2019 Seat Tarraco lights

Lights
When the light switch is in position  

, a light
sensor aut omatically s wit
ches dipped beam
on and off (including the contr
ol and instru-
ment lighting) or the daytime running lights
depending on the level of exterior lighting.
Motorway light*
The function is connected and disconnected
via the corresponding Easy Connect system
menu.

Lights
Note

Lights
For vehicles without light and rain sensors.

Operation
5. For a manual gearbox, engage 1st gear; for an aut
omatic gearbo x, mo
ve the gear
l e
ver to P.
6. Use the warning triangle to draw the at- tention of other road users to your vehicle.
7.

Always take the vehicle key with you when
you leave the vehicle.
All turn signal

s flash simultaneously when the
hazard warning lights are switched on. The
two turn signal turn signal lamps   and the
turn signal lamp in the switch  will flash at
the same time. The simultaneous hazard
warning lights also work when the ignition is
switched off.
Emergency braking warning
If the vehicle brakes suddenly and continu-
ously at a speed of more than 80 km/h (50
mph), the brake light flashes several times per
second to warn the vehicles driving behind. If
you continue braking, the hazard warning
lights will come on automatically when the
vehicle comes to a standstill. They switch off
automatically when the vehicle starts to
move again. WARNING

Lights
Interior lights Lighting of the instrument panel ,
displ ays and s wit
ches Fig. 99
Related video Depending on the model, the lighting of the
instrument panel and s
wit
ched can be adjus-
t ed in the Easy Connect syst
em, using the
butt on

> SETTINGS

Operation
Radio-operated remote control Fig. 159
Auxiliary heating: radio-operated re-
mot e contr ol
. Fig. 159
Swit
ch the auxiliary heat er on
S wit ch the auxiliary heat
er off
Contr
ol lamp
If the buttons of the remote control are press-
ed unnecessarily, it could switch on the auxili-
ary heater involuntarily, even when it is out of
range or when the control lamp is flashing.
To switch on and off the independent heating,
the button must be pressed and held for ap-
proximately 1 second.
Control lamp on the remote control
When the buttons are pressed, the control
lamp on the remote control 1 provides the
user with diff er
ent inf ormation:


1 It lights up for approx. 2 seconds

Start and driving
v
It lights up yellow
Limited steering operation.
Drive carefully to a specialised workshop to hav e the
st
eering checked.
If the warning light does not come on again after re-
starting the engine and driving a short distance, it is
not necessary to check the steering.
OR: The 12-volt battery was disconnected and re-
connect ed.
Driv

e a short distance at 15-20 km / h (9-12 mph). v
It flashes yellow
The steering column is jammed.
When stopped, turn the steering wheel in both direc-
tions.
OR: The st eering column does not unl

ock or lock.
Remove the key fr om the ignition s

witch and recon-
nect it. Consider the messages shown on the instru-
ment panel display.
Do not continue driving if the steering column re-
mains locked after switching on the ignition. Seek
specialist assistance. The control lamp should light up for a few
seconds when the ignition is s
wit
ched on. It
shoul d go out once the engine is st
arted. WARNING
Never ignore the warning lamps or messag-
es.

Braking and parking
and the anti-slip regulation (ASR 1)
) int erv
en-
tions ar e limit
ed. In addition, the 
contr
ol
lamp lights up on the instrument panel.
ESC in “Offroad” mode 2)
Turn the Driving Experience button to select
the Offroad mode and connect it