Page 8 of 31
6
Immediate Attention
Caution
Informational
Gauges
Seatbelt warning
Front passenger
seatbelt warning
(Located on center console)
SRS airbag system
Security
indicator light
Door open
Charge warning
Oil pressure warning
Power steering warning Brake system
REV indicator
High beam indicator light
AT OIL TEMP
(Automatic transmission)
ABS warning
Low fuel
SNOW indicator
(Automatic transmission)
Speedometer Tachometer
Outside temperature, trip meter and odometer
BRZ Premium
3514335_19a_BRZ_QRG_072318.indd 67/23/18 4:48 PM
Page 10 of 31
8
Immediate Attention
Caution
Informational
Gauges
Seatbelt warning
Front passenger
seatbelt warning
(Located on center console)
SRS airbag system
Security
indicator light
Door open
Charge warning
Oil pressure warning
Power steering warning REV indicator
Brake system
Hot coolant temperature/
Cold coolant temperature
High beam indicator light
AT OIL TEMP
(Automatic transmission)
ABS warning
Low fuel
Speedometer Tachometer
BRZ Limited
3514335_19a_BRZ_QRG_072318.indd 87/23/18 4:48 PM
Page 15 of 31
13
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you. Rotate the dial to adjust the intermittent
wiper speed.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only the front daytime
running lights will be automatically turned on when the engine has started,
the parking brake is fully released and the light switch is in the “OFF,” “AUTO”
(if equipped) or “
” position. The brightness of the illumination of the high
beam headlights is reduced by the daytime running light system. You must
always switch on your headlights when it is dark outside by turning the light
switch to the “
” position or have the switch in the “AUTO” position.
OFF
1
2
3
INT.
LOW
HIGH
Controls
3514335_19a_BRZ_QRG_072318.indd 137/23/18 4:49 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
Page 21 of 31
19
Cruise Control
Increase speed
Push the lever up to the “RES” side;
hold until your vehicle reaches the
desired speed and release. To increase
speed using the accelerator pedal,
press the pedal until you reach the
desired speed. Push the lever down
to the “SET” side to set the speed. Decrease speed
Push the lever down to the “SET”
side; hold until your vehicle slows to
the desired speed and release. To
decrease the speed using the brake
pedal, press the pedal to release cruise
control temporarily. When the speed
decreases to the desired speed, push
the lever down to the “SET” side to set
the speed.
To cancel the cruise control, pull the
lever toward you, push the brake
pedal or press the “ON-OFF” button.
If you have a manual transmission,
you can push in the clutch pedal.
Press the accelerator pedal until
your vehicle reaches the desired
speed. Push the lever down to the
“SET” side and release. Ease off
the accelerator pedal. Your vehicle
will maintain the desired speed.
To activate the cruise control,
press the “ON-OFF” button. The
cruise control indicator light on
the instrument panel will turn
on. To deactivate cruise control,
press the “ON-OFF” button again.
To resume your speed after
canceling, push the lever
up to the “RES” side.Controls
3514335_19a_BRZ_QRG_072318.indd 197/23/18 4:50 PM
Getting
Started Instrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
