2019 Seat Arona light

Driving
Emergency program A backup programme is in place if a fault
should occur in the control system.
If all the positions of the sel
ect
or lever are
shown over a light background on the instru-
ment panel display, there is a system fault
and the automatic gearbox will operate in
with the backup programme. When the back-
up programme is activated, it is possible to
drive the vehicle, however, at low speeds and
within a selected range of gears. In some ca-
ses driving in reverse gear may not be pos-
sible. CAUTION
If the gearbox operates with the backup
programme, t ak

e the vehicle to a special-
ised workshop and have the fault repaired
without delay. Indications on the instrument panel
displ
ay Clutch

Driving

It lights up
Fault in the management of the petrol engine.
Have the engine checked by a specialised workshop
as soon as possibl e
.
The warning lamp  (Electronic Pow
er Control)
lights up when the ignition is switched on while sys-
tem operation is being verified. It should go out once
the engine is started. 
It lights up
Diesel engine glow plug system.
The engine glow plug system has been activ at

ed.
The engine can be started straight away when the
lamp switches off. 
Flashes
Fault in the management of the diesel engine.
Have the engine checked by a specialised workshop
as soon as possibl e

.Note
While the control lamps are on , ;, 
or  there might be faults in the engine, fuel consumption may go up and the en-
gine might l ose po

wer. Catalytic converter
To maintain the useful life of the catalytic
converter

Driving
Driver assistance systems
St ar
t-St
op syst
em*
Control lamps 
It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is active. i
It lights up
The Start-Stop system is not available. Instructions for the driver on the instru-
ment panel displ
ay
Start-Stop system deactivated.
Start the engine manually
This driv er message is displ ayed when cer
-
t

ain conditions are not met during the stop-
ping phase and the Start-Stop system can-
not restart the engine. The engine must be
started manually.
Start-Stop system: Fault! Function
not available
There is a fault in the Start-Stop system. Take
the vehicle to a workshop to have the fault re-
paired. Description and operation
Fig. 224
Related video The Start-Stop system helps save fuel and
reduce CO
2 emissions.
In Start-St op mode

, the engine will automati-
cally switch off when the vehicle stops or is
stopping; for example when stopping at traf-
fic lights. The ignition remains switched on
during the stopping phase. The engine auto-
matically switches back on when required. In
this scenario, the light of the    button stays lit
1)
.
As soon as the ignition is s wit
ched on, the
St art
-St

op function is automatically activa-
ted.
Further information about the Start-Stop sys-
tem can be found on the Easy Connect sys-
tem: by pressing the button  /  in the Ve-
hicle status menu. Vehicles with a manual gearbox

Driver assistance systems
light up on the instrument panel, and the pro-
gr ammed speed and ACC st
atus will be dis-
pl ayed

Driving
Using the blind spot detector (BSD)
with parking assist ant (RC
TA) Activating and deactivating the blind spot
detector (BSD) with parking assistant
(RC T
A)
The blind spot detector with parking assistant
can be switched on and off by accessing the
Assistance systems menu on the dash
panel display using the steering wheel con-
trols. If the vehicle is equipped with a multi-
function camera, it can also be accessed by
means of the driver assistance systems key
located on the main beam headlight lever.
Open the Assistants menu.

Checking and refilling levels
means, for example, a proportion of bio-
diesel of max. 7%.
Nat ur
al gas : “CNG” means
C
ompressed
Natural Gas.
Type of petrol  Applies to vehicles: with petrol engine
The correct grade of petr ol is list

ed inside the
fuel tank flap.
The vehicle is equipped with a catalytic con-
verter and must only be run on unleaded
petrol. The petrol must comply with the
standard EN 228 and be sulphur-free. Fuels
with a 10% ethanol ratio can be refuelled
(E10) 1)
. The types of petrol are differentiated
by using the octane numbers (RON) or via
the anti-knock index (AKI).
The following pieces of text show the infor-
mation included in the corresponding stickers
on the tank lid (examples):
Super unleaded petrol 95 octane petrol or
normal 91 octane petrol at least
We recommend refuelling with super 95 oc-
tane petrol (91 AKI). If not available: normal 91 3 octane petrol (87 AKI) (with a slight power
l
oss).
Super unl eaded petr ol, 95 oct
anes at
l

east
You should use super 95 octane petrol (91
AKI) at least.
If super is not available, if necessary, use nor-
mal 91 octane petrol (87 AKI). In this case only
use moderate engine speeds and a light
throttle. Refuel with super as soon as possi-
ble.
Unleaded super plus 98 octane petrol or
super 95 octane petrol at least
We recommend refuelling with super plus 98
octane petrol (93 AKI). If not available: super
95 octane petrol (91 AKI) (with a slight power
loss).
If super is not available, if necessary, use nor-
mal 91 octane petrol (87 AKI). In this case only
use moderate engine speeds and a light
throttle. Refuel with super as soon as possi-
ble. CAUTION

Maintenance
Problem Solution
Care Apply preservative cream regu-
larly to protect fr
om sunlight.
Use a colour preservative if re-
quired a)
Neutral soap solution: two tablespoons maximum in
1 litre of water
Carbon fibr e par

tsProblem Solution
Dirt Clean like plastic partsTake special care with...
Headlights/tail lights

Technical data
Wheels Tyr
e pr essur
e and wheel bolts Tyre pressure
The sticker with the tyre pr
essur
e values can
be found on the back of the left front door
frame. The tyre pressure values given there
are for cold tyres. Do not reduce the slightly
raised pressures of warm tyres