2019 SKODA KAMIQ light

Lighting, windscreen wipers and
washers
Exterior lighting Functionality
Unless otherwise stated, the light works when the
ignition is switched on.
Daytime running lights
The daytime running lights illuminate the area in
front of the vehicle.
For vehicles for certain markets, they also illuminate
the rear vehicle area.
Operating conditions
q The lights switch is in position
, or .
Switching the low beam on/off automatically
The low beam is automatically switched on or o

Fog light1
Fog light - lights up
2
Rear fog light - lights
up

Or:

Troubleshooting
Turn signal light defectiveflashes faster - turn signal light on the right de-
fective

Replace light bulbs
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
NOTICE
Danger of headlight damage due to the ingress of
water and dirt!

Reversing lights

Messages in relation to faults can also be displayed in
the Infotainment.
The warning messages will continue to be dis-
played until the malfunctions have been remedied.
After the message is displayed for the first time, only
the indicator lights
(Hazard) or (Warning) re-
main displayed.
Infotainment Swing
Infotainment overviewATouchscreenRotary control on the left

Automatic gearbox
Lever positions
Parked vehicle The drive wheels are
locked.
Only set the posi-
tion when the vehi- cle is stationary.
Reverse gear
Only set the posi-
tion when the vehi- cle is stationary.
Neutral
There is no transmission of engine power to the
wheels.
Forward drive / sports program
The gear is changed automatically.
Choose between and (spring-loaded posi-
tion)
In
mode, the gear is changed at higher speeds
than in mode.
Moving the selector lever out of the
or position
lights up - the selector lever is locked

Operating conditions
qFront Assist activated.
q Driving speed between 5-60 km/h.
Speed limiter Functionality
The speed limiter controls the maximum driving
speed according to the set speed limit.
If the limit is exceeded when driving downhill, brake
the vehicle with the brake pedal.
Status display in the instrument cluster display - Speed limiter is activated
When the control starts,
is highlighted and the
set limit is displayed.
illuminated - Control is active
flashing - the set limit is exceeded
Operating conditions
q The driving speed is higher than 30 km/h.
Operation
Variant without GRA
A Activate limiter (control inactive)
Deactivate limiter
Interrupt control (sprung position)
B Resume control 1)
/Increase limitC Start control with current speed/Reduce
limitVariant with GRAA Activate GRA (condition for the subsequent
activation of the limiter).
To activate the speed limiter , press button D
or
E
.
Deactivate limiter
Interrupt control (sprung position)
B Resume control1)
/Increase limitC Start control with current speed/Reduce
limitDDepending on the equipment:
Switch between GRA and speed limiter
Or:
Show menu of assist systems - Possibility of
switching between GRA and speed limiter
Switching to GRA interrupts the control.
EShow menu of assist systems - Possibility of
switching between GRA and speed limiter
Switching to GRA interrupts the control.
Adjusting the speed limit with the buttons
B
and
C
By pressing in steps of 1 km/h.
By holding in steps of 10 km/h.
1)
If no speed limit is set, the current speed is set as the speed limit.
122Driver assist systems