2019 SUBARU FORESTER light

2
Remote Keyless Entry
Keyless Access with
Push-Button Start System
(if equipped)
By simply carrying the access key in your pocket, you can
lock and unlock doors, open the rear gate and start your car
without ever having to take the key fob out of your pocket.
1 Lock/Arm
• Press to lock all doors and the rear gate.
• If any of the doors or the rear gate
are not fully closed, five rapid chirps
will sound and the hazard lights will
flash to alert you that the doors or the
rear gate are not properly closed.
• To activate the vehicle finder function,
press three times (within five seconds).
If you are within 30 feet of the vehicle,
the horn will sound one time and the
hazard lights will flash three times.
2 Unlock/Disarm
• Press once to unlock the driver’s door.
• Press twice (within five seconds) to
unlock all doors.
• When the “Unlock/Disarm” button is
pressed, the dome and map lights will
illuminate if the dome light switch is in
the middle position.
3 Unlocking the Rear Gate
• Press to unlock the rear gate.
4 Panic Alarm
• Press once and the horn will sound
and the hazard lights will flash.
w Press any button on the remote
to deactivate.
1
23
4
1
2
3
4
3495150_19a_Subaru_Forester_QRG_070318.indd 27/3/18 1:06 PM

8
Trip meter reset button
Gauges
Forester
Forester Premium
Forester Sport
Forester Limited
Forester Touring
Immediate Attention

Caution
Informational
Tachometer
Fuel gauge
Seatbelt warning
Front passenger seatbelt
warning (Located on
overhead console)
SRS airbag system
Security indicator light
Charge warning
Oil pressure warning
Power steering warning
Brake system
Hot coolant temperature/
Cold coolant temperature
High beam indicator light
AT OIL TEMP
ABS warning
Low fuel
All-Wheel Drive
3495150_19a_Subaru_Forester_QRG_070318.indd 87/3/18 1:06 PM

9
Gauges
Speedometer
Trip meter and odometer
Auto Vehicle Hold operation
Vehicle Dynamics Control/
Vehicle Dynamics Control
operation
Vehicle Dynamics Control OFF
CHECK ENGINE/
Malfunction indicator
Tire pressure warning light
Front passenger airbag ON
(Located on center console)
Front passenger airbag OFF (Located on center console)
Pre-Collision Braking
System OFF light
Lane Departure Warning OFF light
Auto Vehicle Hold ON
Turn signals
Front fog light indicator
light (if equipped)
Headlight indicator light
3495150_19a_Subaru_Forester_QRG_070318.indd 97/3/18 1:06 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

10
Personalize
Tilt and Telescopic Steering Column
Pull the lever down firmly to adjust the height and lengthwise positio\
n of the column; firmly
push the lever back up to lock the column in place. Do not adjust while \
driving.
Heated Steering Wheel (if equipped)
To activate, pull the Heated Steering Wheel switch while the ignition is \
in the ON position.
The indicator light on the switch will illuminate.
To deactivate, pull the Heated Steering Wheel switch again.
i/SET Combination Meter Display Controls
Use the controls to display and switch selected items in the combination meter displa\
y.
Please refer to your Owner’s Manual for details on these controls.
3495150_19a_Subaru_Forester_QRG_070318.indd 107/3/18 1:06 PM

11
Power Exterior Mirrors
Turn the knob to the “L” side to adjust the left-hand mirror or to the “R” side to
adjust the right-hand mirror. Move the knob in the direction you want to move the
mirror. Then return the knob to the neutral/center position.
Power Moonroof (if equipped)
With the moonroof in the fully closed position, press the switch 1 to fully open
the moonroof. Press the switch
2 to close the moonroof. To stop the moonroof
in a midway position while opening or closing, momentarily press the switch to the
1 side or 2 side.
1
2
Personalize
HomeLink® 5 Accessory Mirror (if equipped)
The HomeLink 5 accessory mirror
provides three buttons to replace up
to three hand-held radio frequency
remotes used to activate devices
such as garage door openers,
gate openers, entry door locks,
security systems and home lighting.
Please see your Owner’s Manual for
programming instructions or visit
www.subaru.com/homelink to
view a how-to video.
3495150_19a_Subaru_Forester_QRG_070318.indd 117/3/18 1:07 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

12
Controls
While the light switch is on, rotate the dial downward to dim the instrument panel illumination. Rotate the dial upward to make the illumination brighter. When the dial is fully rotated upward
(dots aligned), the instrument panel illumination stays at full bright\
ness.
Light Controls

Turns on instrument panel
lights, tail lights, parking lights
and license plate lights.
Turns on headlights, instrument
panel illumination, parking lights,
tail lights and license plate lights.
Rotate to
turn on
fog lights
(if equipped).AUTO: The vehicle’s lights are
automatically on or off, depending
on the level of outside light.
Push forward to change from low
beam to high beam. Pull the lever
back to center to return to low beam.
Push slightly down
for lane change
or fully down for
left turn signal.
Push slightly up
for lane change
or fully up for
right turn signal.
3495150_19a_Subaru_Forester_QRG_070318.indd 127/3/18 1:07 PM

13
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you. Rotate the dial to adjust the intermittent
wiper speed.
To operate the rear wiper, rotate the end of the knob upward to the intermittent,
continuous, or wash position. When the rear wiper is off, rotate the knob downward
to wash and wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only the front daytime running
lights will be automatically turned on when the engine has started, the parking
brake is fully released and the light switch is in the “OFF”, “AUTO” or “\
”
position. The brightness of the illumination of the high beam headlights\
is reduced
by the daytime running light system. You must always switch on your headlights
when it is dark outside by turning the light switch to the “
” position or have the
switch in the “AUTO” position.
1
2
3
INT.
LOW
HIGH
OFF
Controls
3495150_19a_Subaru_Forester_QRG_070318.indd 137/3/18 1:07 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

20
While Operating
Paddle Shift Control Switches (if equipped)
• Temporary use: Even when the selector is in the
“D” (Drive) position, you can temporarily shift the
gear by pulling the “+” or “–” paddle shift control
switch. The transmission will automatically
switch back to Normal Mode.
• When the selector lever is in Manual Mode,
shift to the next higher gear by pulling the “+” paddle shift cont\
rol switch on the steering
wheel. Pull the “–” paddle shift control switch to shift into the next lower gear.
Manual Shifting Operation
Arrow-shaped lights in the center of the instrument panel show whether an u\
pshift is possible
and whether a downshift is possible.
Instrument Panel Switches (lower left)
Please refer to your Owner’s Manual for details on these switches.
1 Power rear gate switch (if equipped)
2 Steering Responsive Headlights OFF switch (if equipped)
3 Rear gate memory switch (if equipped)
4 Vehicle Dynamics Control OFF switch
5 Auto Start Stop OFF switch
6 Blind Spot Detection/Rear Cross Traffic Alert OFF switch (if equipped)
7 Driver Monitoring System OFF switch (if equipped)
1
45
32
76
3495150_19a_Subaru_Forester_QRG_070318.indd 207/3/18 1:07 PM