2019 SUBARU WRX lock

2
Remote Keyless Entry
Keyless Access and
Push-Button Start
(if equipped)
By simply carrying the access key in your pocket, you can
lock and unlock doors, open the trunk and start your car
without ever having to take the key fob out of your pocket.
1 Lock/Arm
• Press to lock all doors and trunk.
• If any of the doors or the trunk are
not fully closed, five rapid chirps
will sound and the hazard lights will
flash to alert you that the doors or
the trunk are not properly closed.
• To activate the vehicle finder function,
press three times (within five seconds).
If you are within 30 feet of the vehicle,
the horn will sound one time and the
hazard lights will flash three times.
2 Unlock/Disarm
• Press once to unlock the driver’s door.
• Press twice (within five seconds) to
unlock all doors.
• When the “Unlock/Disarm” button is
pressed, the dome and map lights will
illuminate if the dome light switch is in
the middle position and the map light
switch is in the “on” position.
3 Unlocking the Trunk
• Press to unlock the trunk.
4 Panic Alarm
• Press once and the horn will sound
and the hazard lights will flash.
• Press any button on the remote
to deactivate.
1
23
4
1
2
3
4
3572136_19b_WRX_WRX_STI_QG_061118.indd 26/11/18 5:06 PM

5
Folding the Rear Seats
Lower the headrests. Pull up on the release
knob on the seat side that you want to fold
down. To return the seatback to its original
position, raise the seatback until it locks into
place, making sure that it is securely locked.
Getting
Started
3572136_19b_WRX_WRX_STI_QG_061118.indd 56/11/18 5:06 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

7
Instrument Panel
14-15
17
Clock
Use the multi-function display controls to set
the time. Vehicles with a navigation system,
please refer to the separate “Operating
Instructions for Navigation System.”
Instrument
Panel
3572136_19b_WRX_WRX_STI_QG_061118.indd 76/11/18 5:06 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

10
Tilt and Telescopic Steering Column
Pull the lever down firmly to adjust the height and lengthwise positio\
n of the column;
firmly push the lever back up to lock the column in place. Do not adju\
st while driving.
Power Exterior Mirrors
Turn the knob to the “L” side to adjust the left-hand mirror or to the “R” side to adjust the
right-hand mirror. Move the knob in the direction you want to move the mirror. Then return
the knob to the neutral/center position.
Personalize
i/SET Combination Meter Display Controls
Use the i/SET controls to display and switch selected items in the Combination Meter
Display located between the tachometer and speedometer. Please refer to your Owner’s
Manual for details on these controls.
3572136_19b_WRX_WRX_STI_QG_061118.indd 106/11/18 5:07 PM

11
Power Moonroof (if equipped)
With the moonroof in the fully closed position, press the switch 2 to tilt the rear of
the moonroof up. Press and hold the switch
1 to lower the moonroof. Press the
switch
4 to open the moonroof to the midway position; press it again to fully open
it. Press the switch
3 to close the moonroof. To stop the moonroof in a midway
position while opening or closing, momentarily press either switch
3 or 4.
1
2
3
4
Personalize
HomeLink® 5 Accessory Mirror (if equipped)
The HomeLink 5 accessory mirror provides three buttons to replace up to three
hand-held radio frequency remotes used to activate devices such as garage door
openers, gate openers, entry door locks, security systems and home light\
ing.
Please see your Owner’s Manual for programming instructions or visit
www.subaru.com/homelink to view a how-to video.
3572136_19b_WRX_WRX_STI_QG_061118.indd 116/11/18 5:07 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

14
Controls
Located in the multi-function
display; top center of dashAutomatic Climate
Control System
(WRX Only)
1 Automatic On and Off
This system automatically controls
outlet air temperature, fan speed, air
flow distribution, air inlet control, and air
conditioner compressor operation. Press
“AUTO” to activate. Press “OFF” to turn
off the system.
2 Temperature Control Dial
Rotate the dial clockwise to increase
the temperature or rotate the dial
counterclockwise to decrease the
temperature and maintain a comfortable
climate within the driver and passenger
compartment. The temperature is
displayed digitally on the screen.
Operation in Manual Mode
3 Recirculated/Outside Air Button
Press the air inlet selection button to
prevent outside air from being drawn
into the passenger compartment. Press
the button again to allow outside air
into the compartment. TO PREVENT
WINDSHIELD FOGGING, DO NOT
REMAIN IN THE RECIRCULATED MODE
FOR AN EXTENDED PERIOD OF TIME.
4 Fan Speed Control Knob
Rotate the fan speed control knob to
select the desired fan speed.
5 Air Flow Mode Selection Dial
Turn the “MODE” dial to select the
desired air flow mode. The selected air
flow mode – either ventilation, bi-level,
heat or heat-defrost – is shown on
the display.
6 Air Conditioner Button
Press the “A/C” button to activate the air
conditioning. Press it again to turn off the
air conditioning.
7 Defroster Button
Press the button to defrost or dehumidify
the windshield and front door windows.
8 Rear Window Defogger Button
Press the button to turn on the defogger.
It will automatically shut off after about 15
minutes. If the window clears before that
time, you can press the button again to
turn it off. If equipped, the outside mirror
defogger and windshield wiper deicer will
also activate.
17
342
8
6
5
3572136_19b_WRX_WRX_STI_QG_061118.indd 146/11/18 5:07 PM

15
Dual Zone Automatic
Climate Control System
(WRX STI only)
1 Automatic On and Off
This system automatically controls
outlet air temperature, fan speed,
air flow distribution, air inlet control,
and air conditioner compressor
operation. Press “AUTO” to activate.
Press “OFF” to turn off the system.
2 Temperature Control Dial
Rotate the dial clockwise to increase
the temperature or rotate the dial
counterclockwise to decrease
the temperature and maintain a
comfortable climate within the driver
and passenger compartment. The
temperature is displayed digitally on
the screen.
Separate temperature settings can
be adjusted for the driver’s side and
passenger’s side.
Operation in Manual Mode
3 Recirculated/Outside Air Button
Press the air inlet selection button to
prevent outside air from being drawn
into the passenger compartment.
Press the button again to allow
outside air into the compartment.
TO PREVENT WINDSHIELD
FOGGING, DO NOT REMAIN IN THE
RECIRCULATED MODE FOR AN
EXTENDED PERIOD OF TIME.
4 Fan Speed Control Knob
Rotate the fan speed control knob
to select the desired fan speed.
5 Air Flow Mode Selection Button
Press the “MODE” button to select
the desired air flow mode. The
selected air flow mode – either
ventilation, bi-level, heat or heat-
defrost – is shown on the display.
6 Dual Button
Press the “DUAL” button to
activate or deactivate the dual
mode. Dual mode makes it
possible to have separate
temperature settings for the driver’s
side and passenger’s side.
7 Air Conditioner Button
Press the “A/C” button to activate
the air conditioning. Press it again
to turn off the air conditioning.
8 Defroster Button
Press the button to defrost or
dehumidify the windshield and
front door windows.
9 Rear Window Defogger Button
Press the button to turn on the
defogger. It will automatically shut
off after about 15 minutes. If the
window clears before that time,
you can press the button again to
turn it off. If equipped, the outside
mirror defogger and windshield
wiper deicer will also activate.
Controls
Located in the multi-function
display; top center of dash
18
3
2
6
9
7
5
4
3572136_19b_WRX_WRX_STI_QG_061118.indd 156/11/18 5:07 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

23
Driver Control Center Differential (DCCD)
(WRX STI only)
This electronically controlled system
adjusts the power-distribution ratio
between the front and rear wheels.
The system is designed to provide
optimum differential control for
improved vehicle cornering, stability,
and handling control to suit driving and
road surface conditions. The DCCD
can be operated automatically or
manually. When the system is in the
automatic mode, the “AUTO” indicator
light in the combination meter comes
on. The DCCD can be taken out of
“AUTO” mode and used manually by
pressing the “AUTO MANU” switch
located on the center console. Use the
DCCD control switch located on the
center console for manual operation. Pressing the “AUTO MANU” switch
again will return the system to “AUTO”
mode. When using the system
manually, if the control switch is set
closer to or at the “Lock” position,
the powertrain may make a vibration
or noise when the vehicle is in tight
turns at slow speeds (system binding).
In addition, if the rear differential
oil exceeds a certain temperature,
the DCCD will automatically cancel
the current torque-distribution ratio
setting and adopt its minimum ratio.
SI-Drive (WRX STI only)
Turn the selector toward S for Sport mode or toward S# for Sport Sharp mode.
Press down on the selector for Intelligent mode.
While
Operating
3572136_19b_WRX_WRX_STI_QG_061118.indd 236/11/18 5:08 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information