2019 MAZDA MODEL CX-9 fuses

Hang-up button
Ends the call or refuses an incoming call. In addition, it ends the voice recognition
operation.
Commander switch
The commander switch is used for volume adjustment and display operation. Tilt or turn the
commander knob to move the cursor. Press the commander knob to select the icon.
Volume adjustment
The volume dial of the commander switch is used to adjust the v olume. Turn the dial to the
right to increase volume, t o the left to decrease it.
The volume can also be adjusted using the volume button on the steering wheel.
NOTE
Press the volume dial to switch the audio MUTE on and off.
If the volume is lower compared to other audio modes, increase the volume from the
device side.

Conversation volume and the volume of the voice guidance and ringtone can each be set in
advance.
1. Select the
icon on the home screen to display the Communication screen.
2. Select
.
3. Adjust the
and the using the slider.
Interior Features
Audio Set
5-51
CX-9_8HB2-EA-18G_Edition1 2018-5-11 13:09:27

6Maintenance and Care
How to keep your Mazda in top condition.
Essential Information........................6-2 Introduction.................................. 6-2
Scheduled Maintenance.................... 6-4 Scheduled Maintenance (U.S.A.,
Canada, and Puerto Rico)............. 6-4
Scheduled Maintenance
(Mexico)..................................... 6-10
Maintenance Monitor................. 6-16
Owner Maintenance........................ 6-18 Owner Maintenance
Precautions................................. 6-18
Hood........................................... 6-20
Engine Compartment
Overview.................................... 6-22
Engine Oil...................................6-23
Engine Coolant........................... 6-25
Brake Fluid............ ..................... 6-27
Washer Fluid............................... 6-27
Body Lubrication...... .................. 6-28
Wiper Blades.............................. 6-29
Battery........................................ 6-34
Key Battery Replacement........... 6-36
Tires............................................ 6-38
Light Bulbs................................. 6-42
Fuses........................................... 6-50
Appearance Care............................. 6-57
Exterior Care.............................. 6-57
Interior Care................................6-63
6-1
CX-9_8HB2-EA-18G_Edition1 2018-5-11 13:09:27

4. Disconnect the bulb by pulling it out.
5. Install the new bulb in the reverseorder of the removal procedure.
Fuses
Your vehicle's electrical system is
protected by fuses.

If any lights, accessories, or controls do
not work, inspect th e appropriate circuit
protector. If a fuse h as blown, the inside
element will be melted.

If the same fuse blows again, avoid using
that system and consult an Authorized
Mazda Dealer as soon as possible.
▼ Fuse Replacement
Replacing the fuses on
the vehicle's left
side
If the electrical system does not work, first
inspect the fuses on the vehicle's left side.

1. Make sure the ignition is switched off,
and other switches are off.
2. Open the fuse panel cover.
Maintenance and Care
Owner Maintenance
6-50
CX-9_8HB2-EA-18G_Edition1 2018-5-11 13:09:27

3. Pull the fuse straight out with the fusepuller provided on the fuse block
located in the eng ine compartment.
4. Inspect the fuse and replace it if it is
blown.
Normal Blown
5. Insert a new fu
se of the same
amperage rating, and make sure it fits
tightly. If it does not fit tightly, have an
expert install it. We recommend an
Authorized Mazda Dealer.
If you have no spare fuses, borrow one
of the same rating from a circuit not
essential to vehicle operation, such as
the AUDIO or OUTLET circuit.
CAUTION
Always replace a fuse with a genuine
Mazda fuse or equivalent of the same
rating. Otherwise you may damage the
electric system.
6. Reinstall the cover and make sure that it is securely installed.
Replacing the fu ses under the hood
If the headlights or other electrical
components do not work and the fuses in
the cabin are normal, inspect the fuse
block under the hood.
If a fuse is blown, it must be replaced.
Follow these steps:

1. Make sure the ignition is switched off, and other switches are off.
2. Remove the fuse block cover.
3. If any fuse but the MAIN fuse is blown, replace it with a new one of the
same amperage rating .
Normal
Blown
Maintenance and Care
Owner Maintenance
6-51
CX-9_8HB2-EA-18G_Edition1 2018-5-11 13:09:27

Lug nut tightening torque
When installing a tire, tighten the lug nut to the following to rque.
108―147 N·m (12―14 kgf·m, 80―108 ft·lbf)
▼ Fuses
Refer to Fuses on page 6-50.
Specifications
Specifications
9-9
CX-9_8HB2-EA-18G_Edition1
2018-5-11 13:09:27

Index
EngineCoolant.........................................6-25
Engine compartment overview.... 6-22
Exhaust gas.................................. 3-28
Hood release............................ .... 6-20
Oil................................................ 6-23
Starting...........................................4-5
Essential Information.......................... 6-2
Event Data Recorder......................... 8-21
Exhaust Gas...................................... 3-28
Exterior Care..................................... 6-57 Aluminum wheel maintenance.... 6-61
Bright-metal maint enance........... 6-60
Maintaining the finish................. 6-58
Plastic part maintenance.............. 6-62
F
Flasher Hazard warning........................... 4-80
Headlights.................................... 4-68
Flat Tire............................................... 7-3 Mounting the spare tire............... 7-14
Removing a flat tire...................... 7-9
Floor Mat.......................................... 3-49
Fluid Brake............................................6-27
Washer......................................... 6-27
Fluids Classification................................. 9-4
Fog Lights......................................... 4-73
Foot Brake.........................................4-89
Forward Sensing Camera (FSC)..... 4-192
Front Seat............................................ 2-5
Fuel Filler lid and cap......................... 3-30
Requirements............................... 3-27
Tank capacity.................................9-4
Fuel Consumption Display............... 4-99
Fuel Economy Monitor..................... 4-99 Ending screen display............... 4-100
Fuel consumption display............4-99
Fuses.................................................. 6-50 Panel description......................... 6-53
Replacement................................ 6-50
G
Gauges............................................... 4-11
Glove Compartment........................ 5-101
H
Hazardous Driving............................ 3-48
Hazard Warning Flasher....................4-80
HeadlightsComing home light......................4-71
Control......................................... 4-68
Headlight flashing....................... 4-71
High-low beam............................ 4-71
Leaving home light..................... 4-71
Leveling....................................... 4-72
Head Restraint................................... 2-21
High Beam Control System
(HBC).............................................. 4-111 High Beam Control System (HBC)
indicator light (green)................ 4-112
Hill Launch Assist (HL A)................ 4-93
HomeLink Wireless Control System
(Type A)............................................ 4-81
HomeLink Wireless Control System
(Type B)............................................ 4-84
Hood Release............. ....................... 6-20
Horn...................................................4-80
I
If a Warning Light Turns On or
Flashes............................................... 7-28
If the Active Driving Display Does Not
Operate.............................................. 7-52
Ignition
Switch............................................ 4-4
10-4
CX-9_8HB2-EA-18G_Edition1 2018-5-11 13:09:27