3. Use the TORX® provided wrench to loosen
the clamp screw.4. Open the clamp approximately two inches
to minimize potential scratching of the roof
rails.5. Determine crossbar orientation by locating
the arrow that points to the front of the
vehicle.
LIC3892LIC3893LIC3894
Instruments and controls2-63
6. Align the pins of the passenger side clamp
with the holes in the roof rail.7. While holding the inner clamp, use the
TORX® provided wrench to tighten the
clamping screw.
NOTE:
Using the TORX® provided wrench, tighten
to 10 N•m (7.4 ft.-lbs.).8. Tighten both the driver and passenger side
shoulder screw.
NOTE:
Using the TORX® provided wrench, tighten
to 10 N•m (7.4 ft.-lbs.).
LIC3895LIC3896LIC3897
2-64Instruments and controls
WARNING
Always follow the instructions below. Fail-
ure to do so could result in damage to the
charging system and cause personal injury.1. If the booster battery is in another ve- hicle, position the 2 vehicles to bring their
batteries near each other.
Do not allow the two vehicles to touch.
2. Apply the parking brake. Engage the P (Park) position. Switch off all unneces-
sary electrical systems (lights, heater, air
conditioner, etc.). 3. Turn the ignition switch to the OFF po-
sition.
4. Ensure the vent caps are level and tight.
5. Connect the jumper cables in the se- quence illustrated (
A,B,C,D).
CAUTION
∙ Always connect positive () to positive() and negative () to body ground (for
example, strut mounting bolt, engine lift
bracket, etc.) — not to the battery. ∙ Make sure the jumper cables do not touch
moving parts in the engine compartment
and that the cable clamps do not contact
any other metal.
6. Start the engine of the booster vehicle and let it run for a few minutes.
7. Keep the engine speed of the booster vehicle at about 2,000 rpm and start the
engine of the vehicle being jump started.
CAUTION
Do not keep the starter motor engaged for
more than 10 seconds. If the engine does
not start right away, place the ignition
switch in the OFF position and wait 3 to
4 seconds before trying again.
8. After starting the engine, carefully dis- connect the negative cable and then the
positive cable.
LCE2223
6-6In case of emergency
