2019 MERCEDES-BENZ E CLASS trunk

Deactivating/activating maneuvering assis‐tanceMultimedia system:
VehiclekAssistance Camera &
ParkingManeuvering Assist.
Activatesor deactivateSthe function.
Maneuvering assistance mustbe activeforthe function of DriveAwayAssist(→page 207) and CrossTraffic Alert(→page208).
ATTENTION ASSIST
Function ofATTENTION ASSISTATTENTION ASSIST assistsyou on long, monoto‐nous journeys, e.g. on highways and trunkroads.IfATTENTION ASSIST detects indicators offati‐gue or increasing lapses in concentration onthepart ofthe driver, it suggeststaking a break.
ATTENTION ASSIST is only an aid. It cannotalways detectfatigue or lapses in concentrationin time. The system is not a substitutefor awell-rested and attentive driver. On long journeys,
takeregular breaks in good timethat allowforadequaterecuperation.
You canchoose between two settings.
RStandard:normal system sensitivity.
RSensitive:higher system sensitivity. Thedriver iswarned earlier andthe attentionlevel detectedbyATTENTION ASSIST is adap‐ted accordingly.
If drowsiness or increasing lapses in concentra‐tion are detected,theATTENTION ASSIST: Takea Break!warning appears inthe instrument dis‐play.You can acknowledgethe message andtake a break where necessary.Ifyou do nottakea break andATTENTION ASSIST continuestodetect increasing lapses in concentration,youwill bewarned again after a minimum of15minutes.
You can havethefollowingstatus informationforATTENTION ASSIST displayed inthe assistancemenu ofthe on-board computer:
RThe length ofthe journey sincethe lastbreak.
RThe attention level determinedbyATTENTIONASSIST.
IfATTENTION ASSIST is unabletocalculatetheattention level and cannot issue awarning,theSystem Suspendedmessageappears.
If awarning is given inthe instrument display,the multimedia system offerstosearchfor arestarea.You can select arestarea andstart naviga‐
Driving and parking209

Removecap1bythetab.
Addwasherfluid.
Keepingthe air-water duct free
Keepthe area betweenthe hood andthewindshield free of deposits, e.g. ice, snowand leaves.
Cleaning and care
Notes onwashingthevehicle in a carwash
\nWARNINGRisk of accident duetoreduced braking effect afterwashingthevehicle
The braking effect isreduced afterwashingthevehicle.
Afterthevehicle has beenwashed,brake carefully while paying attentiontothe traffic conditions untilthe brakingeffect has been fullyrestored.
NOTEDamageduetounsuitable carwash
Before driving into a carwash makesurethatthe carwash is suitableforthevehicle dimensions.
Ensurethere is sufficient ground clear‐ance betweenthe underbody andtheguiderails ofthe carwash.
Ensurethatthe clearance width ofthecarwash, in particularthe width oftheguiderails, is sufficient.
Toavoid damageto yourvehicle when using acarwash, ensurethefollowing beforehand:
RActive Distance AssistDISTRONIC andtheHOLD function are deactivated.
Rthe 360° Camera ortherear view camera isswitched off.
Rthe side windowsand sliding sunroof arecompletelyclosed.
Rthe blowerfortheventilation/heating isswitched off.
Rthe windshield wiper switch is in positionZ.
Rin carwashes with a conveyor system: neu‐tral\\is engaged.
Rthe SmartKeyis at a distance of at least10ft(3 m)awayfromthevehicle,otherwisethetrunk lid could open unintentionally.
Maintenance and care355

Ifyouwould liketoleavethevehicle while itis beingwashed, make surethe SmartKeyislocated inthevehicle. The]gear isother‐wise automatically engaged.
If, afterthe carwash,youremovethewaxfromthe windshield and wiperrubbers,thiswill prevent smearing andreduce wipernoise.
Information on using a powerwasher
\nWARNINGRisk of accident when usinghigh-pressure cleaning equipment withround-spraynozzles
Thewater jet from around-spraynozzle (dirtgrinder) may cause damagetotires and sus‐pension componentsthat is not visible.
Components damaged inthisway mayfailunexpectedly.
Do not use high-pressure cleaningequipment withround-spraynozzlestocleanyourvehicle.
Damaged tires or suspension compo‐nents must bereplaced immediately.
Toavoid damageto yourvehicle, observethefol‐lowing when using a powerwasher:
Rkeepthe SmartKeyat least10ft(3 m)awayfromthevehicle. Otherwisethe trunk lidcould open unintentionally.
Rmaintain a distance of at least11.8 in(30 cm)tothevehicle.
Rvehicles with decorativefoil:parts ofyourvehicle are covered with a decorativefoil.Maintain a distance of at least27.6 in(70 cm) betweenthefoil-covered parts ofthevehicle andthe nozzle ofthe powerwasher.Movethe powerwasher nozzle around whilstcleaning. Thewatertemperature ofthepowerwasher must notexceed140 °F(60 °C).
Robservethe information onthe correct dis‐tance inthe equipment manufacturer's oper‐ating instructions.
Rdo not pointthe nozzle ofthe powerwasherdirectly at sensitive parts such as tires, slits,electrical components, batteries, light bulbsandventilation slots.
Washingthevehiclebyhand
Observethe legalrequirements, e.g. in a numberof countries,washingbyhand is only permittedin specially designatedwash bays.
Use a mild cleaning agent, e.g. car shampoo.
Washthevehicle with lukewarmwater usinga soft car sponge. When doing so, do notexposethevehicletodirect sunlight.
Carefully hosethevehicle off withwater anddry using achamois.Takecare nottopointthewater jet directlytowardsthe air inletgrille.
356Maintenance and care

If a pressure losswarning message appears inthe multifunction display,proceed asfollows:
RCheckthe tirefor damage.
RIf driving on, observethefollowing notes.
Driving distance possible in emergencymode after the pressure losswarning:
Load condition Driving distance pos‐sible in emergencymode
Partially laden50 miles (80 km)
Fully laden19miles (30 km)
The driving distance possible in emergencymode mayvarydepending onthe drivingstyle.Observethe maximum permissible speed of50mph (80 km/h).
If a tire has goneflat and cannot bereplacedwith an MOExtended tire,you can use astand‐ard tire as atemporary measure.
TIREFIT kitstoragelocation
The TIREFIT kit is located underthe trunkfloor.
1Tiresealant bottle
2Tireinflation compressor
Usingthe TIREFIT kit
Requirements
Requiredtools:
RTiresealant bottle
RTIREFITsticker
RTireinflation compressor
RGloves (depending onthevehicle equipment)
TIREFIT kitstorage location: (→page 366)
You can use TIREFIT tire sealanttoseal perfora‐tion damageof upto0.16in (4 mm), particularlythose inthe tire contact surface.You can useTIREFIT in outsidetemperatures downto-4 °F(-20 °C).
\nWARNINGRisk of accident when usingtire sealant.
Inthefollowing situations,the tire sealant isunabletoprovide sufficient breakdown assis‐tance, as it is unabletosealthe tire properly:
RThere are cuts or punctures inthe tirelargerthanthose previously mentioned.
RThe wheelrim is damaged.
RYou havedriven at averylow tire pres‐sure or on aflat tire.
Do not continue driving.
Consult aqualified specialistworkshop.
366Breakdown assistance

vehicle/trailer combination maystarttoskid.Consequently,you could lose control ofyourvehicle.
When transporting, ensurethat:RThevehicle has been loaded ontothe transporter correctly
RThevehicle is secured at allfourwheels with suitabletensioningstraps
RThe maximum permissible speed of35mph (60 km/h) is notexceededwhen transporting
NOTEDamagetothevehicle from secur‐ing it incorrectly
After loading,thevehicle must besecured at allfour wheels. Otherwise,thevehicle could be damaged.
A minimum distance of 8 in (20 cm) upand 4 in (10 cm) down mustbekepttothe transport platform.
Securethevehicle on allfour wheels afterloading.
4MATICvehicles/vehicles with automatictransmission
Make surethatthe front andrear axles cometorestonthe same transportationvehicle.
NOTEDamagetothe drivetrain duetoincorrect positioning
Do not positionthevehicle abovetheconnection point ofthe transportvehi‐cle.
Towingeye
Towingeye1is attachedtothe edge ofthetrunk underthe trunkfloor.
Breakdown assistance37 9

Blown fuses must bereplaced with fuses ofthesamerating, whichyou canrecognizebythecolor and fuserating. The fuseratings and fur‐ther informationtobe observed are listed inthefuse assignment diagram.
Fuse assignment diagram:onthe fuse box inthe trunk (→page 383).
NOTEDamageor malfunctions causedbymoisture
Moisture may cause damagetothe electricalsystem or cause ittomalfunction.
Whenthe fuse box is open, make surethat no moisture can enterthe fusebox.
When closingthe fuse box, make surethatthe seal ofthe lid is positioned cor‐rectly onthe fuse box.
Ifthe newly inserted fuse also blows, havethecause traced andrectified at aqualified special‐istworkshop.
Ensurethefollowing beforereplacing a fuse:
RThevehicle is secured againstrollingaway
RAll electrical consumers are switched off
RThe ignition is switched off
The electrical fuses are located invarious fuseboxes:
RFuse box inthe engine compartment onthedriver's side (→page 381)
RFuse box onthe driver's side ofthe cockpit(→page 382)
RFuse box inthe front passengerfootwell(→page 382)
RFuse box inthe trunk ontheright-hand sideofthevehicle when viewed inthe direction oftravel (→page 383)
Opening and closingthe fuse box intheengine compartment
Requirements:RA dry clothand a screwdriver areavailable.
Observethe notes on electrical fuses(→page 380).
Opening
\nWARNINGRisk of injuryfrom usingthewindshield wipers whilethe engine hoodis open
Whenthe engine hood is open andthe wind‐shield wipers are set in motion,you can betrappedbythe wiper linkage.
Always switch offthe windshield wipersand ignition before openingthe enginehood.
Breakdown assistance381

Open cover1inthe direction ofthe arrowandremoveit.
Fuse box inthe trunk
Observethe notes on electrical fuses(→page 380).
Fold up cover1inthe direction ofthearrow.
The fuse assignment diagram is in arecess onthe side ofthe fuse box.
Breakdown assistance383

Aluminum hub cap
Toremove:position socket2on hub cap1.
The socket can befound inthe tire-changetool kit.
Position wheel wrench3on socket2.
Using wheel wrench3, turn hub cap1counter-clockwise andremoveit.
Toinstall:position hub cap1and turn untilit is completelyflush withthe wheel.
Position socket2on hub cap1.
Attachwheel wrench3tosocket2andtightenthe hub cap clockwise.Specified tighteningtorque:18lb-ft(25 Nm).
Raisingthevehicle whenchanging a wheel
Requirements:RThere are no persons inthevehicle.
RThevehicle has been preparedfor a wheelchange (→page 409).
RThe hub caps havebeenremoved(→page 409).
Important notes on usingthe jack:
RUse onlythevehicle-specific jackthat hasbeentested and approvedbyMercedes-Benztoraisethevehicle.
RThe jack is only designedforraising andholdingthevehiclefor a short time while awheel is beingchanged and notfor mainte‐nanceworkunderthevehicle.
RThe jack must be placed on afirm,flat andnon-slip surface. If necessary,use a large,flat, load-bearing, non-slip underlay.
RThefootofthe jack must be positionedverti‐cally underthe jack support point.
Rules of conduct whenthevehicle israised:
RNever placeyour hands orfeetunderthevehicle.
RNever lie underthevehicle.
RDo notstartthe engine and do notreleasethe electric parking brake.
RDo not open or close any doors orthe trunklid.
41 0Wheels and tires