwise, 
the child restraint system cannot be securely restrained and this may
cause death or serious injuries in the event of sudden braking, sudden 
swerving or an accident. 
● When a junior seat is installed, always ensure that the shoulder belt is 
positioned across the center of the child’s shoulder. The belt should be 
kept away from the child’s neck, but not so that it could fall off the child’s 
shoulder. Failing to do so may result in death or serious injury in the event
of sudden braking, sudden swerving or an accident. 
● Ensure that the belt and plate are securely locked and the seat belt is not 
twisted. 
● Shake the child restraint system left and right, and forward and backward 
to ensure that it has been securely installed. 
● After securing a child restraint system, never adjust the seat. 
● Follow all installation instructions provided by the child restraint system 
manufacturer. 
■ To correctly attach a child restraint system to the anchors 
When using the ISOFIX rigid anchors, be sure that there are no foreign 
objects around the anchors and that the seat belt is not caught behind the 
child restraint system. Make sure the child restraint system is securely
attached, or it may cause death or serious injury to the child or other pas- 
sengers in the event of a sudden stop, sudden swerve or accident.