2019 RAM CHASSIS CAB keyless

2
INTRODUCTION  INTRODUCTION .............................................................. 12
 HOW TO USE THIS MANUAL ....................................... 13 
Essential Information .................................................... 13
Symbols ........................................................................... 13
 WARNINGS AND CAUTIONS ....................................... 14
 VAN CONVERSIONS/CAMPERS ................................ 14
 VEHICLE MODIFICATIONS/ALTERATIONS ........... 14
GETTING TO KNOW YOUR VEHICLE  VEHICLE USER GUIDE — IF EQUIPPED...................... 15
 KEYS ..................................................................................... 17 
Key Fob ........................................................................... 17
 IGNITION SWITCH ......................................................... 23 
Keyless Push Button Ignition....................................... 23
 REMOTE START — IF EQUIPPED .................................. 26 
How To Use Remote Start ............................................ 26
Remote Start Abort Message........................................ 26
To Enter Remote Start Mode........................................ 27
To Exit Remote Start Mode Without Driving The
Vehicle ............................................................................ 27

To Exit Remote Start Mode And Drive The Vehicle ..... 27

Remote Start Comfort Systems — If Equipped......... 27

General Information ..................................................... 28  SENTRY KEY .......................................................................28 
Key Programming ........................................................29 
Replacement Keys ........................................................29 
General Information .....................................................30
 VEHICLE SECURITY ALARM .......................................30 
To Arm The System .......................................................30 
To Disarm The System ..................................................31 
Rearming Of The System ..............................................31 
Security System Manual Override ..............................32
 DOORS .................................................................................32 
Manual Door Locks .......................................................32 
Power Door Locks — If Equipped .............................33 
Keyless Enter-N-Go — Passive Entry ........................34 
Automatic Door Locks — If Equipped .....................37 
Child-Protection Door Lock ........................................38
 SEATS ................................................................................39 
Manual Front Seat Adjustment....................................39 
Manual Rear Seat Adjustment .....................................41 
Power Driver Seat Adjustment — If Equipped .........42 
Driver Memory Seats — If Equipped .......................44 
Heated Seats — If Equipped ........................................47 
Ventilated Seats — If Equipped...................................49
 HEAD RESTRAINTS ......................................................50

Front Head Restraints ...................................................50

Rear Head Restraint Adjustment ................................52

Rear Head Restraint Removal......................................53

5
 WARNING LIGHTS AND MESSAGES ........................ 146 
Red Warning Lights .................................................... 146
Yellow Warning Lights............................................... 150
Yellow Indicator Lights .............................................. 155
Green Indicator Lights ................................................ 156
White Indicator Lights ................................................ 157
Blue Indicator Lights ................................................... 158
 ONBOARD DIAGNOSTIC SYSTEM — OBD II ........ 158 
Onboard Diagnostic System (OBD II)
Cybersecurity ............................................................... 159
 EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS ..................................................................... 159
SAFETY  SAFETY FEATURES ......................................................... 161 
Anti-Lock Brake System (ABS) ................................. 161
Electronic Brake Control System .............................. 162
 AUXILIARY DRIVING SYSTEMS .................................. 174 
Forward Collision Warning (FCW) With Mitigation —
If Equipped ................................................................... 174
Tire Pressure Monitoring System (TPMS) ............ 177  OCCUPANT RESTRAINT SYSTEMS ...........................187 
Occupant Restraint Systems Features ......................187 
Important Safety Precautions.....................................188 
Seat Belt Systems .........................................................189 
Supplemental Restraint Systems (SRS).....................202 
Child Restraints ..........................................................214 
Transporting Pets ......................................................240
 SAFETY TIPS ...................................................................240 
Transporting Passengers ............................................240 
Exhaust Gas ..............................................................240 
Safety Checks You Should Make Inside The
Vehicle ..........................................................................241 
Periodic Safety Checks You Should Make Outside The
Vehicle ...........................................................................243
STARTING AND OPERATING  STARTING THE ENGINE ..............................................244 
Automatic Transmission.............................................245 
Tip Start Feature ..........................................................245 
Keyless Enter-N-Go — Ignition ................................. 245 
Normal Starting Using ENGINE START/STOP
Button .........................................................................246

Cold Weather Operation (Below –22°F Or −30°C) ... 250

After Starting ................................................................250
 ENGINE BLOCK HEATER — IF EQUIPPED............... 251

GETTING TO KNOW YOUR VEHICLE 17
KEYS
Key Fob
Your vehicle uses a keyless ignition system. The ignition
system consists of a key fob with Remote Keyless Entry
(RKE) and a START/STOP push button ignition system. The
Remote Keyless Entry system consists of a key fob and
Keyless Enter-N-Go feature.
NOTE:
The key fob may not be found if it is located next to a mobile
phone, laptop or other electronic device; these devices may
block the key fob’s wireless signal.
The key fob allows you to lock or unlock all doors, as well as
activate the Panic Alarm from distances up to approximately
66 ft (20 m) using a handheld key fob. The key fob does not
need to be pointed at the vehicle to activate the system.
NOTE:
• In the ON/RUN position, all key fob buttons will work
until the vehicle reaches 3 mph (5 km/h).
• The key fob should not be placed next to the wireless
charging pad (if equipped). Key Fob
In case the ignition switch does not change with the push of
a button, the key fob may have a low or fully depleted
battery. A low key fob battery can be verified by referring to
the instrument cluster, which will display directions to
follow. 1 — Emergency Key
2 — Unlock
3 — Lock
4 — Remote Start
5 — PANIC 2

GETTING TO KNOW YOUR VEHICLE 23
Programming Additional Key Fobs
Programming the key fob may be performed by an autho -
rized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it cannot be
repurposed and reprogrammed to another vehicle.
General Information
The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and with
Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired opera -
tion.
NOTE:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment. IGNITION SWITCH
Keyless Push Button Ignition
This feature allows the driver to operate the ignition switch
with the push of a button as long as the Remote Keyless
Entry key fob is in the passenger compartment.
The Keyless Push Button Ignition has four operating posi -
tions; three of which are labeled and will illuminate when in
position. The three positions are OFF, ACC, and ON/RUN.
The fourth position is START, during start RUN will illumi -
nate.
NOTE:
In case the ignition switch does not change with the push of
a button, the key fob may have a low or dead battery. In this
situation, a back up method can be used to operate the igni -
tion switch. Put the nose side (side opposite of the emer -
gency key) of the key fob against the ENGINE START/STOP
button, with your foot applied on the brake pedal, and push
to operate the ignition switch. 2

24 GETTING TO KNOW YOUR VEHICLE
(Continued)Keyless Push Button Ignition
The push button ignition can be placed in the following
modes:
OFF
• The engine is stopped.
• Some electrical devices (e.g. Central locking, alarm, etc.)
are still available. ACC
• Engine is not started.
• Some electrical devices are available.
RUN
• Driving position.
• All the electrical devices are available.
START
• The engine will start.
1 — OFF
2 — ACC (Accessory)
3 — ON/RUN WARNING!
• When exiting the vehicle, always remove the key fob
from the vehicle and lock your vehicle.
• Never leave children alone in a vehicle, or with access
to an unlocked vehicle.
• Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or others
could be seriously or fatally injured. Children should
be warned not to touch the parking brake, brake pedal
or the gear selector.

GETTING TO KNOW YOUR VEHICLE 25
The engine only runs in the ON/RUN ignition position or
from a remote start request.
In case the ignition switch does not change with the push of
a button, the key fob may have a low or dead battery. In this
situation, a back up method can be used to operate the igni -
tion switch. Put the nose side (side opposite of the emer -
gency key) of the key fob against the ENGINE START/STOP
button and push to operate the ignition switch. Back Up Starting Method
NOTE:
The key fob may not be able to be detected by the vehicle
keyless-go system if it is located next to a mobile phone,
laptop or other electronic device; these devices may block the
key fob’s wireless signal and prevent the keyless-go system
from starting the vehicle.
NOTE:
Refer to "Starting The Engine," in "Starting And Operating"
for further information.• Do not leave the key fob in or near the vehicle, or in a
location accessible to children, and do not leave the
ignition of a vehicle equipped with Keyless
Enter-N-Go in the ON/RUN mode. A child could
operate power windows, other controls, or move the
vehicle.
• Do not leave children or animals inside parked vehicles
in hot weather. Interior heat build-up may cause
serious injury or death.
CAUTION!
An unlocked vehicle is an invitation for thieves. Always
remove key fob from the vehicle and lock all doors when
leaving the vehicle unattended. WARNING! (Continued)
2

28 GETTING TO KNOW YOUR VEHICLE
NOTE:
The Remote Start Comfort System can be activated and deac -
tivated through the Uconnect System. Refer to “Uconnect
Settings” in “Multimedia” for further information on
Remote Start Comfort System operation.
General Information
The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and with
Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired opera -
tion.
NOTE:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment. SENTRY KEY
The Sentry Key Immobilizer system prevents unauthorized
vehicle operation by disabling the engine. The system does
not need to be armed or activated. Operation is automatic,
regardless of whether the vehicle is locked or unlocked.
The system uses a key fob, keyless push button ignition and
a RF receiver to prevent unauthorized vehicle operation.
Therefore, only key fobs that are programmed to the vehicle
can be used to start and operate the vehicle. The system
cannot reprogram a key fob obtained from another vehicle.
After turning the ignition switch to the ON/RUN position,
the vehicle security light will turn on for three seconds for a
bulb check. If the light remains on after the bulb check, it
indicates that there is a problem with the electronics. In addi -
tion, if the light begins to flash after the bulb check, it indi -
cates that someone attempted to start the engine with an
invalid key fob. In the event that a valid key fob is used to
start the engine but there is an issue with the vehicle elec -
tronics, the engine will start and shut off after two seconds.

GETTING TO KNOW YOUR VEHICLE 29
If the vehicle security light turns on during normal vehicle
operation (vehicle running for longer than ten seconds), it
indicates that there is a fault in the electronics. Should this
occur, have the vehicle serviced as soon as possible by an
authorized dealer.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics.
Key Programming
Programming key fobs may be performed at an authorized
dealer. Replacement Keys
NOTE:
Only key fobs that are programmed to the vehicle electronics
can be used to start and operate the vehicle. Once a key fob
is programmed to a vehicle, it cannot be programmed to any
other vehicle.
NOTE:
Duplication of key fobs may be performed at an authorized
dealer. This procedure consists of programming a blank key
fob to the vehicle electronics. A blank key fob is one that has
never been programmed.
When having the Sentry Key Immobilizer System serviced,
bring all vehicle keys with you to an authorized dealer.CAUTION!
The Sentry Key Immobilizer system is not compatible
with some aftermarket remote starting systems. Use of
these systems may result in vehicle starting problems
and loss of security protection. CAUTION!
• Always remove the key fobs from the vehicle and lock
all doors when leaving the vehicle unattended.
• For vehicles equipped with Keyless Enter-N-Go —
Ignition, always remember to place the ignition in the
OFF position. 2