2019 INFINITI QX80 steering

4
Instrument Panel
Multi-function touch-screen/RearView Monitor display/Around View® Monitor display
Infiniti multi-function controller
Audio system
Climate control panel
Shift lever
Lower center console switch panel
• 2nd row seat release buttons
• Climate-controlled seat switches (if so equipped)
• Front passenger air bag status light
Parking brake
Switch panel
• Power liftgate button
• Safety Shield OFF switch
• Blind Spot/RCTA OFF switch (if so equipped)
• Power Liftgate ON/OFF switch
• Steering wheel heater

12
Clock Set/Adjustment
SYSTEM OPERATING TIPS

• The interior of the vehicle should be as quiet as possible.

• Speak naturally. Speaking too fast, too slow, too soft or too loud makes voice recognition more difficult.

• Confirm that the correct voice commands are being used. Glance at the screen to see the currently
available commands.
USING THE VOICE RECOGNITION SYSTEM

• Press the button on the steering wheel, and a list of
commands will appear on the screen.

• After the tone sounds, speak the command.

• To skip the voice prompt and give the command immediately, press the
button on the steering wheel
to interrupt the system. Speak the next command after the
tone sounds.

• To cancel the command, press and hold the button on
the steering wheel.
Please see your INFINITI InTouch™ Owner’s Manual for important safety
information, system limitations, and additional operating and feature information.
Voice Recognition
To adjust the time and the appearance of the clock on the display:
Press the SETTING button on the control panel.
Locate and touch the “Clock” key to adjust “On-Screen Clock”, “Daylight
Savings Time”, “Clock Format (24h)” and “Time Zone” on the display.
The time can be adjusted through “Offset Adjustment”
by adjusting the
minutes and/or hours forward or backward. The current clock time can be
set up to a difference of 12 hours and 59 minutes.
ANALOG CLOCK
To set the clock forward, press the button
.
To set the clock backward, press the button
.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.

15
• To slide the seat forward or backward, push the switch forward
or backward.
• To recline the seatback, push the switch forward or backward.
SEAT LIFTER
• To adjust the angle of the front portion or height of the seat, push the front or rear end of the
switch up or down.
LUMBAR SUPPORT
• Push each side o f the adjusting switch to adjust the seat lumbar area
until the desired position is achieved.
SEAT/STEERING POSITIONING ON EXIT
• The shift le ver must be in P (PARK) position with the
ignition switch in the OFF position.
• The entry/exit function can be activated or canceled by pushing and holding the SET switch
, located on the
driver’s side door, for more than 10 seconds.
Please see your Owner’s Manual for important safety information, system limitations, and additional operating
and feature information.
Seat AdjustmentsHead Restraint Adjustment
To raise the head restraint: Pull the head restraint up.
To lower the head restraint: Push and hold the lock
knob
and push the head restraint down.
Make sure the head restraint is fully engaged in
position after any adjustment.
Please see your Owner’s Manual for important safety information,
system limitations, and additional operating and feature information.