
41Maintenance Log
MAINTENANCE LOG
MAINTENANCE
30,000 miles or 36 months
Check installation of driver’s floor mat
Inspect and adjust all fluid levels1
Inspect wiper blades
Lubricate propeller shaft 
Re-torque propeller shaft bolt
Replace cabin air filter
Replace engine air filter
Replace engine oil and oil filter2
Rotate tires
Inspect the following: _ Automatic transmission for signs of leakage
 _Ball joints and dust covers
 _Brake lines and hoses
 _ Brake linings/drums and brake pads/discs5
 _Drive shaft boots (4WD)
 _Engine coolant6
 _Exhaust pipes and mountings _  Front differential oil (4WD) 
Additional Maintenance Items for Special Operating Conditions3
Driving on dirt roads or dusty roads:Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading:7
Replace front differential oil (4WD)
Replace rear differential oil
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body
Dealer Service verification:
Date:Mileage:
 
 _ fuel lines and connections, fuel tank band  and fuel tank vapor vent system hoses
 _fuel tank cap gasket
 _radiator and condenser
 _rear differential oil
 _Steering gear
 _Steering linkage and boots
 _transfer case oil (4WD)
1  inspect sealed transmissions, transfer cases and differentials for signs of leakage. if any leakage from a sealed  component is suspected, it is recommended that you have the sealed component inspected by a toyota dealer. inspect power steering fluid (if equipped) and brake fluid level/condition. inspect engine and inverter (if equipped) coolant  level/condition/freezing point. Your dealer may recommend services (Dealer-recommended Maintenance) based on inspection results.2   reset the oil replacement reminder light (“Maint reQD”) or the message “oil Maintenance reQUireD” on the  multi-information display after maintenance at every 5,000 miles.3 Perform these service items only if you drive primarily under the conditions indicated. 4 includes operating on roads which road salt has been applied.5  inspect thickness measurement and disc runout.6     refer to “engine coolant” in the “explanation of Maintenance items” section in the back of this guide for more information.7 not all vehicles are designed for towing. refer to your vehicle Owner’s Manual for details.
114136_18-TCS-11409_WMG_MY19_4Runner_GUTS_F_4_tg_R1.indd   417/3/18   10:40 AM 

45Maintenance Log
MAINTENANCE LOG
MAINTENANCE
60,000 miles or 72 months
Check installation of driver’s floor mat
Inspect and adjust all fluid levels1
Inspect wiper blades
Lubricate propeller shaft  
Re-torque propeller shaft bolt
Replace cabin air filter
Replace engine air filter
Replace engine oil and oil filter2
Rotate tires
Inspect the following: _ Automatic transmission for signs of leakage _Ball joints and dust covers _Brake lines and hoses _ Brake linings/drums and brake pads/discs5
 _Drive belts6
 _Drive shaft boots (4WD)  _Engine coolant7
 _Exhaust pipes and mountings
 _Front differential oil (4WD)   
Additional Maintenance Items for Special Operating Conditions3
Driving on dirt roads or dusty roads:Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading:8
Replace automatic transmission fluid
Replace front differential oil (4WD)
Replace rear differential oil
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body  Dealer Service verification:
Date:Mileage:
 1  inspect sealed transmissions, transfer cases and differentials for signs of leakage. if any leakage from a sealed  component is suspected, it is recommended that you have the sealed component inspected by a toyota dealer. inspect power steering fluid (if equipped) and brake fluid level/condition. inspect engine and inverter (if equipped) coolant  level/condition/freezing point. Your dealer may recommend services (Dealer-recommended Maintenance) based on inspection results.2   reset the oil replacement reminder light (“Maint reQD”) or the message “oil Maintenance reQUireD” on the  multi-information display after maintenance at every 5,000 miles.3 Perform these service items only if you drive primarily under the conditions indicated. 4 includes operating on roads which road salt has been applied.5  inspect thickness measurement and disc runout.6  initial inspection at 60,000 miles/ 72 months. inspect every 15,000 miles/18 months thereafter. 7     refer to “engine coolant” in the “explanation of Maintenance items” section in the back of this guide for more information.8 not all vehicles are designed for towing. refer to your vehicle Owner’s Manual for details.
 _ Fuel lines and connections, fuel tank band   and fuel tank vapor vent system hoses _Fuel tank cap gasket _Radiator and condenser _Rear differential oil _Steering gear _Steering linkage and boots _Transfer case oil (4WD)
114136_18-TCS-11409_WMG_MY19_4Runner_GUTS_F_4_tg_R1.indd   457/3/18   10:40 AM 

49Maintenance Log
MAINTENANCE LOG
MAINTENANCE
90,000 miles or 108 months
Check installation of driver’s floor mat
Inspect and adjust all fluid levels1
Inspect wiper blades
Lubricate propeller shaft  
Re-torque propeller shaft bolt
Replace cabin air filter
Replace engine air filter
Replace engine oil and oil filter2
Rotate tires
Inspect the following: _ Automatic transmission for signs of leakage _Ball joints and dust covers _Brake lines and hoses _ Brake linings/drums and brake pads/discs5
 _Drive belts _Drive shaft boots (4WD)  _Engine coolant6
 _Exhaust pipes and mountings
 _Front differential oil (4WD)   
Additional Maintenance Items for Special Operating Conditions3
Driving on dirt roads or dusty roads:Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading:7
Replace front differential oil (4WD)
Replace rear differential oil
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body  
Dealer Service verification:
Date:Mileage:
 
 _ fuel lines and connections, fuel tank band  and fuel tank vapor vent system hoses _fuel tank cap gasket _radiator and condenser _rear differential oil _Steering gear _Steering linkage and boots _transfer case oil (4WD)
1  inspect sealed transmissions, transfer cases and differentials for signs of leakage. if any leakage from a sealed  component is suspected, it is recommended that you have the sealed component inspected by a toyota dealer. inspect power steering fluid (if equipped) and brake fluid level/condition. inspect engine and inverter (if equipped) coolant  level/condition/freezing point. Your dealer may recommend services (Dealer-recommended Maintenance) based on inspection results.2   reset the oil replacement reminder light (“Maint reQD”) or the message “oil Maintenance reQUireD” on the  multi-information display after maintenance at every 5,000 miles.3 Perform these service items only if you drive primarily under the conditions indicated. 4 includes operating on roads which road salt has been applied.5  inspect thickness measurement and disc runout.6     refer to “engine coolant” in the “explanation of Maintenance items” section in the back of this guide for more information.7 not all vehicles are designed for towing. refer to your vehicle Owner’s Manual for details.
114136_18-TCS-11409_WMG_MY19_4Runner_GUTS_F_4_tg_R1.indd   497/3/18   10:40 AM 

53Maintenance Log
MAINTENANCE LOG
MAINTENANCE
120,000 miles or 144 months
Check installation of driver’s floor mat
Inspect and adjust all fluid levels1
Inspect wiper blades
Lubricate propeller shaft  
Re-torque propeller shaft bolt
Replace cabin air filter
Replace engine air filter
Replace engine oil and oil filter2
Replace spark plugs5 
Rotate tires
Inspect the following: _ Automatic transmission for signs of leakage _Ball joints and dust covers _Brake lines and hoses _ Brake linings/drums and brake pads/discs6
 _Drive belts _Drive shaft boots (4WD)  _Engine coolant7
 _Exhaust pipes and mountings
 _Front differential oil (4WD)   
Additional Maintenance Items for Special Operating Conditions3
Driving on dirt roads or dusty roads:Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading:8
Replace automatic transmission fluid
Replace front differential oil (4WD)
Replace rear differential oil
Replace transfer case oil (4WD)
Tighten nuts and bolts on chassis and body 
Dealer Service verification:
Date:Mileage: 
1  inspect sealed transmissions, transfer cases and differentials for signs of leakage. if any leakage from a sealed  component is suspected, it is recommended that you have the sealed component inspected by a toyota dealer. inspect power steering fluid (if equipped) and brake fluid level/condition. inspect engine and inverter (if equipped) coolant  level/condition/freezing point. Your dealer may recommend services (Dealer-recommended Maintenance) based on inspection results.2   reset the oil replacement reminder light (“Maint reQD”) or the message “oil Maintenance reQUireD” on the  multi-information display after maintenance at every 5,000 miles.3 Perform these service items only if you drive primarily under the conditions indicated. 4 includes operating on roads which road salt has been applied.5  Maintenance services of spark plugs are required under the terms of the emissions control Warranty.6  inspect thickness measurement and disc runout.7     refer to “engine coolant” in the “explanation of Maintenance items” section in the back of this guide for more information.8 not all vehicles are designed for towing. refer to your vehicle Owner’s Manual for details.
 _ Fuel lines and connections, fuel tank band  and fuel tank vapor vent system hoses _Fuel tank cap gasket _Radiator and condenser _Rear differential oil _Steering gear _Steering linkage and boots _Transfer case oil (4WD)
114136_18-TCS-11409_WMG_MY19_4Runner_GUTS_F_4_tg_R1.indd   537/3/18   10:40 AM 

56Maintenance Log
MAINTENANCE
EXPLANATION OF MAINTENANCE ITEMS
Engine Oil and Oil Filter
Replace the oil filter and drain and refill  
the engine oil at specified intervals. For 
recommended oil grade and viscosity,  
refer to the Owner’s Manual. 
NOTE: Your vehicle is certified with  
Genuine Toyota 0W-20 motor oil. For  
VEHICLES CERTIFIED FOR 0W-20 motor  
oil, the oil change interval is 10,000 miles  
or 12 months IF 0W-20 MOTOR OIL IS  
BEING USED. If 0W-20 is not available,  
5W-20 mineral oil may be used. However,  
it must be replaced at a 5,000-miles or  
six-month INTERVAL with 0W-20 motor oil. 
For customers who primarily drive their  
vehicle under any of the listed Special 
Operating Conditions, the motor oil and  
filter should be replaced at 5,000 miles or  
six months, REGARDLESS OF THE OIL USED 
(OR CERTIFICATION OF THE VEHICLE).
Exhaust Pipes and Mountings 
Visually inspect the exhaust pipes, muffler  
and hangers for cracks, deterioration and 
damage. Start the engine and listen  
carefully for any exhaust gas leakage.  
Tighten connections or replace parts  
as necessary.
Front and Rear Differential Oil
Inspect or replace at specified intervals. 
When performing inspections, check each 
component for signs of leakage. If you 
discover any leakage, have it repaired by a 
qualified technician immediately.
Fuel Lines and Connections,   
Fuel Tank Band and Fuel Tank 
Vapor Vent System Hoses
Visually inspect for corrosion, damage,  
cracks, and loose or leaking connections.  
Tighten connections or replace parts  
as necessary.
Fuel Tank Cap Gasket
Visually inspect for cracks, deterioration  
and damage and replace if necessary.
Nuts and Bolts on Chassis   
and Body
Retighten the seat-mounting bolts and  
front /rear suspension member retaining  
bolts to specified torque.
Propeller Shaft
Lubricate the propeller shaft spiders and   
slide yokes with lithium-base chassis 
grease and the double cardan joint with 
molybdenum-disulfide lithium-base  
chassis grease, and re-torque the bolt.  
Only a qualified technician should perform  
this operation.
Radiator and Condenser
Inspect for debris, corrosion and signs 
of damage. Have any problem repaired 
immediately by a qualified technician.
Spark Plugs
Replace at specified intervals. Install new 
plugs of the same type as originally  
equipped. A qualified technician should 
perform this operation.
114136_18-TCS-11409_WMG_MY19_4Runner_GUTS_F_4_tg_R1.indd   567/3/18   10:40 AM