2019 LEXUS LX570 warning

LX570_OM_OM60R07U_(U) 5778-1. Specifications
8
Vehicle specifications This information has been prepared in acco rdance with regulations issued by the
National Highway Traffic Safety Administra tion of the U.S. Department of Trans-
portation.
It provides the purchasers and/or prospe ctive purchasers of Lexus vehicles with
information on uniform tire quality grading.Your Lexus dealer will help answer any ques tions you may have as you read this infor-
mation.■
DOT quality grades
All passenger vehicle tires must conform to Federal Safety Requirements in
addition to these grades. Quality grad es can be found where applicable on
the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200 Traction AA Temperature A■
Treadwear
The treadwear grade is a comparative rati ng based on the wear rate of the tire
when tested under controlled conditio ns on a specified government test
course. For example, a tire graded 150 would wear one and a half (1 - 1/2) times as well on
the government course as a tire graded 100.
The relative performance of tires depends upon the actua l conditions of their use.
Performance may differ significantly from the norm due to variations in driving
habits, service practices and difference s in road characteristics and climate.■
Traction AA, A, B, C
The traction grades, from highest to lo west, are AA, A, B and C, and they rep-
resent the tire’s ability to stop on wet pavement as measured under controlled
conditions on specified government test surfaces of asphalt and concrete. A tire marked C may have poor traction performance.
Warning: The traction grade assigned to this tire is based on braking (straight
ahead) traction tests and does not include cornering (turning) traction.Uniform Tire Quality Grading

578
LX570_OM_OM60R07U_(U) 8-1. Specifications■
Temperature A, B, C
The temperature grades are A (the highes t), B, and C, representing the tire’s
resistance to the generation of heat and its ability to dissipate heat when
tested under controlled conditions on a specified indoor laboratory test
wheel. Sustained high temperature can cause the ma terial of the tire to degenerate and
reduce tire life, and excessive temperature can lead to sudden tire failure.
Grade C corresponds to a level of perfor mance which all passenger car tires must
meet under the Federa l Motor Vehicle Safety Standard No. 109.
Grades B and A represent higher levels of performance on the laboratory test
wheel than the minimum required by law.
Warning: The temperature grades of a tire assume that it is properly inflated and
not overloaded.
Excessive speed, underi nflation, or excessive loading, either separately or in com-
bination, can cause heat buildup and possible tire failure.

LX570_OM_OM60R07U_(U) 5878-2. Customization
8
Vehicle specifications ■
Smart access system with push-button start (  P. 138) and wireless remote
control (  P. 116)
■
Door lock (  P. 121)Function Default setting Customized
setting
Operation signal (Emer-
gency flashers) On Off O — O
Adjust the volume of confir-
mation buzzer sounds
when the vehicle is locked
or unlocked 5 Off
O — O
1 to 7
Open door warning func-
tion (when locking the vehi-
cle) On Off — — O
Time elapsed before auto-
matic door lock function is
activated if door is not
opened after being
unlocked 60 seconds Off
O — O30 seconds
120 seconds 1 2 3
Function Default setting Customized
setting
Unlocking using a mechan-
ical key Driver’s door
unlocked in one
step, all doors
unlocked in two
steps All doors unlocked
in one step — — O
Automatic door lock Shifting the shift
lever to position
other than P Off
O — OVehicle speed is
approximately
12 mph (20 km/h)
or higher
Automatic door unlock Shifting the shift
lever to P Off
O — O
Driver’s door is
opened 1 2 3

LX570_OM_OM60R07U_(U) 5898-2. Customization
8
Vehicle specifications ■
Moon roof (  P. 174)
* : The settings of the power windows are chan ged in conjunction with the settings of the
moon roof.■
Automatic light control system (  P. 227)
* : Vehicles sold outside Canada Function Default setting Customized
setting
Mechanical key linked
operation (open)
* Off On — — O
Mechanical key linked
operation (close)
* Off On — — O
Linked operation of com-
ponents when mechanical
key is used Slide only Tilt only — — O
Wireless remote control
linked operation (open)
* Off On — — O
Linked operation of com-
ponents when wireless
remote control is used Slide only Tilt only — — O
Moon roof open warning
buzzer On Off — — O 1 2 3
Function Default setting Customized
setting
Light sensor sensitivity Standard -2 to 2 O — O
Daytime running light sys-
tem On Off
* O — O
Time elapsed before head-
lights automatically turn off
after doors are closed 30 seconds Off
O — O60 seconds
90 seconds
Welcome lighting illumina-
tion control On Off — — O 1 2 3

596
LX570_OM_OM60R07U_(U) 8-2. Customization■
LDA (Lane Departure Alert)
* (  P. 267)
* : If equipped ■
BSM (Blind Spot Monitor) (  P. 369)Function Default
setting Customized
setting
Alert method
(Steering
vibration) (Buzzer) — O —
Alert sensitivity Standard High — O —
Vehicle sway warning On Off — O —
Vehicle sway warning sensi-
tivity Standard Low
— O —
High 1 2 3
Function Default setting Customized set-
ting
BSM (Blind Spot Monitor) On Off — O —
RCTA (Rear Cross Traffic
Alert function) On Off — O —
Outside rear view mirror indi-
cator brightness Bright Dim O — O
Alert timing for presence of
approaching vehicle (BSM
function only) Intermediate Early
O — OLate
Only when in
blind spot
RCTA buzzer volume Level 2 Level 1
O — O
Level 3 1 2
3

LX570_OM_OM60R07U_(U) 5978-2. Customization
8
Vehicle specifications ■
HUD (Head-up Display)
* (  P. 105)
* : If equipped ■
Vehicle customization ●
When smart access system with push-button start is turned off, unlock door cannot be
selected. ●
When doors are not opened after unlocking and are then automatically re-locked, a
signal will be given if Operation signal (Emergency flashers) or Operation signal
(Buzzer) are set to on. ■
When setting using the multi-information display
When using the vehicle switches to set an item that can also be set using the touch
screen, the item displayed on the Remote Touch will not change immediately.
If the engine switch is first turned to off, the screen display will change once the engine
switch is turned to IGNITION ON mode again. ■
When customizing usin g the Remote Touch
Stop the vehicle in a safe place, apply the parking brake, and shift the shift lever to P. Also,
to prevent battery discharge, leave the engine running while customizing the features. Function Default
setting Customized
setting
Driving support display
(Navigation system
* ) On Off — O —
Driving support display
(Driving assist
* ) On Off — O —
Driving support display
(compass
* ) On Off — O —
Driving support display
(audio
* ) On Off — O —
WARNING ■
During customization
As the engine needs to be running during customization, ensure that the vehicle is
parked in a place with adequate ventilation. In a closed area such as a garage, exhaust
gases including harmful carbon monoxide (CO) may collect and enter the vehicle. This
may lead to death or a serious health hazard.
NOTICE ■
During customization
To prevent battery discharge, ensure that the engine is running while customizing fea-
tures. 1 2 3

598
LX570_OM_OM60R07U_(U) 8-3. Initialization
Items to initialize
* : If equippedThe following item must be initialized for normal system operation such cases
as the battery being reconnected, or maintenance being performed on the
vehicle: Item When to initialize Reference
Message indicating mainte-
nance is required (U.S.A. only) After the maintenance is per-
formed P. 467
Power back door • After reconnecting or changing
the battery with power back door
opened
• After changing a fuse with power
back door opened P. 128
Tire pressure warning system • When the set tire pressure has
been changed before towing.
• When rotating the tires in above
situation. P. 488
Multi-terrain Monitor After reconnecting or changing the
battery P. 367
Engine oil maintenance data
* After the maintenance is per-
formed P. 477

614 What to do if... (Troubleshooting)
LX570_OM_OM60R07U_(U) ●
It is locked automatically to prevent theft of the vehicle. (  P. 213)●
Is the window lock switch pressed?
The power window except for the one at the driver’s seat cannot be operated
if the window lock switch is pressed. (  P. 171)●
The auto power off function will be operated if the vehicle is left in ACCES-
SORY or IGNITION ON mode (the engine is not running) for a period of
time. (  P. 213)●
The seat belt reminder light is flashing
Are the driver and the front passe nger wearing the seat belts?
(  P. 525)●
The parking brake indicator is on
Is the parking brake released? (  P. 224)
Depending on the situation, other type s of warning buzzer may also sound.
(  P. 523, 531)
●
Did anyone inside the vehicle open a door during setting the alarm?
The sensor detects it and the alarm sounds. (  P. 82)
To stop the alarm, turn the engine switch to IGNITION ON mode or start the
engine. The steering wheel cannot be turned after the engine is stopped
The windows do not open or close by operating the power window
switches
The engine switch is turned off automatically
A warning buzzer sounds during driving
An alarm is activated and the horn sounds