2019 OPEL ASTRA J ignition

162Vehicle careThe menu can be selected by thebuttons on the turn signal lever.
Press MENU to select the Vehicle
Information Menu X.
Turn the adjuster wheel to select the
tyre pressure monitoring system.
System status and pressure warnings
are displayed by a message with the
corresponding tyre flashing in the
Driver Information Centre.
The system considers the tyre
temperature for the warnings.
A detected low tyre pressure
condition is indicated by illumination
of control indicator w 3 71.
If w illuminates, stop as soon as
possible and inflate the tyres as
recommended 3 186.
If
w flashes for 60-90 seconds and
then illuminates continuously, there is
a fault in the system. Consult a
workshop.
After inflating, driving may be
required to update the tyre pressure
values in the Driver Information
Centre. During this time w may
illuminate.
If w illuminates at lower temperatures
and extinguishes after some driving,
this could be an indicator for
approaching a low tyre pressure
condition. Check tyre pressure.
Vehicle messages 3 79.
If the tyre pressure must be reduced
or increased, switch off ignition.
Only mount wheels with pressure
sensors, otherwise the tyre pressure
will not be displayed and w
illuminates continuously.
A spare wheel or temporary spare
wheel is not equipped with pressure
sensors. The tyre pressure
monitoring system is not operational
for these wheels. Control indicator w

Vehicle care163illuminates. For the further three
wheels the system remains
operational.
The use of commercially available
liquid tyre repair kits can impair the
function of the system. Factory-
approved repair kits can be used.
Operating electronic devices or being
close to facilities using similar wave
frequencies could disrupt the tyre
pressure monitoring system.
Each time the tyres are replaced, tyre pressure monitoring system sensors
must be dismounted and serviced.
For the screwed sensor: replace
valve core and sealing ring. For
clipped sensor: replace complete
valve stem.
Vehicle loading status Adjust tyre pressure to load condition
according to the tyre information label or tyre pressure chart 3 186, and
select the appropriate setting in the
Tyre load menu in the Driver
Information Centre 3 73. This setting
is the reference for the tyre pressure
warnings.The Tyre Load menu only appears if
the vehicle is in a standstill and the
parking brake is applied. On vehicles
with automatic transmission, the
selector lever must be in P.
Select:
● Light for comfort pressure up to
3 people.
● Eco for Eco pressure up to
3 people.
● Max for full load.
Tyre pressure sensor matching
process
Each tyre pressure sensor has a
unique identification code. The
identification code must be matched
to a new wheel position after rotating the wheels or exchanging the
complete wheel set and if one or more
tyre pressure sensors were replaced. The tyre pressure sensor matching
process should also be performed
after replacing a spare wheel with a
road wheel containing the tyre
pressure sensor.
The malfunction light w and the
warning message or code should
extinguish at the next ignition cycle.
The sensors are matched to the
wheel positions using a relearn tool,
in the following order: left side front
wheel, right side front wheel, right
side rear wheel and left side rear
wheel. The turn signal light at the
current active position is illuminated
until the sensor is matched.
Consult a workshop for service. There
are two minutes to match the first
wheel position, and five minutes
overall to match all four wheel

164Vehicle carepositions. If it takes longer, the
matching process stops and must be
restarted.
The tyre pressure sensor matching
process is:
1. Apply the parking brake.
2. Turn the ignition on.
3. On vehicles with automatic transmission: set the selector
lever to P.
On vehicles with manual
transmission: select neutral.
4. Use MENU on the turn signal
lever to select the Vehicle
Information Menu in the Driver
Information Centre.
5. Turn the adjuster wheel to scroll to
the tyre pressure menu.
6. Press SET/CLR to begin the
sensor matching process. A
message requesting acceptance
of the process should be
displayed.
Press SET/CLR again to confirm
the selection. The horn sounds
twice to indicate the receiver is in
relearn mode.7. Start with the left side front wheel.
8. Place the relearn tool against the tyre sidewall, near the valve stem.Then press the button to activate
the tyre pressure sensor. A horn
chirp confirms that the sensor
identification code has been
matched to this wheel position.
9. Proceed to the right side front wheel, and repeat the procedure
in Step 8.
10. Proceed to the right side rear wheel, and repeat the procedure
in Step 8.
11. Proceed to the left side rear wheel, and repeat the procedure
in Step 8. The horn sounds twice
to indicate the sensor
identification code has been
matched to the left side rear tyre,
and the tyre pressure sensor
matching process is no longer
active.
12. Turn off the ignition.13. Set all four tyres to the recommended air pressure level
as indicated on the tyre pressure
label.
14. Ensure the tyre loading status is set according to the selected
pressure 3 73.
Tread depth
Check tread depth at regular
intervals.
Tyres should be replaced for safety
reasons at a tread depth of 2-3 mm
(4 mm for winter tyres).
For safety reasons it is recommended
that the tread depth of the tyres on
one axle should not vary by more than 2 mm.

172Vehicle care4. Switch on electrical consumers(e.g. headlights, heated rear
window) of the vehicle receiving
the jump start.
5. Reverse above sequence exactly when removing leads.Towing
Towing the vehicle
Wrap a cloth around the tip of a flat
screwdriver to prevent paint damage.
Insert the screwdriver in the slot at the
lower part of the cap. Release the cap by carefully moving the screwdriver
downwards.
The towing eye is stowed with the
vehicle tools 3 159.
Screw in the towing eye as far as it will
go until it stops in a horizontal
position.
Attach a tow rope – or better still a tow
rod – to the towing eye.
The towing eye must only be used for
towing and not for recovering the
vehicle.
Switch on ignition to release steering wheel lock and to permit operation of
brake lights, horn and windscreen
wiper.
Switch the selector lever to neutral.
Release the parking brake.

199Cupholders .................................. 48
Curve lighting................................ 97
D
Danger, Warnings and Cautions ...4
Daytime running lights .................97
Declaration of conformity ............188
Door open .................................... 73
Doors ............................................ 23
Driver assistance systems ..........130
Driver Information Centre .............73
Driving hints ................................ 115
E Electric adjustment ......................25
Electrical system......................... 154
Electric parking brake ...........69, 126
Electric parking brake fault ...........70
Electronic climate control system 109
Electronic driving programmes ..123
Electronic Stability Control.......... 129
Electronic Stability Control and Traction Control system ............71
Electronic Stability Control off....... 71
End-of-life vehicle recovery .......139
Engine compartment fuse box ...155
Engine coolant ........................... 142
Engine coolant temperature gauge ....................................... 64
Engine data ............................... 184
Engine exhaust .......................... 119Engine identification ...................181
Engine oil ................... 141, 178, 182
Engine oil pressure ......................72
Entry lighting .............................. 104
Event data recorders ..................193
Exhaust filter ......................... 71, 119
Exit lighting ................................ 104
Exterior care .............................. 174
Exterior light ................................. 72
Exterior lighting ......................12, 93
Exterior mirrors ............................. 25
F Fault ........................................... 123
First aid ......................................... 53
First aid kit ................................... 53
Fixed air vents ........................... 113
Folding mirrors ............................. 25
Front airbag system .....................40
Front fog lights .............73, 101, 149
Front seats.................................... 32
Front storage ................................ 49
Front turn lights .......................... 150
Fuel............................................. 135
Fuel for petrol engines ...............135
Fuel gauge ................................... 63
Fuses ......................................... 154
G Gauges ......................................... 62
Glovebox ..................................... 48H
Halogen headlights ....................146
Hand brake ......................... 125, 126
Hazard warning flashers ............100
Headlight flash ............................. 95
Headlight range adjustment ........96
Headlights..................................... 93
Headlights when driving abroad ..96
Head restraint adjustment .............8
Head restraints ............................ 31
Heated mirrors ............................. 26
Heated rear window ..................... 30
Heated steering wheel .................57
Heating ........................................ 35
Heating and ventilation system . 106
High beam ............................. 72, 95
High beam assist ....................72, 95
Hill start assist ........................... 128
Horn ....................................... 13, 58
I
Identification plate .....................180
Ignition switch positions .............116
Immobiliser ............................ 24, 72
Indicators ...................................... 62
Info Display ................................... 77
Information displays...................... 73
Instrument cluster ........................62
Instrument panel fuse box .........157
Instrument panel illumination .....153