2019 Seat Alhambra light

Fuses and bulbs
To replace the xenon headlight
bulb Fig. 109
In the engine compartment: turning
light co ver
. Fig. 110
Turn signal bulb holder 1 and turning
light 2 .
There is no need to remove the headlight to
r
epl ace bulbs.
Compl

ete operations only in the sequence
given: Turn signals
1 Turning lights
2 1. Open the bonnet

Fuses and bulbs
Replacing the rear bulbs in the
body Fig. 115
On the side of the boot: removing the
l eft and right hand side r ear lights. 1 remove
the cap; 2 attachment screw Fig. 116
Tail light on the bodywork: detach the
bulb hol der. 1 a
4 : lock latches.
Complete operations only in the sequence
giv
en.
R emo
ving the rear light units
Complete operations only in the sequence
given: Rear light, left Rear light, right
1. Open the rear lid

Emergencies
Rear light, left Rear light, right
13. Carefully insert the tail light unit into the open-
ing in the bodywork . T
o do this, insert the up-
per rear light unit guide into the attachment ring.
14. Tighten the white attachment screw using the
screw

driver from the vehicle tool kit.
15. Ensure that the tail light unit has been correct-
ly fitted and is firmly secur ed.
16. R

eplace the cap

Fuses and bulbs

Fixed number
plat e light Bolt
ed number
plate light
7. Plug the connect
or in-
to the bulb hol der

.Press on the attach-
ment tabs. The bulb
hol
der must be firmly
att

ached to the num-
ber plate light.
8. Insert the number plate light carefully into the
opening on the bumper. Ensur e that the number
pl

ate light is in the correct position.
9. Insert the number
plat
e light int

o the
bumper until it audibly
clicks into place. Tighten the attach-
ment screws f
or the
number plate light us-
ing the screwdriver. 101

Lights and visibility
driver door and the front passenger door are
not opened.
Anti-trap function of the panoramic
sliding sunr oof and the sun blindThe anti-trap function reduces the risk of in-
jury when opening and closing the panor
am-
ic sliding sunr
oof and sun blind

Operation

It lights up
Main beam on or flasher on

Lights and visibility
lights also work when the ignition is switch-
ed off

Operation
Automatic switch-
ing on
Automatic switch-
ing off
The photo sensor de-
tects darkness
, for exam-
ple, when driving through
a tunnel. When adequate lighting
is detected.
The r
ain sensor detects
rain and activ at

es the
windscreen wipers. When the windscreen
wipers have been inac-
tive f
or a few minutes. WARNING
If the road is not well lit and other road
users cannot see the vehicl e w

ell enough
or at all, accidents may occur.