2019 NISSAN GT-R brake

NOTICE
When the vehicle is stopped on a hill,
do not hold the vehicle in place by
depressing the accelerator pedal.
Doing so may cause the clutch to
overheat and result in transmission
damage. Use the brakes to prevent
the vehicle from moving.
The hill start assist system automatically
keeps the brakes applied to help prevent
the vehicle from rolling backwards in the
time it takes the driver to release the
brake pedal and apply the accelerator
when the vehicle is stopped on a hill.
Hill start assist will operate automatically
under the following conditions:
. The shift lever is moved to a forward
or reverse position.
. The vehicle is stopped completely on a
hill by applying the brake.
The maximum holding time is 2 seconds.
After 2 seconds the vehicle will begin to
roll back and hill start assist will stop
HILL START ASSIST SYSTEM

wheels will lose even more trac-
tion.
. Allow more stopping distance
under these conditions. Braking
should be started sooner than on
dry pavement.
. Allow greater following distances
on slippery roads.
. Watch for slippery spots (glare
ice). These may appear on an
otherwise clear road in shaded
areas. If a patch of ice is seen
ahead, brake before reaching it.
Try not to brake while on the ice,
and avoid any sudden steering
maneuvers.
. Do not use the cruise control on
slippery roads.
. Snow can trap dangerous ex-
haust gases under your vehicle.
Keep snow clear of the exhaust
pipe and from around your vehi-
cle.
NOTE:
When driving on snow, select the SAVE
mode with the setup switch. By select-
ing the SAVE mode, the engine output is
controlled appropriately for snow or slippery road surfaces. This enables
the vehicle to start or accelerate
smoothly.

engine for more than 20 seconds
without depressing the brake pedal.
This allows the brake pads to move
away from the rotor so the pad does
not contact the rotor.
Additionally, the brakes must be dry
before parking the vehicle after driv-
ing on wet roads or after washing the
vehicle. If the roads are wet, lightly
apply the brakes for a short distance
before parking the vehicle to dry the
brakes. After washing the vehicle, dry
the brakes by driving on a dry road for
a few miles and apply the brakes
normally based on traffic and road
conditions.
The metallic brake pads and brake
disc rotor may rust together when the
brakes are not applied:
— If the vehicle is not idled for 20seconds without the brakes ap-
plied, or if the brakes are applied
when the vehicle is shut off, the
rotor and pads can rust together,
even when the brake pads are dry.
— If the brakes are wet when the vehicle is parked and the parking
brake is applied for a long time.
— The hill start assist system can apply the brakes even if the brake
pedal is not depressed. The brake
pads and rotors can rust together if the parking procedure previously
described is not followed.
It is recommended you contact a GT-R
certified NISSAN dealer if the brake
pads and brake rotor have rusted
together.
NOTICE

Braking System (ABS) warning light illu-
minate, it may indicate the ABS is not
functioning properly. It is recommended
you have the brake system checked, and
if necessary repaired, by a GT-R certified
NISSAN dealer promptly. (

in this section for 48 hours after tires
are installed on the wheels. The tire
may slip on the wheel if the vehicle is
driven in these conditions before 48
hours have passed. If the tire slips on
the wheel, the wheel/tire assembly
will be out of balance and will require
rebalancing.
BrakesThe information and specifications in
this section apply only when engaging
in performance driving.
.Check for the heat deterioration of the
brakes and parts around the brakes.
. It is recommended that you remove
air from the brake system after any of
the following:
— When engaging in high perfor-
mance driving for the first time
after purchasing a new vehicle.
— After replacing the brake fluid.
— When engaging in high perfor- mance driving for a sustained per-
iod of time. It is recommended that
bleeding the brake be performed
when the brake calipers are hot
(about 212°F (100°C)). Brake pad break-in procedure:
NISSAN recommends that a special brake
pad break-in procedure be performed
before engaging in performance driving.
It is recommended you contact a GT-R
certified NISSAN dealer for details.
INSPECTION AND ADJUSTMENTS
AFTER DRIVINGThe information and specifications in
this section apply only when engaging
in performance driving.
NOTICE
At the completion of performance
driving, all fluid and other adjust-
ments should be returned to the
normal fluid specifications as shown
in the “Maintenance and do-it-your-
self” section of this manual.FluidsThe information and specifications in
this section apply only when engaging
in performance driving.
.
Check the engine, transmission, differ-
ential and under the vehicle for oil and
coolant leaks. .
Check the fluid levels and adjust as
necessary using the specified fluid as
described under the conditions listed
in this section. (

Braking System (ABS) warning light illu-
minate, it may indicate the ABS is not
functioning properly. It is recommended
you have the brake system checked, and
if necessary repaired, by a GT-R certified
NISSAN dealer promptly. (

NOTICE
When the vehicle is stopped on a hill,
do not hold the vehicle in place by
depressing the accelerator pedal.
Doing so may cause the clutch to
overheat and result in transmission
damage. Use the brakes to prevent
the vehicle from moving.
The hill start assist system automatically
keeps the brakes applied to help prevent
the vehicle from rolling backwards in the
time it takes the driver to release the
brake pedal and apply the accelerator
when the vehicle is stopped on a hill.
Hill start assist will operate automatically
under the following conditions:
. The shift lever is moved to a forward
or reverse position.
. The vehicle is stopped completely on a
hill by applying the brake.
The maximum holding time is 2 seconds.
After 2 seconds the vehicle will begin to
roll back and hill start assist will stop
HILL START ASSIST SYSTEM

subject it to a strong impact.
When removing the tires, be care-
ful not to allow the tire to inter-
fere with the brake disc rotor.
REPLACING BRAKE PADS AND
BRAKE DISC ROTORS.When replacing brake pads and brake
disc rotors, NISSAN recommends re-
placing two sets of them at the same
time. However, the brake pads can be
separately replaced only when a GT-R
certified technician judges that the
brake disc rotors are reusable, based
on a measured weight and a check for
scratches and cracks.
. It is recommended that maintenance
and inspection on your vehicle should
be performed at a GT-R certified
NISSAN dealer after engaging in high
performance driving. Otherwise, the
peripheral parts of the brake may be
damaged due to the generation of
special radiant heat because of the
characteristics of the material in addi-
tion to brake pad wear and the
deterioration in durability of the brake
disc rotor.
Brake padWhen the brake warning light illuminates
to indicate brake pad wear, have the
brake system checked and brake pads
replaced as soon as possible. It is recom-
mended you contact a GT-R certified
NISSAN dealer for this service.