(Continued)
quick coupling from the negative
pole (–) of the battery.
If the battery needs to be removed
from
its compartment, you must first
detach the terminal clamp from
negative pole (–) and then the other
terminal clamp from positive pole (+),
after removing the protective cover.
Battery poles are marked positive (+)
and negative (–) and are identified on
the battery case.
Remove the metal clamp indicated in
the picture and then remove the
battery from the trunk compartment. To Reconnect the Battery NOTE:
When the battery cables have been
disconnected and the trunk lid has
been locked, it is necessary to pull the
emergency release cable in order to
re-open it. To access the trunk and
operate the emergency release (see
“Open and Close the Trunk Lid”
chapter in section “Before Starting”).
CAUTION!
• It is essential when replacing the
cables on the battery that the
positive cable is precisely attached to
the positive pole (+) and the
negative cable is attached to the
negative pole (–).
• Cable clamps should be tight on the
terminal poles and free of corrosion.
After the battery has been
disconnected
and re-connected and
before starting the engine it is
necessary to proceed as follows:
• Unlock and lock the doors using the
radio control buttons on the key.
• Unlock the trunk lid with the radio
control button on the key and then
lock it manually. • Check the seats are working
correctly: in the event of
malfunction, carry out the
initialization operations described in
the chapter “Front Seats” of the
section “Understanding the Vehicle”.
• Initialize the climate control system
by activating the compressor as
described in chapter "Air
Conditioning Controls" of the section
“Dashboard Instruments and
Controls”.
• Turn on the MTC+ and set the date
and time (see “MTC+ Setting” in
section “Dashboard Instruments and
Controls”).
• Lift, release and lift again the lever
located next the shift lever to
initialize the electric parking brakes.
In this way the
warning light
on the instrument cluster will turn
off.
CAUTION!
• Every time the battery is
reconnected, wait at least 30 seconds
with the key in the ignition switch
turned to MAR (ON) position before
starting the engine, in order to allow
the electronic system that manages
the motor-driven throttles to run aMaintenance and Care
7
238
Passenger Compartment Fuses
Pos. Amp. –
Color System / Component
F12 15 A –
Blue Right-hand low
beam
F13 15 A –
Blue Left-hand low beam
F31 7.5 A –
Brown A/C unit, NBC (Body
Computer Node),
high beam relay
F32 10 A –
Red Domelights, step
lights, CAV, driver-
and passenger-side
footwell lights,
outside mirror lights
F33 30 A –
Green Driver’s seat
(movement)
F34 30 A –
Green Passenger’s seat
(movement)
F35 7.5 A –
Brown ACC, FN and LF relay
coil
F36 10 A –
Red NQS
F37 10 A –
Red NQS (Instrument
Cluster Node), CPP,
CPD
F38 15 A –
Blue Rear lid lock Pos. Amp. –
Color System / Component
F39 15 A –
Blue NIM (Inside Roof
Node), NCL (Air
conditioning and
heating system
node), OBD socket,
CSA (Alarm system
siren ECU), CAV
(Motion sensing
alarm ECU), radio,
NAVTRAK
F40 30 A –
Green Heated rear window
F41 - Not used
F42 7.5 A –
Brown Power supply for
control panel on roof
F43 30 A –
Green Windshield
wiper/washer
(Connected Devices
Relay INT/A)
F44 20 A –
Yellow Front and rear power
outlets (INT/A device
relay) front seat
heating (passenger
side)
F45 - Not used
F46 20 A –
Yellow NPG/NPP locks Pos. Amp. –
Color System / Component
F47 30 A –
Green NPG (Driver’s door
node)
F48 30 A –
Green NPP (Passenger’s
door node)
F49 7.5 A –
Brown NVO (Steering wheel
node), CSG (Power
steering ECU), CSP
(Twilight/rain sensor
ECU), NIM (Inside
Roof Node), NCL,
Radio, CEM, CRP,
domelight molding,
windshield wiper
controls, NAVTRAK
F50 7.5 A –
Brown Air bag system
F51 7.5 A –
Brown NCA (Automatic
Gearbox Node)
F52 15 A –
Blue Front seat heating
(driver side) (INT/A
device relay)
F53 10 A –
Red Rear fog lightsMaintenance and Care
7
245
