Page 65 of 568

651-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
WARNING
■Using a child restraint system 
The use of a child restraint system not suitable for the vehicle may not prop- 
erly secure the infant or child. It may result in death or serious injury (in the 
event of sudden braking, sudden swerving or an accident). 
■ Child restraint precautions 
● For effective protection in automobile accidents and sudden stops, a child 
must be properly restrained, using a seat belt or child restraint system
depending on the age and size of the child. Holding a child in your arms is 
not a substitute for a child restraint system. In an accident, the child can be 
crushed against the windshield, or between you and the vehicle’s interior. 
● Toyota strongly urges the use of a proper child restraint system that con- 
forms to the size of the child, installed on the rear seat. According to acci- 
dent statistics, the child is safer w hen properly restrained in the rear seat 
than in the front seat. 
● Never install a rear-facing child restraint system on the front passenger 
seat when the airbag manual on-off switch is on. ( P.  5 6 ) 
In the event of an accident, the force of the rapid inflation of the front pas- 
senger airbag can cause death or serious injury to the child. 
● A forward-facing child restraint system may be installed on the front pas- 
senger seat only when it is unavoidable. A child restraint system that 
requires a top strap should not be used in the front passenger seat since 
there is no top strap anchor for the front passenger seat. Adjust the seat-
back as upright as possible and always move the seat as far back as pos-
sible because the front passenger airbag could inflate with considerable 
speed and force. Otherwise, the child may be killed or seriously injured. 
● Do not allow the child to lean his/her head or any part of his/her body 
against the door or the area of the sea t, front and rear pillars or roof side 
rails from which the SRS side airbags  or SRS curtain shield airbags deploy 
even if the child is seated in the child restraint system. It is dangerous if
the SRS side and curtain shield airbags inflate, and the impact could 
cause death or serious injury to the child.  
● Make sure you have complied with all installation instructions provided by 
the child restraint manufacturer and that the system is properly secured. If 
it is not secured properly, it may cause death or serious injury to the child 
in the event of a sudden stop, sudden swerve or accident. 
     
        
        Page 66 of 568
661-1. For safe use
PRIUS +_OM_OM47D30E_(EE)
WARNING
■When children are in the vehicle 
Do not allow children to play with the seat belt. If the seat belt becomes 
twisted around a child’s neck, it may lead to choking or other serious injuries 
that could result in death. 
If this occurs and the buckle cannot be unfastened, scissors should be used
to cut the belt. 
■ When the child restraint system is not in use 
● Keep the child restraint system properly secured on the seat even if it is 
not in use. Do not store the child restraint system unsecured in the pas- 
senger compartment. 
● If it is necessary to detach the child restraint system, remove it from the 
vehicle or store it securely in the  luggage compartment. This will prevent it 
from injuring passengers in the event of a sudden stop, sudden swerve or
accident. 
     
        
        Page 67 of 568
671-1. For safe use
1
For safety and security
PRIUS +_OM_OM47D30E_(EE)
Installing child restraints
Seat belts (An ELR belt requires a 
locking clip) 
ISOFIX rigid anchors (ISOFIX 
child restraint system) 
Lower anchors are provided for the 
second outboard seats. (Tags dis-
playing the location of the anchors 
are attached to the seats.) 
Anchor brackets (for top strap)
Anchor brackets are provided for 
the second outboard seats. 
Use anchor brackets when fixing 
the top strap.
Follow the child restraint system manufacturer’s instructions. 
Firmly secure child restraints to the seats using a seat belt or 
ISOFIX rigid anchors. Attach the top strap when installing a child 
restraint. 
     
        
        Page 68 of 568
681-1. For safe use
PRIUS +_OM_OM47D30E_(EE) 
■Rear facing  Baby seat/child seat 
Adjusting the angle of the seatback.
Second seats 
While pulling the lever (either 
 [outboard seats only] or 
), fold the seatback for- 
ward and then back to the 1st 
lock position (most upright 
position) until it locks into 
place. Adjust the seatback to 
the 5th lock position. 
1st lock position 
5th lock position 
Move the seat as far back as 
possible.
Third seats 
Adjust the second seat for- 
ward so that it does not inter- 
fere with the child restraint 
system. 
While pulling the lever, fold 
the seatback forward and 
then back to the 1st lock 
position (most upright posi- 
tion) until it locks into place.
Installing child restraints using a seat belt
1
1
2
A
B 
     
        
        Page 69 of 568
691-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
Remove the head restraint. (P. 200) 
Place the child restraint sys- 
tem on the seat facing the 
rear of the vehicle. 
Run the seat belt through the 
child restraint system and 
insert the plate into the 
buckle. Make sure that the 
belt is not twisted. Keep the 
lap portion of the belt tight. 
Install a locking clip near the 
tab of the lap and shoulder 
belt by inserting the lap and 
shoulder webbing through 
the recesses of locking clip.
2
3
4
5 
     
        
        Page 71 of 568
711-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
Remove the head restraint. (P. 200) 
Place the child restraint sys- 
tem on the seat facing the 
front of the vehicle. 
Run the seat belt through the 
child restraint system and 
insert the plate into the 
buckle. Make sure that the 
belt is not twisted. Keep the 
lap portion of the belt tight. 
Install a locking clip near the 
tab of the lap and shoulder 
belt by inserting the lap and 
shoulder webbing through 
the recesses of locking clip.
2
3
4
5 
     
        
        Page 73 of 568
731-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
Place the child restraint sys- 
tem on the seat facing the 
front of the vehicle. 
Sit the child in the child 
restraint system. Fit the seat 
belt to the child restraint sys- 
tem according to the manu- 
facturer’s instructions and 
insert the plate into the 
buckle. Make sure that the 
belt is not twisted.
Check that the shoulder belt is 
correctly positioned over the 
child’s shoulder and that the lap 
belt is as low as possible. 
( P.  3 8 )
Press the buckle release button 
and fully retract the seat belt. 
2
3
Removing a child restraint installed with a seat belt 
     
        
        Page 79 of 568

791-1. For safe use
1
PRIUS +_OM_OM47D30E_(EE)
For safety and security
WARNING
■When installing a child restraint system 
● If child restraint system regulations exist in the country where you reside, 
please contact any authorized Toyota retailer or Toyota authorized 
repairer, or any reliable repairer for the child restraint system installation. 
● If other second seats interfere with the child restraint system when install- 
ing a child restraint system in the second seat, adjust the seat cushions to 
the same position and align the seatbacks at the same angle. Otherwise, 
the child restraint system cannot be securely restrained and this may
cause death or serious injuries in the event of sudden braking, sudden 
swerving or an accident. 
● When a junior seat is installed, always ensure that the shoulder belt is 
positioned across the center of the child’s shoulder. The belt should be 
kept away from the child’s neck, but not so that it could fall off the child’s 
shoulder. Failing to do so may result in death or serious injury in the event
of sudden braking, sudden swerving or an accident. 
● Ensure that the belt and plate are securely locked and the seat belt is not 
twisted. 
● Shake the child restraint system left and right, and forward and backward 
to ensure that it has been securely installed. 
● After securing a child restraint system, never adjust the seat. 
● Follow all installation instructions provided by the child restraint system 
manufacturer. 
■ To correctly attach a child restraint system to the anchors 
When using the ISOFIX rigid anchors, be sure that there are no foreign 
objects around the anchors and that the seat belt is not caught behind the 
child restraint system. Make sure the child restraint system is securely
attached, or it may cause death or serious injury to the child or other pas- 
sengers in the event of a sudden stop, sudden swerve or accident.