2019 MERCEDES-BENZ E CLASS light

Ashtray and cigarettelighter
Usingthe ashtrayinthe front center console
NOTEDamagetothestowage compart‐ment underthe ashtray
Thestowage compartment underthe ashtrayis not heatresistant and could be damaged ifyouresta lit cigaretteon it.
Make surethatthe ashtrayis fullyengaged.
Toopen:push up cover2ofthe ashtrayonitsright or left side.
Toremovethe insert:press insert1upwards slightly and pull it out upwards.
Tore-installthe insert:press insert1intothe holder until it engages.
Usingtherear passenger compartment ash‐tray
Toopen:pull cover2outbyitstop handleedge.
Toremovethe insert:pushribbing3fromthe left side and pull insert1upwards andout.
Toinstallthe insert:install insert1fromaboveand press down intothe holder until itengages.
Usingthe cigarettelighter
\nWARNING‑ Risk offireand injury fromhot cigarettelighter
You can burnyourself ifyoutouchthe hotheating element orthe socket ofthe ciga‐rette lighter.
In addition,flammable materials may igniteif:
Ryou dropthe hot cigarettelighter
Rachild holdsthe hot cigarettelightertoobjects,forexample
Always holdthe cigarettelighterbytheknob.
Always make surethatthe cigarettelighter is out ofreach ofchildren.
Never leavechildren unattended inthevehicle.
11 2Seats andstowing

Requirements:RThe ignition is switched on.
Press in cigarettelighter1.The cigarettelighter will pop out automati‐cally whenthe heating element isred-hot.
Sockets
Using the12V socketintherear passengercompartment
Requirements:ROnly connect devices uptoa maximum of180watts (15 A).
Pull cover2outbyitstop handle edge.
Removeblind plug1fromthe socket andinsertthe plug ofthe device.
Usingthe12V socketinthe front passengerfootwell
Requirements:ROnly connect devices uptoa maximum of180 W (15 A).
Lift up socket cap1.
Makesurethat no cables arerunningthrough or secured inthe airbag deploymentarea when usingthe socket. Observethenotes on airbag protection when doingthis(→page 40).
Seats andstowing11 3

Exterior lighting
Information about lighting systems andyourresponsibility
Thevarious lighting systems ofthevehicle areonly aids. The driver ofthevehicle isresponsiblefor correctvehicle illumination in accordancewiththe prevailing light and visibility conditions,legalrequirements and traffic situation.
Light switch
Operating the light switch
GcLeftstanding light
HdRightstanding light
I`Parking lights and license plate lamp
JXAutomatic driving lights (preferred lightswitch position)
KXLow beam/high beam
6^Switchestherearfog lights on or off
When low beam is activated,the`indicatorlampforthe parking lights is deactivated andreplacedbytheXlow beam indicator lamp.
Always parkyourvehicle safely and in awell-lit area, in accordance withtherelevant legalstipulations.
NOTEBattery dischargingbyoperatingthestanding lights
Operatingthestanding lightsover a period ofhours puts astrain onthe battery.
Where possible, switch ontherightdor leftcparking light.
Inthe case of severebattery discharging,thestanding lights or parking lights are automati‐cally switched offtofacilitatethe next enginestart.
Theexterior lighting (exceptstanding and park‐ing lights) switches off automatically whenthedriver's door is opened.
Light and visibility117

RObservethe notes on surround lighting(→page121).
Automatic driving lights functionThe parking lights, low beam and daytimerun‐ning lamps are switched on automaticallydepending onthe ignitionstatus andthe ambi‐ent light.
\nWARNINGRisk of accident whenthe lowbeam is switched off in poor visibility
Whenthe light switch is settoX,the lowbeam may not be switched on automaticallyifthere isfog, snow orother causes of poorvisibility such as spray.
In such cases, turnthe light switchtoX.
The automatic driving lights are only an aid.Yo uareresponsibleforvehicle lighting.
Switchingtherearfog lights on or off
Requirements:RThe light switch is intheXorXposi‐tion.
Pressthe^button.
Please observethe country-specific lawsontheuse ofrearfog lamps.
Operatingthe combination switchfor thelights
1High beam
2Turnsignal indicator,right
3High-beamflasher
4Turnsignal indicator, left
Usethe combination switchtoactivatethedesired function.
11 8Light and visibility

High beam
Toswitch on:turnthe light switchtotheXorXposition.
Pressthe combination switch beyondthepoint ofresistance inthe direction of arrow1.Whenthe high beam is activated,theXindicator lampfor low beam will be deactiva‐ted andreplacedbytheWindicator lampfor high beam.Toswitch off:movethe combination switchbacktoitsstarting position.
High-beam flasher
Pullthe combination switch inthe directionof arrow3.
Turnsignal lights
Toindicate briefly:pressthe combinationswitch brieflytothe point ofresistance inthedirection of arrow2or4.The corresponding turn signal indicator willflashthree times.
Toindicate permanently:pressthe combi‐nation switch beyondthe point ofresistanceinthe direction of arrow2or4.
Vehicles withActive Lane Change Assist:
RIndicator operation activatedbythe drivercanextendforthe duration ofthe lanechange.
RIfthe driver indicated immediately before‐hand but a lanechangewas not immedi‐ately possible,the turn signal indicatormay activate automatically.
Activating/deactivating the hazardwarninglights
Press button1.
Light and visibility11 9

Cornering light
Cornering light function
The cornering light improvesthe illumination oftheroadwayover a wide angle inthe turningdirection, enabling better visibility on tightbends,forexample. It can be activated onlywhenthe low beam is switched on.
The function is active:
RAtspeeds below 25mph (40 km/h) whenthe turn signal light is switched on orthesteering wheel is turned
RAtspeeds between 25mph (40 km/h) and45mph (70 km/h) whenthesteering wheelis turned
Traffic circle and intersection function:thecornering light is activated on bothsidesthroughanevaluation ofthe current GPS position ofthevehicle. Itremains active until afterthevehiclehas leftthe traffic circle orthe intersection.
Adaptive Highbeam Assist
Adaptive Highbeam Assist function
\nWARNINGRisk of accident despiteAdaptive Highbeam Assist
Adaptive Highbeam Assist does notrecog‐nizethefollowingroad users:
RRoad users without lights, e.g. pedes‐trians
RRoad users with poor lighting, e.g.cyclists
RRoad users whose lighting is obstructed,e.g.bya barrier
Onveryrareoccasions,Adaptive HighbeamAssist mayfailtorecognizeotherroad userswiththeirown lighting, or mayrecognizethemtoo late.
Inthese or similar situations,the automatichigh beam is not deactivated or is activateddespitethe presence ofotherroad users.
Always observethe traffic carefully andswitch offthe high beam in good time.
Adaptive Highbeam Assist cannottakeintoaccountroad,weather or traffic conditions.
Detection may berestricted inthefollowingcases:
Rin poor visibility,e.g.fog, heavyrain or snow
Rifthere is dirt onthe sensors orthe sensorsare obscured
Adaptive Highbeam Assist is onlyan aid.You areresponsiblefor adjustingthevehicle's lightingtothe prevailing light, visibility and traffic condi‐tions.
12 0Light and visibility

TheAdaptive Highbeam Assist automaticallyswitches betweenthefollowing types of light:
RLow-beam headlamps
RHigh beam
Atspeeds above19mph (30 km/h):
RIf nootherroad users are detected,the highbeam will be switched on automatically.
The high beam switches off automatically inthefollowing cases:
RAtspeeds below16mph (25 km/h).
RIfotherroad users are detected.
RIfstreetlighting is sufficient.
Atspeeds aboveapproximately31mph(50 km/h):
RThe headlamprange ofthe low beam isregu‐lated automatically based onthe distancetootherroad users.
The system's optical sensor is located behindthe windshield neartheoverhead control panel.
SwitchingAdaptive Highbeam Assist on/offToswitch on:turnthe light switchtotheXposition.
Switch onthe high beam usingthe combina‐tion switch.Whenthe high beam is switched on automat‐ically inthe dark,the

vehicle is unlocked. Whenyoustartthevehicle,the surround lighting is deactivated andtheautomatic driving lights are activated.
Interior lighting
Adjusting the interior lighting
1=Switchesthe front leftreading lampon/off
23Switchesthe automatic interiorlighting control on/off
3JSwitchesthe front interior lightingon/off
4BSwitchestherear interior lightingon/off
5=Switchesthe frontrightreadinglamp on/off
Adjusting the ambient lighting
Multimedia system:
Vehicle÷Light SettingsAmbient
Light
Settingthe color
SelectColor.
Set a color.
Adjusting the brightness
SelectBrightness.
Set a brightnessvalue.
Activating the brightnessfor zones
SelectBrightness Zones.
Activatesor deactivateSthe function.TheDisplay,FrontandRearzones can be setseparately.
Activating multi-color lighting
SelectMulti-color.
Activatesor deactivateSthe function.There areten preset color combinationsavailable.
Activating multi-color animation
SelectMulti-color Anim..
Activatesor deactivateSthe function.Thechosen color combinationchanges atpredefined intervals.
Activating dependency on air conditioningsettings
SelectClimate.
Activatesor deactivateSthe function.Ifchanges are madetothetemperature set‐ting inthevehicle,the color ofthe ambientlightingchanges briefly.
Activatingwelcome lighting
SelectWelcome.
12 2Light and visibility