2019 Seat Tarraco light

Lights
Interior lights Lighting of the instrument panel ,
displ ays and s wit
ches Fig. 99
Related video Depending on the model, the lighting of the
instrument panel and s
wit
ched can be adjus-
t ed in the Easy Connect syst
em, using the
butt on

> SETTINGS

Visibility
Mirrors Int erior mirr
or anti-dazzl e functionRear view mirror with automatic anti-daz-
zle function
The anti-dazzle function is activated ev
ery
time the ignition is s
witched on.
When the anti-dazzle function is enabled, the
interior rear vision mirror will darken auto-
matically according to the amount of light it
receives. The anti-dazzle function is cancel-
led if reverse gear is engaged. WARNING
In the event that an automatic anti-dazzle
rear vision mirror breaks, an electrolyt e flu-
id may l

eak. This could cause irritation to
the skin, eyes and respiratory organs. If you
come into contact with this liquid, it must
be rinsed with large quantities of water. If
necessary, get medial help. CAUTION
In the event that an automatic anti-dazzle
rear vision mirror breaks, an electrolyt e flu-
id may l

eak. This liquid attacks plastic sur- faces. Clean it with a wet sponge as soon
as possible.
Note

Operation
Radio-operated remote control Fig. 159
Auxiliary heating: radio-operated re-
mot e contr ol
. Fig. 159
Swit
ch the auxiliary heat er on
S wit ch the auxiliary heat
er off
Contr
ol lamp
If the buttons of the remote control are press-
ed unnecessarily, it could switch on the auxili-
ary heater involuntarily, even when it is out of
range or when the control lamp is flashing.
To switch on and off the independent heating,
the button must be pressed and held for ap-
proximately 1 second.
Control lamp on the remote control
When the buttons are pressed, the control
lamp on the remote control 1 provides the
user with diff er
ent inf ormation:


1 It lights up for approx. 2 seconds

Start and driving
In Start-Stop mode, the engine will automati-
cally s wit
ch off when the v ehicl
e stops or is
st opping. The ignition r
emains switched on.
The engine automatically switches back on
when required.
In this scenario, the light of the    button stays lit.
When the ignition is s
wit
ched on, the St art
-
St op function is aut
omatically activ

ated.
In the Easy Connect system you can find
more information about the Start-Stop sys-
tem: press the button  > View > Vehicle
status .
Vehicles with a manual gearbox

Start and driving
v
It lights up yellow
Limited steering operation.
Drive carefully to a specialised workshop to hav e the
st
eering checked.
If the warning light does not come on again after re-
starting the engine and driving a short distance, it is
not necessary to check the steering.
OR: The 12-volt battery was disconnected and re-
connect ed.
Driv

e a short distance at 15-20 km / h (9-12 mph). v
It flashes yellow
The steering column is jammed.
When stopped, turn the steering wheel in both direc-
tions.
OR: The st eering column does not unl

ock or lock.
Remove the key fr om the ignition s

witch and recon-
nect it. Consider the messages shown on the instru-
ment panel display.
Do not continue driving if the steering column re-
mains locked after switching on the ignition. Seek
specialist assistance. The control lamp should light up for a few
seconds when the ignition is s
wit
ched on. It
shoul d go out once the engine is st
arted. WARNING
Never ignore the warning lamps or messag-
es.

Driver assistance systems
WARNING
If the warning lamps and the corresponding
messages are ignored when they light up,
the vehicle may st all in tr
affic and cause
accidents and severe injuries.

Braking and parking
Using the blind spot detector (BSD)
with parking assist ant (RC
TA) Activating and deactivating the blind spot
detector (BSD) with parking assistant
(RCTA)
The blind spot det ect
or with parking assistant
can be switched on and off by accessing the
Assistance systems menu on the dash
panel display using the steering wheel con-
trols. If the vehicle is equipped with a multi-
function camera, it can also be accessed by
means of the driver assistance systems key
located on the main beam headlight lever.
Open the Assistants menu.

Braking and parking
and the anti-slip regulation (ASR 1)
) int erv
en-
tions ar e limit
ed. In addition, the 
contr
ol
lamp lights up on the instrument panel.
ESC in “Offroad” mode 2)
Turn the Driving Experience button to select
the Offroad mode and connect it