2019 Peugeot 208 instrument panel

26
This function is only displayed from
19 mph (30 km/h).
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip computer
reset.
Distance travelled
(miles or km)
Calculated since the last trip computer
reset.
Average speed
(mph or km/h) Calculated since the last trip
computer reset.
Total time in stop mode
(minutes/seconds or hours/minutes)
If your vehicle is fitted with Stop & Start, a time
counter adds up the time spent in STOP mode
during a

journey.
It resets to zero every time the ignition is
switched on.
Setting the time and date
Instrument panel
F Each press of this button toggles between the following settings:
-


h o u r,
-


minutes,
-

1
2 or 24 hour format.
With PEUGEOT Connect
Radio
F Select the Settings menu in
the upper banner of the touch
screen.
F

Sel

ect " System configuration ".
F

Sel
ect "Date and time ".
F

Sel

ect " Date " or "Time ".
F

C

hoose the display formats.
F

C

hange the date and/or time using the
numeric keypad.
F

C

onfirm with " OK".
With PEUGEOT Connect
Nav
Setting of the time and date is only available if
synchronisation with the GPS is deactivated.
F

Sel
ect the "Settings " menu.
F

P
ress the " OPTIONS " button to go to the
secondary page.
F

Sel
ect "Setting the time- date".
F

Sel
ect the " Date" or " Time" tab.
F

A
djust the date and time using the numeric
keypad and confirm.
F

I
n the selected tab, press this
key to confirm.
Additional settings
You can choose:
- T o change the date format (DD/MM/ Y Y Y Y,
YYYY/MM/DD, etc.)
-

T
o change the time format (12h/24h).
-

T
o change the time zone.
-

T
o activate or deactivate synchronisation
with the GPS (UTC).
Instruments

27
The system does not automatically
manage the change between winter and
summer time (depending on country).
The change between winter and summer
time is done by changing the time zone.
Lighting dimmer
System for the manual adjustment of the
brightness of the instrument panel and the
touch screen to suit the ambient light level.
With two buttons
Lighting switched on:F
P
ress this button to raise
the level of brightness.
F

P
ress this button to lower
it.
Release the button once the desired level of
brightness is reached.
With one button
F Press this button to adjust the brightness.
F

R

elease the button once the desired level
of brightness is reached.
When the vehicle lighting is off, or in day
mode (daytime running lamps on), pressing
the button does not have any effect.
With touch screen
The brightness can be adjusted differently
for day mode (lighting control stalk in
position " 0") and night mode (lighting
control stalk in any other position).
F

I

n the Settings menu, select " Brightness".
F

A

djust the brightness by pressing the
arrows or moving the slider.
1
Instruments

36
PEUGEOT i-Cockpit
Once these adjustments have been made,
make sure that the "head-up" instrument
panel can be viewed correctly over the
smaller diameter steering wheel.
Steering wheel adjustment
For safety reasons, these adjustments
must only be made with the vehicle
stationary.
Mirrors
Door mirrors
As a safety measure, the mirrors should
b e adjusted to reduce the "blind spot".
Manual adjustments
F Operate the lever in the four directions to adjust the angle of the mirror glass.
Folding
F

F
old the mirror manually to protect it when
the vehicle is parked.
F

U
nfold it before moving off again.
They do not have automatic defrosting.
F

W

ith the vehicle stationary
, pull the
control lever to release the steering wheel.
F

A

djust the height and reach to suit your
driving position.
F

P

ush the control lever to lock the adjustment
mechanism.
Before taking to the road and in order to take
advantage of the specific ergonomics of the
PEUGEOT i-Cockpit, adjust it in the following order:
-

t
he height of the head restraint,
-

t
he seat backrest angle,
-
t

he seat cushion height,
-

t
he longitudinal position of the seat,
-
t

he depth and then the height of the steering
wheel,
-

t
he rear view mirror and door mirrors.
Ease of use and comfort

51
Lighting control stalk
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps is
normal; it disappears after the lamps have
been on for a few minutes.
Travelling abroad
If planning to use your vehicle in a
country
that drives on the other side of the road,
the dipped beam headlamps must be
adjusted to avoid dazzling oncoming
drivers. Contact a
PEUGEOT dealer or
a


qualified workshop.
Selection of main lighting
mode
Lighting off (ignition off)/Front daytime
running lamps (engine running).
Sidelamps only.
Dipped or main beam headlamps.
Automatic illumination of headlamps.
Headlamp dipping
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining
a pull on the stalk.
Display
Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.
Foglamps
The foglamps operate with dipped or main
beam headlamps on.
Turn the ring to align the desired symbol with
the marking. Pull the stalk to switch between dipped and
main beam headlamps.
Rear foglamp only
F To switch it on, turn the ring for wards.
When the lighting is switched off automatically
(version with AUTO lighting), the foglamp and
the dipped beam headlamps will remain on.
F

T
o switch it off, turn the ring rear wards.
Front foglamps and rear foglamp
Rotate and release the ring:
F o nce for wards to switch on the front
foglamps,
F

f
or wards a second time to switch on the rear
foglamp,
F

o
nce rear wards to switch off the rear
foglamp,
F

r
ear wards a second time to switch off the
front foglamps.
4
Lighting and visibility

53
Switching on
F Turn the ring to the "AUTO" position.
Activation of the function is accompanied by
a
message on the screen.
Switching off
F Turn the ring to another position. Deactivation of the function is accompanied
by a
message in the screen.
In fog or snow, the sunshine sensor may
detect sufficient light. In this case, the
lighting will not come on automatically.
Do not cover the sunshine sensor, linked
with the rain sensor and located in the
centre of the windscreen behind the rear
view mirror; the associated functions
would no longer be controlled.
Automatic guide-me-home
lighting
When associated with automatic illumination of
headlamps, the guide-me-home lighting offers
the following additional options:
-

s
election of the lighting duration of 15, 30 or
60


seconds,
-

a
utomatic activation of guide-me-home
lighting when the automatic illumination of
headlamps is in operation.
The guide-me-home lighting can be
configured in the Driving/Vehicle
menu.
In the event of a
fault with the
sunshine sensor, the lighting comes
on, this warning lamp is displayed
in the instrument panel and/or
a
message appears on the screen,
accompanied by an audible signal.
Contact a
PEUGEOT dealer or
a


qualified workshop.
Manual guide-me-home
lighting
Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the driver's exit easier
when the light is poor.
Switching on
F With the ignition off, "flash" the headlamps using the lighting control stalk.
F

A f
urther "headlamp flash" switches the
function off.
Manual guide-me-home lighting is
also available from the remote control
lighting button.
Switching off
Manual guide-me-home lighting goes off
automatically at the end of a given period of
time.
4
Lighting and visibility

54
Headlamp beam height
adjustment
To avoid causing a nuisance to other road
u sers, the height of the headlamp beams
should be adjusted according to the load in the
vehicle.
0. 1
or 2 people in the front seats.
-. Intermediate setting.
1. 5


people.
-. 5
people + maximum authorised load.
2. Driver + maximum authorised load.
The initial setting is position " 0".
Vehicle side marking by illumination of the
sidelamps on the traffic side only.
F

W

ithin one minute after switching off the
ignition, operate the lighting control stalk up
or down, depending on the traffic side (for
example, when parked on the left, move the
lighting control stalk upwards; the right-hand
sidelamps come on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition.
Parking lamps Daytime running lamps/
Sidelamps
The front and rear lamps light up automatically
when the engine starts.
They provide the following functions:
-

D
aytime running lamps (lighting control
stalk at position " 0" or " AUTO " with
adequate light level).
-

S
idelamps (lighting control stalk at " AUTO"
position with low light levels or "Sidelamps
only" or "Dipped/main beam headlamps").
The LEDs are brighter when operating as
daytime running lamps.
Lighting and visibility

56
Automatic rain sensitive
windscreen wipers
The windscreen wipers operate
automatically, without any action
on the part of the driver, when rain
is detected (sensor behind the rear
view mirror), adapting their speed to
the intensity of the rainfall.
Switching on
This indicator lamp comes on in the
instrument panel and a message is
displayed.
Give a

short downwards push to the control
stalk.
A wiping cycle confirms that the instruction has
been accepted.
Switching off
This indicator lamp goes off in the
instrument panel and a message is
displayed.
Give another short downwards push to
the control stalk or shift the control stalk to
a

different position (Int, 1 or 2). If the wipers operate in intermittent mode
when in AUTO mode, have the system
checked by a
PEUGEOT dealer or
a

qualified workshop.
Do not cover the rain sensor, combined with
the sunshine sensor, located at the top of
the windscreen behind the rear view mirror.
When using an automatic car wash, switch
off the automatic rain sensitive wipers.
In winter, it is advisable to wait until the
windscreen is completely clear of ice before
activating the automatic rain sensitive
wipers.
Front screenwash
Pull the wiper control stalk towards you. The
screenwash and then the wipers operate for
a
preset time.
Front wipers
Fast (heavy rain).
Normal (moderate rain).
Intermittent (proportional to the
speed of the vehicle).
Of f.
Single wipe (press down and
release). The automatic rain sensitive windscreen
wipers must be reactivated by pushing the
control stalk downwards, if the ignition has
been off for more than 1
minute.
Lighting and visibility

61
Anti-lock braking system
(ABS) and electronic brake
force distribution (EBFD)
The fixed illumination of this warning
lamp indicates that there is a fault
with the ABS.
The vehicle retains conventional braking. Drive
carefully at moderate speed. If these warning lamps come on,
accompanied by an audible signal
and a
message, this indicates a fault
with the electronic brake force
distribution (EBFD) system.
When changing wheels (tyres and rims),
ensure that these are approved for your
vehicle.
Normal operation of the ABS may make
itself felt by slight vibration of the brake
pedal. If you need to brake in an emergency,
press the brake pedal ver y firmly and
keep the pressure applied.
You must stop as soon as it is safe to do so.
In both cases, have the system checked by
a

PEUGEOT dealer or a qualified workshop as
soon as possible.Anti-slip regulation (ASR)/
Dynamic stability control
(DSC)
Operation
These systems are activated automatically
every time the vehicle is started.
They come into operation in the event of
a
problem with grip or trajectory. This is indicated by flashing of this
warning lamp in the instrument panel.
Deactivation
In exceptional conditions (starting a vehicle
w hich is bogged down, stuck in snow, on soft
ground, etc.), it may be advisable to deactivate
these systems, so that the wheels can turn
freely and regain grip.
Reactivate these systems as soon as the level
of grip permits.
Deactivation of ASR and DSC using the button
F Press this button.
The orange indicator lamp in the button comes
on.
The ASR and DSC systems will no longer have
an effect on engine operation or the brakes in
the event of an involuntary change of trajectory.
Deactivation of ASR using the touch screen
The deactivation is configured in the
Driving/Vehicle menu.
It is confirmed by the display of a
message.
Reactivation
These systems are reactivated automatically
each time the ignition is switched back on or
above 31 mph (50 km/h).
Below 31
mph (50 km/h), you can reactivate
them manually.
5
Safety