3
Seating
Getting
Started
Power Driver’s Seat (if equipped)
1 Forward/Backward,
Angle and Height
Move the switch toward the front
or rear to move the seat forward
or backward. Pull the switch up
or push down on the front of the
switch to adjust the angle of the
seat cushion. Pulling the switch
straight up or pushing the switch
straight down will adjust the height
of the entire seat cushion.
2 Seatback
Move the switch in the
corresponding direction to adjust the
angle of the seatback.
3 Lumbar Support (if equipped)
Press the front part of the switch
to increase lumbar support;
press the rear part of the switch
to decrease lumbar support.
4 Thigh Extension (if equipped)
Pull up on the lever below the
front of the driver’s seat to adjust
the length.
3
2
1
Memory Driver’s Seat (if equipped)
While pressing the “SET” button, press and hold the desired button “1” or “2”.
A beep sounds when the seat position is registered. Press button “1” or “2” to
retrieve the seat positions.
4
3422055_19a_Subaru_Ascent_QRG_032118.indd 33/21/18 10:48 AM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information
